低周疲勞 的英文怎麼說

中文拼音 [dīzhōupíláo]
低周疲勞 英文
low cycle fatigue
  • 周 : Ⅰ名詞1 （圈子; 周圍） circumference; periphery; circuit 2 （星期） week 3 [電學] （周波的簡稱） c...
  • 疲 : 形容詞（疲乏; 勞累） tired; weary; exhausted
  • 勞 : Ⅰ動詞1 （勞動） work; labour 2 （煩勞） put sb to the trouble of; trouble sb with sth : 勞您費心...
  • 疲勞 : 1. （疲乏勞累） tired; fatigued; weary; become fagged 2. （機能或反應能力減弱） fatigue; strain 3. [物理學] fatigue
  1. The initial requirements involved the belief that the presence of a duplex or "necklace" structure was intolerable from a low cycle fatigue aspect.

    最初有人認為從低周疲勞性能的角度來說雙層或「項鏈」組織是絕對不行的。
  2. For rotor steel ( 30crlmolv steel ), the tests of low - cycle fatigue property are done under different temperatures. the fatigue life under different temperatures is researched to make up for the defects of the testing for foreign similar materials. when pull - stretch data is attempted to evaluate low - cycle fatigue data, the result shows that four - point associated method in middle - low life zone is done well under room temperature, but there are large errors of four - point associated method and general - slope method under other temperatures

    在本文中，通過與國外同類材料的性能進行比較，國產材料與國外材料共有的材料特徵基本相同；對轉子鋼（ 30crlmolv鋼）進行了不同溫度下的低周疲勞性能實驗，研究其在不同溫度下疲勞壽命，以彌補國外對同類鋼材測試的不足；採用拉伸數據預測低周疲勞壽命時發現，室溫條件下用四點關聯法在中低壽命區預測較好，在高溫條件下四點關聯法和通用斜率法都有較大誤差，需要進行改進。
  3. The paper is dedicated to study the low - cycle fatigue behavior of a certain semi - rigid connection : the top - and - seat angle

    本文嘗試研究一種半剛性連接-頂底角鋼連接的低周疲勞性能。
  4. Zircaloy - 4 sheet, which was cold - worked followed by recrystallization annealing, exhibits longer lcf life in the rolling direction than that in the transverse direction, and the fact that difference in lcf life between both directions becomes larger as the range of plastic strain becomes lower can be attributed to the texture effect, p - solution treatment deteriorates the alloy ' s lcf property because the treatment lowers the average value of alloy ' s schmid factors, and the subsequent annealing - treatment in a - phase range has a impact on the lcf properties, i. e. the subsequent annealing - treatment at 500 ? for 1. 5h results in better property than that at 750 for 1. 5h, which comes mainly from the fact that the alloy annealled at 500 for 1. 5h has lower amount of the precipitate particles than the alloy annealled at 750 for 1. 5h

    對于冷加工后經再結晶退火處理的zr - 4合金，軋制方向的低周疲勞壽命比橫向要大。隨著_ p的降低，兩個方向的低周疲勞壽命的差別相應增加，這是由於合金中存在織構的緣故。冷加工后經再結晶退火處理的zr - 4合金在固溶處理后，抗疲勞性能明顯降低，這主要是由於固溶處理降低了合金的schmid因子；固溶處理后在相區的退火對疲勞性能有影響，即500 1 . 5h退火的抗疲勞性能要優於750 1 . 5h退火，這主要與500 1 . 5h退火的合金中沉澱相粒子的數量較少有關。
  5. Furthermore, the lcf behavior of hydrided zircaloy - 4 plate has been also investigated

    且進一步探討了氫對zr - 4合金的低周疲勞性能的影響。
  6. Low cycle fatigue ( lcf ) behavior of zircaloy - 4 has been reviewed in the present paper. then, the lcf behavior of a recrystallized zircaloy - 4 plate with different texture has been studied at room temperature and 400, respectively

    並在此基礎上，研究了不同溫度（室溫和400 ） 、不同取向（平行於軋向和垂直於軋向）的再結晶退火態zr - 4合金板材試樣的低周疲勞性能。
  7. The test of low cycle fatigue characteristics for 45crnimova steel and in - situ observation on surface crack propagation

    鋼的低周疲勞特性和表面疲勞裂紋的在位觀測
  8. Under seismic ground shaking, the ability of the connection to dissipate energy will depend on the connection ' s capability to withstand low cycle fatigue

    在地震地面振動時，連接的耗能能力取決于抵抗低周疲勞的能力。
  9. In this paper, the high - temperature low - cycle fatigue life and fatigue crack propagation life tests are carried on the cylindrical axial symmetry specimens having precrack or non - precrack with different types of notches of 16mnr steel in common use in the petrochemical industry contacting coke drum equipment, the stress / strain and the range of stress / strain of dangerous points are received through stress analysis of the specimens using finite element program under multi - axial stress state. at last, the equations of evaluating the high - temperature low - cycle fatigue life and the fatigue crack propagation life are found through using the least - square regression method

    本文採用無預裂紋和帶預裂紋環狀缺口圓柱形試樣，進行了石化焦炭塔設備常用材料16mnr多維應力狀態下不同缺口形式的高溫低周疲勞總壽命試驗及裂紋擴展壽命試驗，並利用有限元程序對試樣缺口周圍及裂紋尖端附近進行了軸對稱多維應力狀態下的應力、應變場分析，來評價材料不同條件下的高溫低周疲勞總壽命和裂紋擴展壽命，最後利用最小二乘回歸方法，得到了該材料高溫低周疲勞總壽命和裂紋擴展壽命評價方程。
  10. Based on the experimental data of rotor steel 1crmov in the loading of low - cycle fatigue at high temperature, the strength behavior and the fatigue life curve of this material at 550 have been achieved. meanwhile, with respect to three kinds of notched bar, their material damage assessment method under multiaxial stress condition is discussed

