互溶劑 的英文怎麼說

中文拼音 [hùróngjì]
互溶劑 英文
mutual solvent
  • 互 : 代詞（相互;彼此） each other; mutual
  • 溶 : 動詞（溶化; 溶解） dissolve
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 溶劑 : dissolvant; solvent; resolvent; solventia; menstruum
  1. In the paper the solubilities of anthracene, phenanthrene and carbazole are studied in benzene, toluene, xylene, the heavy solvent oil, clohexane, dmf, pyridine, cyclohexanone and acetone, and qualitative analysis is done by three aspects in the process of the solute dissolved the solvent : ( l ) the molecular struture and the interspace struture ; ( 2 ) reciprocity force of the intermolecule ; ( 3 ) the cohesion energy

    本文考察了蒽、菲、咔唑在苯、甲苯、二甲苯、重溶劑油、環己烷、 dmf 、吡啶、環己酮和丙酮等有機溶劑中的溶解度。並從三個方面對溶劑溶解固體定性分析： （ 1 ）分子結構及空間結構， （ 2 ）分子之間相互作用力， （ 3 ）內聚能，得到的結果與實驗得到的數據基本一致。
  2. A review of the development of organic semiconductor composite photo - conductive materials and devices was followed by a proposal of the researching theme in this thesis. the effects of fabrication arts such as solvents, gradient, interfacial layer and configurations on the photoconductive properties of the single - layer chlorodiane blue azo / tiopc composite photoreceptors were systematically studied in chapter ii. the results showed that the solvent played a decisive role in the multiphase and multicomponent system composed of two photogeneration species ( chlorodiane blue azo and tiopc ), a transporting material ( hydrozone ) and polymer binder ; 1, 4 - dioxane, as an amphiphilic solvent can effectively disperse and stabilize such multiphase and multicomponent systems, the derived photoreceptors presented improved photoconductive properties superior to those of dual - layer counterparts and demonstrated the evident synergetic enhancement and complementary effects ( eg

    結果表明：在由兩種光生材料氯丹藍偶氮和酞菁氧鈦、傳輸材料萘苯腙以及聚合物介質組成的多相多組分復合體系中，分散溶劑是至關重要的因素，二氧六環作為典型的雙親性溶劑，有效地分散和穩定了該多相多組分復合體系，得到的復合單層光導體的光敏性在整體上優于雙層光導體，復合材料在可見光和近紅外光區分別表現出的偶氮和酞菁氧鈦的光敏性（如azo / tiopc = 8 / 2 ， cgm / ctm / pc = 1 / 120 / 120時，具有明顯的互補效應；在近紅外光區明顯高於酞菁氧鈦與偶氮光敏性的線性加和，表現出協同增強正效應。
  3. When 2 - propanol ( ipa ) is used as a coagulation reagent, it has better dissolving ability with solvent than 1 - butanol and 1 - pentanol

    以異丙醇作為凝固劑時，它與溶劑的互溶性要優于正丁醇和正戊醇。
  4. N - methyl pyrrolidone is colorless clear liquid, has tiny ammoniacal odour ; is a strong polar organic solvent, can dissolve each other with water and general organic solvent by any proportion

    -吡咯烷酮為無色或微黃色澄凈液體，有微氨味是一種強極性有機溶劑，可與水和一般有機溶劑以任意比例互溶。
  5. Aim : to analyze the mechanism, thermadynamic theoretical basis, dynamic mechanism and influencing factors of thermally induced phase separation ( tips ) in order to completely grasp the factors affecting the size, distribution and form of pores, so that the adjusted range of pore can be widened and the preparation of porous membrane can be repeated and controlled. methods : considering from the structural characteristics of tissue engineered materials, the methods of preparing porous membrane using tips technique, the hermadynamic theoretical basis, dynamic mechanism and influencing factors were analyzed, the problems and investigative directions in the future were also analyzed. tips technique is a process of phase separation of polymer homogenous solution under quenching, and it is suitable for diameter and structural form of the micropore materials prepared using tips are closely correlated with the kind and dispensing proportion of polymer attrnuant, polymer concentration and polymer molecular mass, etc. conducted, including determination of polymer - solvent system phase diagram, study of form and appearance of porous membrane of different thickness, study of form and appearance of porous membrane prepared with systems of different x, which is the parameter of polymer - solvent interaction

    目的:分析熱致相分離成膜過程的機理、熱力學理論基礎、動力學機制以及影響因素，以便充分掌握影響孔度大小、分佈、形態的因素，使孔度調控范圍得以拓寬，使多孔膜的制備能重復可控.方法:從組織工程材料結構特點出發，分析熱致相分離聚合物多孔膜的制備方法及該法成膜的熱力學理論基礎、動力學機制以及影響因素.並分析實驗中存在的問題及今後的研究方向.結果:以熱致相分離法可制備聚合物多孔膜.熱致相分離法制備多孔膜是高聚物均相溶液在淬冷條件下發生相分離的過程，它適用於上臨界共溶溫度型聚合物一稀釋劑二元體系.熱致相分離法成膜的過程，可以認為是旋節線機理佔主導地位.熱致相分離法制備的微孔材料，其孔隙率、孔徑大小、結構形態與聚合物稀釋劑的種類、組成配比、聚合物濃度、聚合物分子量等因素密切相關.結論:可採用熱致相分離技術制備多孔膜，通過改變不同的成膜條件可獲得一系列不同孔徑尺寸和孔徑分佈的多孔膜材料.對熱致相分離成膜過程中聚合物-溶劑體系的相圖測定，不同厚度的多孔膜形貌研究，不同x （聚合物-溶劑相互作用參數）體系所制備的多孔膜形貌等需深人研究
  6. At the end of the thesis, we incorporate the influences of all the four parameters - half - length l, radius r, viscosity of the fluid v and the density of the fiber / - into one compound parameter a

