介質管諧振器 的英文怎麼說
中文拼音 [jièzhíguǎnxiézhènqì]
介質管諧振器
英文
dielectric tube resonator- 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
- 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
- 諧 : Ⅰ形容詞1 （和諧） in harmony; in accord; in tune 2 （詼諧） humorous Ⅱ動詞（商量好; 辦妥） come t...
- 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
- 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
-
The basic principle, main properties, typical parameters, technical characteristics and general situation of klystron are introduced. the electron beam prebunching in the modulated cavity and shift tube of relativistic klystron amplifer ( rka ) is studied analytically, a self - consistent equation of radiation generated by the prebunched electron beam in the radiation cavity is derived using the field method of particle ? wave interaction instead of the electrical circuit method, and in terms of it, the gain in the linear regime calculated, a field analysis method is proposed. the theory analysis shows that the characteristic parameters, such as resonance frequency, real part of gap - impedance, external quality fadtor in all kinds of klystron output circuits including single - beam, multi - beam, single - gap, multi - gap, single - beammulti - gap, multi - beam multi - gap klystron output circuit, can be calculated by the field analysis method
本文系統的介紹了速調管的工作原理、主要特點、發展概況、主要性能指標和技術特點，解析的研究了電子束在相對論速調管放大器的調制腔和漂移管中的預群聚;用粒子波互作用的場方法導出了在輻射腔中預群聚電子束產生輻射的自洽方程，同時對線性區的增益進行了計算。理論分析表明，場分析法可用於計算單注單間隙、多注多間隙、單注多間隙和多注多間隙速調管輸出迴路的諧振頻率、間隙阻抗實部和外觀品質因數等特性參數。The resonance network is connected to the gate, then the output and input matching network is designed to satisfy the oscillation criteria. then harmonic balance method is used to analysize and optimize the output power and phase noise. to minimize the load pulling effect a buffer amplifier is designed to isolate the oscillator and the load
本文在場效應管fet柵極上加上諧振網路（諧振網路是通過cst模擬得到的，它是串聯反饋迴路，介質工作在te01模，對于其後的fet ，它又相當於一個帶阻濾波器） ，然後設計輸入輸出匹配電路，使電路結構滿足起振條件，之後繼續用諧波平衡法模擬和優化，使振蕩器輸出功率合適，相位噪聲很低。
分享友人