余膨脹 的英文怎麼說

中文拼音 [péngzhàng]
余膨脹 英文
after-expansion
  • : Ⅰ動詞(剩下) remain; leave: 9減4 余 5。 nine minus four is five ; four from nine leaves five ; i...
  • : 動詞(物體的長度或體積增加) expand; swell
  • : 動詞1. (膨脹) expand; dilate; inflate 2. (脹大) swell; distend; bloat
  • 膨脹 : expand; swell; dilate; inflate; puff; bulge; inflation; expansion; dilatation; buckling; swelling...
  1. Owing to the expansion of the universe, an observer today would expect to find these remnants to have undergone a red shift to long wave lengths.

    由於宇宙的,今天的觀察者可望找到這些向長波紅移了的殘物。
  2. Based on the pull - out tests data between geogrids and expansive soil / sands arranged by the orthogonal table l9 ( 34 ), the following conclusions are reached : 1 ) the displacement - properties of pullout tests depend on the pullout speed. the law of factors " affecting degree, which influences the parameters between geogrids and soils in the pulling - out procedure, is obtained. with the concept of " equivalent pull - out displacement ( x ) " brought forward, the whole process of pull out tests is divided into two process - " main process ( when x 1. 0 ) " and " residual process ( when x 1. 0 ) ", and three stages - static friction resistance stage, slip friction resistance stage, and residual friction resistance stage

    基於正交設計表l9 ( 3 ~ 4 )分別安排了影響因素與土工格柵土或砂土界面相互作用參數的拉拔試驗數據,獲悉: 1 )拉拔試驗位移特性主要取決于影響因素中拉拔速率;通過分析並獲取影響因素對筋土界面相互作用參數的影響程度及其在拉拔試驗過程中的變化規律,提出了當量拉拔位移( x )的概念,並據此將拉拔試驗全過程劃分成「主過程( x 1 . 0 ) 」和「殘過程( x 1 . 0 ) 」 ;且將影響因素對拉拔力或摩擦阻力系數的影響程度分成三階段(靜摩擦阻力階段、滑動摩擦阻力階段,殘摩擦阻力階段) ; 2 )不同(規范)定義的筋土界面摩擦阻力系數數值相差較大,但影響因素對摩擦阻力系數影響程度及其變化規律不會因不同(規范)定義而受到影響。
  3. In metal matrix composites, thermal residual stresses will arise due to get ( coefficient of thermal expansion ) mismatch between matrix and fiber during cooling

    在擠壓鑄造的金屬基復合材料中,由於基體和纖維的熱系數相差很大,所以在制備過程中由高溫(工藝溫度)冷卻至室溫時復合材料中會有熱殘應力產生。
  4. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響,對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響,弄清了氮氣輔助蒸汽增產的機理主要表現在:氮氣輔助后增加攜熱能力,降低殘油飽和度,氮氣的壓縮作用分散和改變了原油流動形態,增強了原油流動性;擴大蒸汽的波及體積,補充地層能量,提高回採水率,強化蒸汽蒸餾效應。
  5. It was found that the interfacial bonding of 93w - ofc was both the joining action of ofc / w grains and that of ofc / ni - fe binders, whereas the joining of ofc to tc4 could be seen as the mutual intense diffusion effect between ofc / tc4 and as a result cu - ti intermetallic compounds were formed at the joint. the joining of tc4 - a1 and a1 - mb2 were also attributed to the result of diffusion between elements ti - al and al - mg respectively. on the other hand, residual thermal stress and stress - induced distortion were produced at the joint simultaneously due to the difference in thermal expansion coefficient of different welding " materials

    研究表明, 93w與ofc的界面連接是ofc與93w中w晶粒的連接以及ofc與93w中ni - fe粘接劑的連接共同作用的結果; ofc與tc _ 4連接界面的形成是由於ofc與tc _ 4之間發生反應擴散,並由此在二者接頭處生成了cu - ti金屬間化合物的中間相; tc _ 4 - al的連接與al - mb _ 2的連接則分別是其基體元素ti 、 al之間和al 、 mg之間元素互擴散的結果,另外,由於熱系數的差異,擴散焊接后在不同焊件的接頭處存在殘熱應力並由此引起接頭的形變。
  6. Comparing the residual strength of the grey - white expansive soil of ningming obtained by three different methods, the results are proved correct in the reference [ 2 ], and it ' s feasible to determine the residual strength of recompacted specimens

    通過對比3種不同制樣方式得到寧明灰白色土的殘強度,驗證了文獻[ 2 ]中結論的正確性,進一步探討了採用土重塑樣確定其殘強度的可行性。
  7. The basic physical and mechanical properties, mineral composition, micro structures, swelling potential, consolidated drained triaxial shear strength, parameters of constitutive model and residual strength of the soft clayey rocks were tested in laboratory with a large number of natural samples. the changing trend of the strength about these rocks is obtained by modeling the condition of softening due to immersion. from the principles of modern soil mechanics, the structural and swelling characteristics of soft clayey rocks were analyzed systematically

    本文通過現場調查,查明風化泥質軟巖的宏觀結構特徵,利用現代試驗測試手段,取原狀土系統進行特殊土室內土工試驗,測定土的基本物理力學特性、礦物成分及微觀結構、性、三軸排水剪強度及本構模型參數、軟化殘強度,並模擬土體在長期浸水軟化后的強度變化趨勢,測試該類土的浸水軟化殘強度。
  8. It is a better way to prepare exfoliate graphite with no harmful sulfur and high performance, such as large specific surface area and high sorption capacity

    所制得的石墨具有良好的比表面積及對吸附性能,並且沒有有害硫的殘
  9. If low residual stress and better residual stress distribution map are expected, adhesives with low cte is preferred, which could be a criteria to select organic adhesives

    使用熱系數較小的有機粘合劑粘貼晶元時,可獲得較低的殘應力和相對優越的應力分佈。該規律可以作為選擇有機粘合劑時的參照。
  10. Numerical calculus and experiment for crystallization process of li2o - al2o3 - sio - p2o5 system glass indicated : size of crystallization grain can be controlled by forming residual glass phase with high melting point, and by this way we got transparent glass - ceramic

    並依據理論分析的受控模型獲得了小晶粒的透明微晶玻璃。討論了通過主晶相和殘玻璃相的系數估算析晶量的方法。
  11. By introduction to structure analysis and design calculation of middle pressure tubular waste heat boiler with expansion joint, the author thinks rational selection to the standard and code of the boiler and vessel is the key to assure the product design and manufacture quality and guarantee personal safety without the special national standard " tubular waste heat boiler " now

    摘要通過介紹一臺6t / h 、帶節的中壓管殼式熱鍋爐的結構分析和設計計算過程,認為在目前國內尚沒有專門的《管殼式熱鍋爐》標準情況下,合理選用各受壓元件所對應的鍋爐、壓力容器標準規范,是確保該類產品設計製造質量和保障人身安全的關鍵。
  12. In order to find an effective process for fabricating exfoliate graphite without sulfur, the different methods have been investigated in this paper

    本文從石墨的制備工藝出發,旨在找尋一種在無硫酸的介入下制備石墨的工藝,達到無有害硫殘的目的。
分享友人