介面驅動器 的英文怎麼說

中文拼音 [jièmiànqūdòngqì]
介面驅動器 英文
interface driver
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 驅 : 動詞1. （趕） drive （a horse, car, etc. ） 2. （快跑） run quickly 3. （趕走） expel; disperse
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 介面 : joggle; nozzle; mouthpiece; [計算機] interface
  • 驅動器 : actuator
  • 驅動 : [機械工程] drive; prime mover
  1. Taking the vr step motor as example in the paper, systemic research is conducted about the principle of the subdividing drive, the non - linearity relationship between microstep and phase current, the method of velocity adjusting and the interrelated factors. the system is designed to realize the subdividing drive, velocity adjusting and position. especially, there are two innovations in this paper. one is the first introduction of pld device and isp technology to the design of phase sequencer, the other is the new measure and amend method of microstep

    本文以三相反應式步進電機為實例，對細分驅動原理、細分驅動的非線性、變細分調速以及相關影響因素進行系統的研究；實現細分驅動器、調速控制、定位控制和軟硬介面的設計。在此基礎上，本文對細分驅動環形分配器的設計和微步距測量修正進行了創新；提出將pld器件和isp技術引入到細分驅動環形分配器的設計思想和錯位測量和逼近修正法。
  2. The tristate driver circuit that interfaces with the main distributing frame and the transmit / receive filters. the drivers and filters are part of the port grouping

    與主配線板和發送接收濾波器介面的三態驅動電路。驅動器和濾波器都是埠分組的一部分。
  3. There is difference frequency measurement requirement for every part of pid regulating, difference between dynamic quality and static quality in response time and accuracy. according to these, it use the interrupt functions and high - speed counter of the simens s7 - 200 plc cpu226 basic unit and some peripheral circuit to measure frequency ; in software designed, the procedure frame of hydraulic - turbine governor and disperse process of parallel pid are analyzed, an improved pid algorithm is adopted to realize a pid regulation mode with variable structure and parameters ; the mechanical liquid - pressure system of the hydraulic - turbine governor is with electric - hydraulic converter unit of step motor. according to the drive character of five phase of response step motor, a variable frequency regulated voltage driver unit is designed in order to realize interface between plc and driver of step motor

    本文利用s7 - 200plc自身的特點設計了頻率測量單元，根據pid調節各個環節的特點，以及調速器動態特性、靜態特性對頻率測量的實時性和精度要求的不同，利用s7 - 200plc基本單元中內置的高速計數器以及相應的外圍放大整形、分頻電路，實現了水輪發電機組頻率的測量；在軟體上，對微機調速器的整個程序框架、並聯pid的離散化過程進行了分析，選用改進的pid演算法實現了變參數、變結構的pid調節模式；調速器的機械液壓隨動系統具有步進電機電液轉換元件，採用五相反應式步進電機，根據其驅動特性設計了變頻調壓驅動器，實現plc與步進電機驅動器之間數字介面。
  4. The system composition structure includes 8031 single chip computer, signal test ( count sensor and speed sensor ), electrical interfaces ( amplification shaping circuit, drive, relay, 8155 parallel i / o, 8279 keyboard display, d / a converter ) and executive mechanism ( electromagnet and electromotor )

    系統組成結構由8031單片機、信號檢測（計數傳感器和測速傳感器） 、電氣介面（放大整形電路、驅動介面、繼電器介面、 8155并行i o介面、 8279鍵盤顯示器介面和d a轉換介面） 、執行機構（電磁鐵和電機）組成。
  5. In order to get data, the plane use the way of comparative between the black line and white line. the device is composed of the pulse producer, system controller, signal processor, logic analyzer, interface circuit and electrical machinery driver. this device could follow the tracks of the plane graphic border automatically

    跟蹤裝置運用黑白交界圖線比較法取得數據，由步進脈沖發生器，系統控制器，信號處理器，邏輯判別器，介面電路，電機驅動器等組成，可對平面圖形邊界進行自動跟蹤控制。
  6. The built - in 3. 5 inch disk driver or usb joint, it can directly read the design patterns of tajama and barudan

    內置3 . 5英寸磁盤驅動器或usb介面，可直接讀取田島、百靈達格式的製版花樣。
  7. The controller adopts tms320f240 dsp as its main control unit, using code wheel for angle measurement, using synchronous serial communications interface for the duplexing data communication between the controller and the upper computer, using rs - 232 interface for the communication between the pitch axis controller and the azimuth axis controller, and then developed the interface circuit to the motor driver

    根據控制器研製要求，提出總體方案。控制器採用dsp作為主控單元，利用光電碼盤測角，利用同步串列通信介面與上位機進行雙向數據通信，利用rs - 232介面進行俯仰軸和方位軸控制器之間的通信，並研製了與電機驅動器的介面電路。
  8. To rerun setup, use the procedure in " using an emergency repair disk for system repairs " earlier in this appendix, and omit the step where you insert the emergency repair disk in the disk drive

    要重新運行安裝程序，請使用本附錄前面的「使用緊急修復磁盤進行系統修復」中介紹的步驟，並跳過將緊急修復磁盤插入磁盤驅動器的步驟。
  9. Sercos interface, a serial real - time communications system, is an connection of nc controller, drives, motion unit and i / o unit of nc control system, which are connected by a fiber optical ring

