余阻力 的英文怎麼說

中文拼音 [yúzǔlì]
余阻力 英文
residual resistance
  • 余 : Ⅰ動詞（剩下） remain; leave: 9減4 余 5。 nine minus four is five ; four from nine leaves five ; i...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 阻力 : 1 （阻礙事物發展的外力） obstruction; resistance 2 [物理學] resistance; drag; drag force; nowel; ...
  1. However, by the time a lightning strike has traveled through the distribution network, surge arrestors will have dissipated a proportion of the charge, network impedance will have shaped the impulse and the residual energy can be represented in terms of its waveshape, and its peak current which is what will be present at a service entrance

    然而，雷擊經過電力網路進行傳送以後，避雷放電器會將一部分能量泄放掉，網路的阻抗也會對電涌進行修整，而殘余的能量將可以以它的波形來體現，其峰值電流也就是建築物進入端將會出現的情況。
  2. 3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant

    對鍋爐本體進行了燃料燃燒計算、爐膛結構熱力計算、對流受熱面結構熱力計算、鍋爐給水加熱器結構參數設計、煙道阻力計算及鍋爐元件強度校核等；改進了水冷壁布置使換熱效果更好，減少輻射換熱損失；改進對流段結構，更充分的利用爐膛出口煙氣余熱，提高熱效率；並且進行了煙氣阻力計算、熱效率計算和能量平衡測試，對改進后的稠油燃料和改進前進行了對比，燃燒狀況和熱效率有明顯改善。
  3. Based on the pull - out tests data between geogrids and expansive soil / sands arranged by the orthogonal table l9 ( 34 ), the following conclusions are reached : 1 ) the displacement - properties of pullout tests depend on the pullout speed. the law of factors " affecting degree, which influences the parameters between geogrids and soils in the pulling - out procedure, is obtained. with the concept of " equivalent pull - out displacement ( x ) " brought forward, the whole process of pull out tests is divided into two process - " main process ( when x 1. 0 ) " and " residual process ( when x 1. 0 ) ", and three stages - static friction resistance stage, slip friction resistance stage, and residual friction resistance stage

    基於正交設計表l9 （ 3 ~ 4 ）分別安排了影響因素與土工格柵膨脹土或砂土界面相互作用參數的拉拔試驗數據，獲悉： 1 ）拉拔試驗位移特性主要取決于影響因素中拉拔速率；通過分析並獲取影響因素對筋土界面相互作用參數的影響程度及其在拉拔試驗過程中的變化規律，提出了當量拉拔位移（ x ）的概念，並據此將拉拔試驗全過程劃分成「主過程（ x 1 . 0 ） 」和「殘余過程（ x 1 . 0 ） 」 ；且將影響因素對拉拔力或摩擦阻力系數的影響程度分成三階段（靜摩擦阻力階段、滑動摩擦阻力階段，殘余摩擦阻力階段） ； 2 ）不同（規范）定義的筋土界面摩擦阻力系數數值相差較大，但影響因素對摩擦阻力系數影響程度及其變化規律不會因不同（規范）定義而受到影響。
  4. In contrast, china is benefited significantly when japan gets to be involved into ftas, which allows china to increase exports of rice, pork, poultry meat, vegetables and fruits to japan

    日本開放農業部門對中國最為有利，稻米、豬禽肉和蔬菜水果有望獲得較大的貿易贏余，但是日本勢必面臨較大的國內阻力。
  5. The phase structure of different cu - fe thin films were studied by using grazing incidence x - ray analysis ( gixa ). the texture and residual stress of different cu - fe thin films were measured by scan of x - ray diffraction ( xrd ) and 2 scan with different. the thicknesses of different thin films were characterized by means of small angle x - ray scattering ( saxs ) technique. by using atomic force microscope ( afm ) measured surface roughness of thin films. the component of different thin film was characterized by energy disperse spectrum ( eds ) and x - ray fluorescence ( xrf ). the magnetic properties of cu - fe thin films were measured by means of vibrating sample magnetometer ( vsm ). in addition, the giant magnetoresistance ( gmr ) effects of different films were also measured. the original resistance of the film fabricated by a direction - current magnetron sputtering system is directly affected by bias voltage

