余熱利用系統 的英文怎麼說

中文拼音 [yúrèlìyòngxìtǒng]
余熱利用系統 英文
bootstrap system
  • 余 : Ⅰ動詞（剩下） remain; leave: 9減4 余 5。 nine minus four is five ; four from nine leaves five ; i...
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 統 : Ⅰ名詞1 （事物間連續的關系） interconnected system 2 （衣服等的筒狀部分） any tube shaped part of ...
  • 余熱 : afterheat; waste heat
  • 系統 : 1. （按一定關系組成的同類事物） system 2. （有條理的;有系統的） systematic
  1. The afterheat, which is collected by recovery devices, in winter can be used as the low level thermal source of heat pump, and in summer can preheat feed water, thus equivalent an economizer. because energy flows in the system so reasonably that energy is used to the most, therefore, its energy conservation effect is significant, and the operating expenditure declines consequently. the sewage can be reused after due treatment, thua it has a certain social and ecological benefit, too

    本研究中選用分離式熱管裝置提供洗浴用水，利用水源熱泵裝置，一機兩用，進行空間供熱和製冷，並通過余熱回收器對系統內的余熱進行回收，冬季可作為水源熱泵的低位熱源，夏季可對鍋爐給水進行預熱，起到「省煤器」的作用。這樣實現系統內的能量合理流動，從而達到節能的目的，同時洗浴污水經適當的處理后可以回用，因而還具有一定的社會和生態效益。
  2. It firstly introduces time principle of dy refrigeration system from two aspects of surplus heat utilization of internal combustion engine and heat energy refrigeration

    首先從內燃機余熱利用及熱能製冷方面比較分析，系統地介紹了dy製冷系統工作原理。
  3. In chapter 5, the principle of molten carbonate fuel cell power system is introduced. the development of the system, such as the improvement of cell components including electrodes and electrolyte, the fuel processing, the heat recovery, the power conditioning and grid interconnection, the control system and the combine generation

    第五章在簡要敘述了熔融碳酸鹽燃料電池發電系統原理后，從以下幾個方面對系統的開發進行了論證:單體元件（電極和電解質）性能的提高，燃料的處理，余熱利用，電力調節和並網，燃料電池/燃氣輪機/汽輪機聯合發電以及系統控制與優化。
  4. The experimental models not only can be introduced into low temperature waste - heat power generation, but also can be available in the geothermal, solar and ocean thermal gradient power generation

    該項研究的實驗模型不僅可以利用在低溫余熱發電系統，而且對地熱、太陽能及海洋溫差發電均有參考價值。
  5. The cost - evaluation model of hrsg was also established, the data and empirical correlations used in cost model are all from domestic manufactures and hence are real and practical

    利用國內製造廠的實際經驗數據和公式，建立了實用的余熱鍋爐造價估算模型。按照本文提出的成本分攤方法及余熱鍋爐造價估算模型，建立了bchp系統的熱經濟學模型。
  6. In order to study the thermal performance and residual stress of microelectronic subassembly, in this paper, a newly optical interferometry method for 3 - d displacement measurement is developed based on wavefront interference theory. in which the moire interferometry provide the in - plane displacement, but the system is different from the conventional interferometry, the system applies the double diffraction of the specimen grating, the in - plane displacement sensitivity is a factor of 2 higher than that of the conventional moire interferometer. twyman / green interferometry method for out - of - plane displacement measurement is adapted, the advantages of the optical set - up are structure novelty, and the fringe patterns of the displacement fields shown high contrast and spatial resolution

    為了詳細研究試件的熱變形特徵以及殘余應力的影響作用，本文在波前干涉理論的基礎上，設計了一新型三維光學測試系統，該系統的平面位移測試基於雲紋干涉方法，但採用與普通雲紋干涉不同的光路系統，利用試件光柵和平面反射鏡組形成的兩次衍射，使平面位移干涉條紋倍增，測量靈敏度是普通雲紋干涉的2倍，系統的離面位移場測試採用泰曼格林干涉光路。
  7. The present situation of energy utilizing in foundry industry was analyzed, the main effective energy saving techniques and their application was described in aspects of melting and heating systems, moulding and core - making processes and equipments, low - stress cast irons, as - cast nodular irons, feeder - less method of nodular reclaiming of cupola gas, and so on

    摘要分析了鑄造行業能源利用現狀，從熔煉加熱系統、造型制芯技術與裝備、低應力鑄鐵、鑄態球墨鑄鐵、球鐵無冒口鑄造、鑄鋼保溫冒口與保溫補貼、沖天爐廢氣綜合利用和余熱回收利用等方面闡述了鑄造行業行之有效的主要節能技術及其應用。
  8. A absorption automotive air conditioning system fed by waste heat of exhaust gas was raised, and the feasibility was discussed by analyzing the structure of the system and thermodynamics

    摘要提出了一個利用尾氣余熱的吸收式汽車空調系統，通過熱力學計算及結構分析指出了吸收式汽車空調系統的可行性。
  9. Further, waste heat recovery boiler and steam turbine are combined to improve system efficiency, resulting combined cycle generation. main characteristics of this technology are as follows

    為進一步提高系統效率，可利用氣化系統和內燃機產生的余熱，通過余熱鍋爐和蒸汽輪機實現聯合循環發電。
分享友人
分享到 Line

分享到臉書