    Sercos介面是數字控制系統中連接數字控制器、驅動器、執行機構以及輸入輸出部件，在彼此間進行實時通訊的國際標準。 sercos介面採用光纜將控制部件連接在一起，構成一個封閉的環路。
  10. Enhanced integrated drive electronics eide, also called parallel ata pata, hard drives have been the standard in the computer industry for more than 10 years

    10多年來，採用增強型電子集成驅動器eide ，也稱為并行ata pata介面的硬盤一直是家用電腦行業的標準。
  11. The early studies are mostly focused on the method of gluing piezoceramics on structural surfaces, which has some disadvantages such as difficulties to protect the ceramics and the connection wires, bad coupling with only one surface glued on the base materials, low signal - to - noise ratio etc. these problems can be solved using the embedded piezoceramics, and furthermore, the piezoceramics can be placed in the optimal positions, especially in the optimal deepness for the piezo - actuators, according to an optimization algorithm befor e they are embedded, so the actuator effects and sensor signals are thereby enhanced

    早期的研究主要集中在表面粘貼壓電片的結構，表面粘貼壓電片具有一些無法克服的缺點。本文著重進行利用埋入復合材料結構的壓電傳感器和壓電驅動器對其振動進行主動控制的相關理論和實驗研究，並介紹其相應結果。埋入型壓電材料的優點主要是能保護壓電傳感器和作動器及其連線、增強壓電材料和基體材料的耦合、優化埋入壓電陶瓷的深度和厚度可增強壓電傳感器的測量信號並提高信噪比等。
  12. A typical calculator chip from rcl semiconductor inc, c9821, is referenced and developed. the chip of the calculator consists of several function units such as rc oscillator, power management module, microprogrammed control unit ( mcu ), register group, lcd driver and keyboard interface

    在硬體方面，在完成計算器的功能模塊劃分的基礎上，對包括rc振蕩器、電源模塊、 lcd顯示驅動模塊、鍵盤介面、寄存器組、微程序控制器在內的各個功能模塊的系統結構和電路原理進行了分析，掌握了它們的設計方法。
  13. In the thesis, many data on micro - displacement stages have been collected ; their study status at home and abroad has been introduced in brief. and some control elements and mechanism in micro - displacement system have been sufficiently stated and compared. in addition, evaluation criterion of micro - displacement system has been summarized

    在收集了大量微位移工作臺方面的資料的基礎上，本文對國內外的研究現狀做了介紹；對常見的微位移系統中的機構和驅動器做了闡述和比較；還對微位移系統的評價標準做了較全面的總結。
  14. Based on the functions of the gpib - rs232 convertor, we can develop th e instrument driver and the dso control panel. thanks to labwindows / cvi, with its great help, we can finish these tasks in a much easier way

    在介面通信完成的基礎上，可以根據示波器的功能開發示波器的儀器驅動器以及示波器的虛擬控制面板。
  15. Information technology - intelligent peripheral interface - device generic command set for magnetic and optical disk drives

    信息技術.智能外圍介面.磁帶和光盤驅動器用設備總命令集
  16. Parallel port interface is a horrid kluge asking for trouble, and usb drives are slow

    並口介面是一種會給您添麻煩的棘手玩意兒，而usb驅動器則很慢。
  17. This thesis includes the hardware design of messaged _ based interface, the realization of the word serial transfers, the translating of scpi commands, the programme of awg ' s instrument driver, the debugging work associated with functional circuit and soft panel and the testing of module compatibility based vxi bus, edc

    本文的主要內容包括： vxi總線消息基介面硬體設計、字串列通信協議實現、 scpi命令翻譯、 vxi任意波形發生器儀器驅動器設計、與功能電路和軟面板的聯調和大量的模塊兼容性測試。
  18. This dissertation grounds on the development of pattern i / o module, some key techniques including the design of a register _ based interface circuit and the data generating and sampling circuit are discussed explicitly. on the basis of virtual instrument software architecture, the programme of the instrument driver and application software are discussed detailedly. and some idea and experience developed by the author in the course of debugging and testing the circuit are discussed also

    本文立足於vxi總線自動測試系統圖形i / o模塊的研製工作，在vxi總線系統體系結構基礎上，介紹了vxi總線圖形i / o模塊介面電路和數據輸入輸出功能電路的實現方案;在虛擬儀器軟體構架visa的基礎上，根據測試任務完成了vxi總線圖形i / o模塊儀器驅動器和應用軟體的設計與編寫;對驅動程序調試過程中出現的問題，進行了較深入的分析，並提出了實際的解決措施。
  19. ? analysing and researching full - digital dc speed adjustment controller, and expounding the elementary component, elementary working principles, 110 technology and the configutation and tune of main parameters. ? devising the plc control system of container loading bridge, mainly including hardware and software design, and emphatically studying the problem of cargoes ? weight measurement of container loading bridge

    對全數字直流調速器進行了比較深入的分析與研究，並以法國te公司的rtv - 84系列直流驅動器為例，闡述了其基本硬體組成、基本工作原理、 i / o介面技術以及主要參數的配置和調節。
  20. Interface power driver

    介面功率驅動器
分享友人
分享到 Line

分享到臉書