    本文在1crmov材料的高溫低周疲勞實驗數據進行了整理和統計的基礎上，得到了材料的疲勞強度特性曲線和疲勞壽命曲線，同時對三種不同缺口形式的圓柱形試件進行了多軸應力狀態下的材料損傷的研究，並通過數值計算方法進行了疲勞壽命評估。
  11. These stud " can be concluded as following : on the basis of the bhw - 35 steel p - s - n curve and its da ' dn growth law the method of low - cycle fatigue life evaluation of 401 t / h boiler was proposed. and a mechanics model was suggested for calculating the stress of internal pressure suffering elbow. with the elbow fatigue test, a method of evaluation the fatigue growth life of pressure suffering elbow is recommended ; and the elementary use of damage mechanics on the fatigue life evaluation of the boiler drum

    本文創新點為：在bhw - 35鋼的p ? s ? n曲線及da / dn擴展規律的試驗研究基礎上，提出了410t / h鍋爐汽包的低周疲勞壽命分析與預測方法；建立了一種橢圓截面變厚度彎管承受內壓時的應力計算力學模型，通過壓力彎管的疲勞試驗，本文推薦其低周疲勞擴展壽命預測方法；將損傷力學應用到鍋爐汽包疲勞壽命預測做了初步的探索。
  12. Analysis results of histogram statistics and section electron microscopic scan technique, are that fracture feature of the cracks of the hbbb is similar and the crack is multi - source strain fatigue one. internal defects of the cast, such as impurities, gas holes, etc, are the main causes for early cracks. the contrast analysis of static strength, model and transient respond on three structures with fem proves that geometrical stress concentration in partial area has influence on early crack, also

    利用直方圖等統計方法和電鏡掃描技術對該抱軸箱體裂紋分析的結果是：抱軸箱體的裂紋斷口特徵相近，裂紋性質屬于多源性低周疲勞裂紋，鑄件中的夾雜、氣孔等內部缺陷是導致過早裂損的主要原因；利用有限元法對該抱軸箱體三種結構的靜強度、模態和動態響應對比分析，證實了局部幾何性應力集中對過早裂損也有一定影響。
  13. Sem investigation shows that all the crack initiations can be traced back to the lateral sides of the sample, and the crack propagates along the direction normal to the loading axis

    Zr一4合金的低周疲勞斷口上，所有裂紋都起源於試樣最窄處的側表面，並逐漸向內部擴展。
  14. The change of elastic constant of steel 20 in low - cycle fatigue procedure measured by ultrasonic

    用超聲波法測試20鋼低周疲勞過程中彈性常數的變化
  15. A new test method to achieve the dynamical rock failure with medium strain rate by low - cycle - index fatigue loading

    用低周疲勞加載實現中等應變速率下巖石動態破壞的新方法
  16. Bracing members in concentrically braced structures may be subjected to large cyclic deformations due to local buckling during a severe earthquake causing possible early fractures

    摘要在罕遇地震下，框架中心支撐結構中的鋼支撐常因局部屈曲位置的低周疲勞開裂而過早退出工作。
  17. On the basis of all these research, the method of low - cycle fatigue life analysis and estimation for 4 lot / h boiler drum was set up

    在上述研究的基礎上，建立了410t / h鍋爐汽包的低周疲勞壽命分析與預測的方法。
  18. In this dissertation, the effect of texture, heat - treatment, and hydrogen on the lcf behavior of zircaloy - 4 and the cyclic deformation behavior for zircaloy - 4, n18 alloy and n36 alloy have been investigated systematically using fully - reversed tension - compression loading under strain control ( r = min / max = - 1 ), while the evolvement of the friction and back stresses versus the number of repeated working cycles and the plastic strain amplitude has been studied, and the thorough discussion combined with the analysis result of fatigue sub - structure, friction and back stresses, and fatigue fracture has been given to the mechanism underlying the lcf behavior of alloys

    本文採用對稱拉壓循環變形方法（ r _ = _ （ min ） _ （ max ） = - 1 ） ，系統研究了織構、熱處理狀態、氫對zr - 4合金低周疲勞性能的影響， zr - 4合金、 n18合金和n36合金的循環變形行為，並研究了摩擦應力、背應力隨循環周次、塑性應變幅的變化規律。結合疲勞亞結構和疲勞斷口的分析結果，深入探討了影響合金低周疲勞行為的作用機制。
  19. However, the lcf of r specimen containing - 200 g / g hydrogen is better than that of the hydrided t specimen, and shows slightly superior to unhydrided r specimen, whereas the hydrided t specimen has not the apparent difference as compared with t specimen

    與室溫下未滲氫態試樣相比，滲氫后r向試樣的低周疲勞性能稍稍優于未滲氫態r向試樣，但對t向zr一4合金試樣，滲氫對其室溫低周疲勞性能幾乎沒有影響。
  20. The application of elastoplastic stochastic finite element method in low cycle fatigue analysis

    彈塑性隨機有限元在低周疲勞分析中的應用
分享友人
分享到 Line

分享到臉書