井眼 的英文怎麼說

中文拼音 [jǐngyǎn]
井眼 英文
[石油工業] borehole; well
  • : Ⅰ名詞1 (從地面往下鑿成的能取水的深洞) well 2 (形狀像井的東西) sth in the shape of a well 3 (...
  • : Ⅰ名詞1 (眼睛) eye 2 (小洞; 窟窿) small hole; aperture 3 (事物的關鍵所在) key point 4 [圍棋]...
  1. 21 the annular volume is 115 cubic meters

    井眼的環空體積為115方。
  2. The basic principle and method of 3d stochastic modeling of sedimentary microfacies are discussed according to geological and acoustic impedance data of well - logging constrained seismic inversion, and a case study according to stochastic modeling of fluvial facies reservoir of the minghuazhen formation of neocene in a certain block of bohai bay basin is used to show the general process of this research

    摘要探討了綜合應用地質及測約束地震反演信息進行三維沈積微相隨機建模的基本原理、思路與方法, ?以渤海灣盆地某區塊新近系明化鎮組河流相儲層?例,說明這一研究過程的基本步驟,包括井眼沉積微相解釋、測約束地震反演、波阻抗與地質相的概率關系分析、隨機模擬方法選擇、地質統計特徵分析、三維隨機建模、隨機模擬預測的多解性評價。
  3. Application of flac in borehole shrinkage in formation of plaster stone and salt stone

    鹽膏巖地層的井眼縮徑變形分析
  4. Different drilling fluid systems have been used in the horizontal well drilling in north tarim area, more specifically, polymer drilling fluid is used in the top hole of large size, and polysulfide drilling fluid for the lower interval ; for the building section and horizontal interval, polysulfide drilling fluid mixed with oil is used

    塔北地區水平上部大井眼採用聚合物鉆液體系、下部段採用聚磺鉆液體系、造斜段及水平段採用聚磺混油鉆液體系。
  5. During field application, the adjustment while drilling technique of horizontal wells for ultra - thin oil layers has been improved to accurately control geosteering, optimize well course and decrease the ineffective section to the limit

    在實施過程中,完善了適應超薄油層特點的水平隨鉆調整技術,實現了準確把握地質導向、優化井眼軌跡,最大限度地降低了無效段。
  6. In order to geosteering, log - geology model of target formation should be built according to logging data and the interpreting result of wells nearby. geosteering parameters model is created to build simulative curves. compared these curves with logging curves, the position and drilling direction of the bit can be found combined with the concrete geological situation

    要實現地質導向,首先要根據鄰的測資料及其解釋結果建立目標層測地質模式,然後通過建立地質導向參數的預測模型構造相應的模擬曲線,將模擬曲線與實測曲線進行對比,結合具體地質情況,確定鉆頭在目標層中的位置及其鉆進方向,及時調整井眼軌跡,使其始終保持在目標層中物性最好的部位。
  7. This study made a conclusion ? amely in order to realize following the geological target while drilling, on the basis of making a better geological and drilling design for horizontal well, we must make full use of mwd, lwd and integrate logging to carry out lithfacy identifying in real time, the lwd interpretation and formation evaluation, to set up geological model of target formation, to select geosteering marked formation and compare simulative curves with lwd curves f to fix on the drilling direction of bit upper and declination, the position in target oil - gas layer, to revise borehole track in real time, to make it extend in reservoir better interval as possible

    研究認為,在做好水平地質設計和鉆設計的基礎上,要實現隨鉆跟蹤地質目標鉆,必須充分利用隨鉆測量、隨鉆測和錄等資料,從實時巖性識別、隨鉆測解釋和地層評價、目標層地質模型建立、導向標志層的選取及模擬曲線對比等方面入手,確定鉆頭上下傾鉆進方向及在目標層中的位置,以實時調整井眼軌跡,使其盡可能在儲層物性較好的部位延伸。
  8. Model lb fishing cup is a practical and effective tool. during drilling operation, it can be used to recover the heavier drilling cuttings or metal chips which are difficult to be lifted out of the borehole by normal drillig fluid circulation

