亮度匹配 的英文怎麼說

中文拼音 [liàngdùpīpèi]
亮度匹配 英文
luminance matching
  • 亮 : Ⅰ形容詞1 （光線強; 明亮） bright; light 2 （聲音強; 響亮） loud and clear; resounding 3 （開朗; ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 匹 : Ⅰ動詞（比得上; 相當; 相配） be equal to; be a match for Ⅱ形容詞（單獨） lone Ⅲ量詞1. （用於馬、騾等） 2. （用於整卷的綢或布）
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 匹配 : 1. [書面語] （婚姻配合） mate; marry 2. [電學] matching
  1. The outside of this chip adopts boost structure to drive up to seven white leds with the input voltage ranging from 3v to 5v. series connection of the leds provides identical led current resulting in uniform brightness

    電路的電源輸入在3v 5v變化，採用boost電路結構升壓，在極限情況下最多可驅動七個白光led ，由於led串聯，因此各led電流完全匹配，亮度一至。
  2. In the lclv, the most important parameter, switching ratio of the lclv, is analyzed. it is mainly influenced by the dark - conductivity, ratio of light - to dark - conductivity, thickness of the photoconductor and the thickness of the liquid crystal. it is concluded that the switching ratio can be improved by matching the thickness of the liquid crystal and the photoconductpr, and the proper change region of the light conductivity of the photoconductor

    在電學匹配方面，我們對光電導材料的暗態電阻、亮暗電導比、厚度以及液晶的厚度等對光閥開關比的影響進行了分析，認為液晶光閥開關能力的提高很大程度上取決于光電導層和液晶層的厚度匹配，以及光電導層的電導變化的區域位置。
  3. It adopted a special matching algorithm that is statistics of similarity of texture. this matching algorithm adopts crisscross characteristic region. by analyzing information of texture in characteristic region it can overcome disturbing factors such as the difference of lighting between pictures, definition, variety of curtaining relationship, and rotary error

    它採用了一種特殊的匹配誤差演算法? ?紋理相似性信息統計法，這種演算法採用十字型特徵區域，通過分析特徵區域中的紋理信息從而有效地排除了圖像亮度差異、清晰度、遮擋關系的變化、旋轉誤差對搜索實際匹配區域的干擾。
  4. We mix our paints to match the color and brightness of that point, and then we measure out a very small amount ? say one hundredth of a gram ? of the mixed paint and apply it evenly to our brush

    我們混合好匹配于該點顏色和亮度的顏料，稱出非常小的量比如說百分之一克把它均勻的加在畫筆上。
  5. For floodlighting, the luminance and the color of the lighted object depend not only on the power and the color of the illuminant, but also on the color of the lighted object ( the spectral reflectance of the surface ), so, if we choose the optimum matching illuminant for the lighted object in lighting design, we can get excellence and energy efficiency result

    摘要：泛光照明中，被照體的亮度大小、顏色變化等視覺效果不但與電光源的功率和光色有關，而且還與物體色（即光譜反射比）等有關，所以在進行照明設計時，應選擇光源色和物體色相匹配的光源，這樣才有可能使泛光照明效果較好，而且達到照明節能的目的。
  6. We tackle the problems with improved algorithms. firstly, we propose a new algorithm which compares the change of video fingerprints instead of comparing video fingerprints directly and interlace scanning is taken considered to make the algorithm more efficient

    在相似性匹配方面，採用比對視頻指紋變化量的方法，取代比較視頻指紋本身，來消除由於視頻處理及傳輸通道噪聲引起的亮度漂移的影響。
  7. A llmmse filter is designed to reduce noise based on the noise model to improve snr of images. making use of the shape and lightness characters of feature points to detect the feature p oints from images. because the accuracy of feature imaging point ' s centroid has close relationship with measuring accuracy, an algorithm based on iteration of the center of the track window is used to improve the measurement accuracy

    圍繞著提高測量精度的要求，分析了影響ccd圖像質量的三類隨機噪聲，建立局部統計特性為高斯分佈的簡化圖像噪聲模型，利用線性最小均方誤差濾波器對圖像進行預處理，而後根據特徵點的亮度和形狀特徵對特徵像點進行檢測，進一步在特徵像點的匹配中採用自適應的質心迭代演算法提高跟蹤精度。
  8. Compared with different inducing methods by lots of experiments, a simple and effective inducing method is confirmed, the opimal technological conditions and formula about the soluton of electroless deposition ni - p alloy are also obtaned. the influence of different technological parameters on the deposition rate is studied. analyzed the pefformance of ni - p alloy on the differen substfates and its corresponding tricture, the result is shown tha the electroless plating nickel process can obtained the ni - p alloy film having brightuess - integrity sdse, strong binding energy and high rigidity at the temperatur about 350wt00oc, the electroless plating nickel film would trallsform from amorphous to crystal state

    本文通過大量實驗，對幾種誘發材料與過程進行分析，研究確定了簡便有效的誘發方法，以及與之相匹配的化學鍍ni - p合金溶液優化配方和工藝條件，討論了各工藝參數對鍍速的影響，並對銅及黃銅基體上得到的ni - p沉積層進行了性能和結構分析，得到外觀光亮完整、結合力強、硬度高的鍍層。
  9. Fully autonomous layered star identification algorithm, which divides the detected stars to lbs and lds, gives priority to lbs in making star triangle and identification, so can find the matching star quickly. it takes the maximum matching reliability and expanding index at the edge of na to reduce the influence of position error, magnitude error and fake star, so have high identification correct rate. it can be used for full and local sky star identification

    全天自主分層星識別演算法，採用分層的方法，以局域亮星為主構造和識別觀測星三角形，減少了待識別的觀測星三角形數量，具有較高的識別速度；採用最大匹配可信度和索引的邊緣擴充方法，可以在一定程度上解決位置誤差、星等誤差和偽星干擾等問題，具有較高的識別準確率；既可以進行全天自主星識別，又可以進行局部星識別。
  10. 2. a series of algorithm and program for tangent correction, radiant correction have been developed, the tangent distortion and the difference between limb radiance and sub - airplane point ( nadir ) radiance was corrected well

    對圖象進行了正切校正，提出了一種基於直方圖匹配的邊緣輻射校正演算法，改正了圖象邊緣列與中心列亮度的差異。
  11. But when there are several kinds of difference between the matching image model and the matched image, such as in lightness, zoom or in angle, the traditional matching algorithms would not be able to obtain satisfying matching results

    但當匹配模板與待匹配圖像之間存在亮度、縮放及角度旋轉等差異時，利用傳統的匹配演算法所得到的匹配結果不盡如人意。
  12. The results of the experiments show that, when there are different kinds of differences in lightness, zoom and angle between matching model and matched image, this kind of optimization algorithm based on evolutionary computation can solve the problem effectively

    實驗結果證明，當待匹配圖像和匹配模板之間存在亮度、大小縮放和旋轉角度差異的情況下，這種基於進化計算的圖像匹配演算法能夠進行正確匹配。
分享友人
分享到 Line

分享到臉書