    利用掠入射x射線分析（ gixa ）技術對不同cu - fe薄膜的相結構進行了研究;利用xrd掃描及不同角度的2掃描對薄膜進行了結晶織構及殘余應力分析;運用小角x射線散射（ saxs ）技術測量了薄膜的厚度;採用原子力顯微鏡（ afm ）觀察了薄膜的表面形貌;運用能量損失譜（ eds ）及x射線熒光光譜（ xrf ）對薄膜進行了成分標定;使用振動樣品磁強計測量了不同cu - fe過飽和固溶體薄膜的磁性能;最後利用自製的磁阻性能測試設備測量了真空磁場熱處理前後不同薄膜的巨磁阻值。
  6. The original design was intermediate vapor 42t / h, but the actual output is 30 - 35t / h, at the same time the temperature and pressure of the vapor are unstable, it affects the economic efficiency, the reason were the collecting dust on the heat area and serious corrision, they led to the decrease of the boiler load, and need stop to washing the dust, the article deals with the reform of the exhaust gas boiler, at the basic of the design condition, after thermo calculation, flute gas, resistence calculationand strenth calculation, the structure of the heat surface had been rearranged, then the proof calculation was done

    原設計產中壓蒸汽42噸時，但投運后只產30 - 35噸時，並且蒸汽溫度和壓力均不穩定，影響到經濟效益。其原因是受熱面積灰和腐蝕嚴重，影響傳熱使鍋爐負荷下降，不能長時間運行，需停產清理積灰。本論文針對此余熱鍋爐的技術改造，在給定設計條件基礎上，通過熱力計算，煙氣阻力計算和強度計算，對鍋爐受熱面結構重新布置，然後再作校核計算。
  7. The thesis also discusses the residual strength after slippage. based on this, the author establishes the analytics of load - settlement of super - long piles in homogeneous soil with the account of shaft resistance degradation and extends to layered soils

    根據工程實際測試結果，提出了發生樁土滑移的樁頂沉降的臨界值為0 . 01d 0 . 02d ，並對發生滑移后樁側土摩阻力殘余強度的確定進行了探討。
  8. Its main function is to complete heat exchange in technological process and reuse remaining heat, and its quality plays an important role in the investment in industrial process, power consumption and safe economic operation etc. as a new energy - saving equipment, the tubular heat exchanger with longitudinal flow of the shellside fluid ( thelfsf ) has many remarkable advantages

    其主要作用是完成工藝過程的熱量交換和余熱利用，其性能的優劣對工業過程的投資、能耗及安全經濟運行等起著重要作用。縱流殼程換熱設備作為新一代節能降耗設備，具有優良的防流體誘導振動性能、傳熱性能好、流體流動阻力小、抗結垢能力強、使用壽命長、重量輕、節約材料等顯著優點。
  9. In fundamental theory, adaptive optics, electrostatic actuation, flexure beam theory and squeeze film damping are researched ; in fabrication, bulk micro fabrication process and surface micro fabrication process are researched and compared, then the structure parameters and layout of a 8 x 8 micromirror array are designed using summit foundry ; in analysis, analytical and numerical method are used to perform static analysis, modal analysis, transient analysis, frequency analysis and to characterize the farfield performance of this 8x8 micromirror array. finally, in order to realize large scale micromirror array with lower snap down voltage, advices are given for further research

    在基本理論方面，通過對自適應光學，靜電力驅動，彈性梁理論和擠壓薄膜阻尼的研究，確定了微變形鏡的配置方案；在加工方面對體加工工藝， mumps工藝和summit工藝進行了研究與比較，並選用殘余應力小，表面質量好的summit工藝對8 8的微變形鏡陣列原型進行了結構設計與版圖設計；在分析方面主要對微變形鏡單元的靜態特性，模態特性，瞬態響應，頻率響應和8 8規模的微變形鏡陣列的遠場光學模型進行了研究，確定了微變形鏡的性能參數。
  10. Based on the comparative analysis of two available heat system plan, the paper selects the water - water heat pump system plan. after a series of character analysis, design calculation ; the style of compressor including media choosing and its circle dynamic calculation for the thermodynamic system is determined. besides this, based on some basic measure of thermodynamic analysis, the heat pump coefficient of performance is discussed ; the exergy analysis for the water - water heat plan is conducted ; the calculation formula of heat pump exergy efficiency is derived ; an optimal model for heat pump together with thermal machine is established and the main exchanger equipment in heat pump system including its resistance calculation is designed in details

    本文通過對兩種系統方案進行比較分析，確定了水環熱泵系統的基本方案，經過定性分析和設計計算，進行了壓縮機的選型、工質的選擇、熱力系統的循環計算等基本設計，同時應用熱力學分析的一些基本方法，討論了如何評價熱泵系統的性能系數，並對電廠循環水余熱回收熱泵系統進行了（火用）分析，得到了熱泵過程（火用）效率的計算公式，建立了熱泵?熱機聯合機組優化模型，還對熱泵系統的主要換熱設備進行了詳細的結構設計和阻力計算，最後對熱泵系統進行了技術經濟分析和評價。
分享友人
分享到 Line

分享到臉書