    它是用來撈取鉆過程中正常的泥漿循環無法帶出井眼的較重鉆屑或金屬碎屑的一種實用有效的隨鉆工具。
  9. Abstract : tight trips often occur for hole undergauge during drilling in east sichuan oilfield. the paper analysis the causes of hole undergauge, proposes preventive and treatment measures which are to optimize design from geologic structure features, to use suitable fluid column pressure, to select different drilling fluid types, to adopt advanced drilling technology and perfect field technical management. therefore, good economic benefit will be obtained

    文摘:川東構造在鉆探作業中因井眼縮徑造成起下鉆的阻卡時有發生,文中對造成井眼縮小的原因進行分析並劃分為五類因素,提出應在地質構造特徵方面優化設計,採用合適的液柱壓力,選擇不同的鉆液類型,使用先進的鉆工藝和完善現場技術管理等措施進行預防和處理,將取得重大的經濟效益。
  10. Mix gel fluid for drilling conductor hole

    為鉆導管井眼配製高粘度泥漿
  11. 12 when 20 ” casing depth is attained, displace hole volume with high viscosity mud

    鉆達20英寸套管深度時,用高粘度泥漿替滿井眼
  12. 11drill the 36 ” hole with seawater, pumping 4 " 6 cubic meters high viscosity slugs for one string

    在36英寸井眼用海水鉆進,每鉆一個立拄泵入4 6方的稠泥漿進行清掃。
  13. Based on the mass and energy conservation equations of the borehole and formation - borehole system, the decisive functions between production rate and flow flux as well as temperature of the fluids in the borehole as all depth of the well have been deduced in this study

    本文在筒及筒?地層系統中的質量能量守恆方程基礎上,推導出了沿身的地層各相產出速度與井眼流量溫度之間的決定性方程組。
  14. Viscosity should not be below 45 sec / qt. maintain with xcd rather than with bentonite. monitor hole cleaning at shakers and adjust low end rheology as required

    要使鉆液粘度不低於每誇脫45秒,就要用生物聚合物來維護,而不用膨潤土。通過振動篩觀察井眼是否干凈,按要求把最終的流變性調低些。
  15. Study of contact force between drill string and borehole wall in constant - curvature wellbores

    等曲率井眼中鉆柱與壁間接觸力分析
  16. The example in the end of the paper shows the method is right and reliable

    文章最後的實例計算表明,本文提出的水平待鉆井眼軌跡最優化設計方法是正確的、可靠的。
  17. The control of the trajectory is the core technique in horizontal well technique, while trajectory design and optimal design are the two key techniques

    井眼軌跡控制是側鉆水平技術的核心,而軌道設計與優化設計又是軌道控制技術的兩大關鍵技術之一。
  18. The crucial technologies of highly - displacement well mainly include torque / friction and wellbore trajectory control tool, and these technologies require rock bit have the following characteristics : having gage protection ability, long axletree lifespan, wear - resisting shirt - tail and head o. d., and high - temperature - resistant sealed system, etc

    大位移的關鍵技術主要有扭矩摩阻和井眼軌道控制工具,這些技術要求鉆頭具有以下特點:具有良好的保徑能力,軸承壽命長,掌尖和掌背部位耐磨損,密封系統耐高溫等。
  19. This technology involves locating wells, optimizing sections, controlling well track and the function of drilling fluid

    對接連通水平工藝技術涉及位的確定、剖面的優選、井眼軌跡控制、鉆液性能等諸多方面。
  20. The principal initial hole factors influencing primary section trajectory, such as sidetracking position ( formation factors ), primary deviating angle and primary azimuth of the sidetracking position are analysed by spatial plane - tilted method

    文章運用空間斜平面法分析了對側?水平起始段有重要影響的主要初始井眼條件,包括側?點(地層因素) 、側?點初始斜角、側?點初始方位角等對起始段軌跡的影響。
分享友人