    在論文最後，經過綜合分析各參數的影響，得到了一個能概括半長度l 、半徑r 、溶劑流體粘度v和纖維比重這四個參數對纖維直接相互作用過程影響的組合量| a | 。
  7. At the same time, it was indicated that the improved separating properties of membranes that had been marinated in methanol was pertinent to the degree of crystallization of polymer chains in membrane. also the effect of temperature and solvent mixtures on the performance of ca - eva composite membrane was related with reciprocity of polymer chains in membrane

    同時，指出ca膜溶劑浸泡后處理效應與膜內大分子鏈的結晶程度相關，此外，還從膜內大分子鏈之間的相互作用解釋了ca eva復合膜中的溶劑效應和溫度效應。
  8. In the nanocomposites mentioned above, part of pmma ca n ' t be dissolved by acetone, which is fine solvent of pmma. this means that there are strong interactions between pmma and mmt ( ommt )

    上述納米復合材料中，由於pmma與mmt （ ommt ）存在較強的相互作用，部分大分子不能被pmma良溶劑?丙酮溶解。
  9. The drug content of these nanoparticles is controlled by reducing the diffusion of the drug from the organic to the aqueous phase during the solvent evaporation stage of the preparation and by increasing the drug ? polymer interactions

    通過減少制備過程中溶劑揮發時藥物從有機相向水相的擴散及通過增加藥物-聚合物間相互作用來控制納米粒的載藥量。
  10. The long range interaction simulated by polarizable continuum model, the hydrogen bonding interaction, and the whole interaction between the solute and the medium were separately investigated

    分別研究了由極化連續模型模擬的溶劑和溶質分子的長程相互作用，溶劑和溶質分子的氫鍵作用，以及溶劑和溶質分子的整體作用對分子結構和性質的影響。
  11. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - tests - resistance to solvents and contaminating fluids

    光纖互聯裝置和無源部件.基本試驗和測量程序.第2部分第34節:耐溶劑和污染液體試驗
  12. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - part 2 - 34 : tests - resistance to solvents and contaminating fluids

    光纖互聯裝置和無源部件.基本試驗和測量步驟.第2 - 34部分:耐溶劑和污染液體試驗
  13. The result of delamination experiment shows that the mutual solubility of alcohol and gasoline is influenced by blend ratio, add - on quantity of booster solvent, temperature and water content

    分層實驗結果表明，醇與汽油的互溶性受醇與汽油的混合比例、助溶劑的加入量、使用溫度及含水量等因素影響。
  14. The results show that nano - particles affect the solution viscosity and crystalline properties of uhmwpe. owing to the strong interaction between nano - particles and pe molecules, the viscosity and e _ ( ) of uhmwpe solution increase with the increasing of nano - particles content

    實驗表明，納米粒子的加入對溶液粘度和uhmwpe的結晶性能均有影響，由於納米粒子和pe大分子及溶劑間有強烈的相互作用，使溶液粘度及粘流活化能均隨納米粒子的加入量的增加而增加。
  15. Polymer - solvent interaction

    溶劑相互作用
  16. Fibres optic interconnecting devices and passive components. basic test and measurements procedures. part 2 - 34 : tests. resistance to solvents and contaminating fluids

    光纖互連裝置和無源元件.基本試驗和測量程序.第2 - 34部分:試驗.耐溶劑和污染流體
  17. It is the especial congregate structure of polymer matrix that is necessary for the forming of three - dimensional interpenetrate network between the polymer and copper. the mma unites lead to the advantage of improving fiexibity of the film, destroying the formal arrangement of macromolecule chain in polymer and decreasing the degree of crystallization. the ita unites help the solvolyzed copper ion transfer in the film and benefite the forming and establishment of the networks of polymer matrix

    聚合物基體特殊的聚集態結構是互穿立體網路形成的必要條件，皿m的加入有利於破壞丙烯睹大分子鏈的規整性，使結晶度降低，提高聚合物的柔韌性，含親水基團的單體（ ita 、 as ）存在有利於降低離子遷移的界面能，提供溶劑化銅離子遷移的途徑以及聚合物基體網路結構的形成和穩定。
  18. The study on solvation effect is the focus of the international scientific research fields. the electrostatic interaction is the most important part hi the solvation effect, especially when the solute is charged or highly polarized

    而靜電相互作用是溶劑北京工業大學工學碩士學位論文一化效應中最主要的貢獻，尤其當溶質分子帶電荷或高度極化時更是如此。
  19. It is soluble in ethanol, toluene etc. and is mutually soluble with water

    本品溶於乙醇、甲苯等有機溶劑，也可與水互溶。
  20. The interaction between template and functional monomer was proved by uv spectrophotometry and based on the results, appropriate reaction solvent was selected

    紫外分光光度法證明了模板分子與功能單體之間存在相互作用，並據此選擇了聚合反應時合適的溶劑。
分享友人
分享到 Line

分享到臉書