余隙 的英文怎麼說

中文拼音 []
余隙 英文
clearance space
  • : Ⅰ動詞(剩下) remain; leave: 9減4 余 5。 nine minus four is five ; four from nine leaves five ; i...
  • : 名詞1 (縫隙; 裂縫) crack; chink; crevice 2 (空閑) gap; interval 3 (漏洞; 機會) loophole; op...
  1. There is not much clearance for tall vehicles passing under this bridge.

    高大車輛在這橋下通過時沒有多大余隙
  2. Standard for safety for insulation coordination including clearances and creepage distances for electrical equipment

    電氣設備的包括余隙和爬電距離在內的絕緣配合的安全標準
  3. Railway applications - insulation coordination - basic requirements - clearances and creepage distances for all electrical and electronic equipment

    鐵路設施.絕緣協調.基本要求.所有電氣和電子設備的余隙距離和蠕變距離
  4. The variations in trace element contents and ratios may hold up a mirror to the lake - level fluctuations and climatic changes, which, in turn, have exerted a direct and important effect on the sequence stratigraphic development. collectively, the reservoir rocks from the yanchang formation consist dominantly of the delta front subfacies subaqueous distributary channel and channel - mouth bar microfacies and delta plain subfacies subaerial distributary channel microfacies fine - grained feldspar sandstones and siltstones. the reservoir rocks have been subjected to three stages of diagenetic and porosity evolution : ( 1 ) the porosity reduction by the mechanical compaction and chemical pressure solution during the early diagenetic stage ; ( 2 ) the porosity increase by the dissolution during the a substage of the late diagenetic stage, and ( 3 ) the porosity reduction by the cementation and filling during the b substage of the late diagenetic stage

    系統的儲層特徵研究表明,該區延長組儲層成因類型主要為三角洲前緣水下分流河道、河口砂壩及三角洲平原水上分流河道微相細粒長石砂巖、粉砂巖;儲層巖石經歷了壓實,膠結,溶蝕等成巖作用,歷經早成巖機械壓實和化學壓溶孔縮小期、晚成巖a亞期溶蝕作用孔擴大期及晚成巖a亞期( b亞期)膠結充填孔縮小期三個成巖-孔演化階段;儲層物性總體上具有較低孔滲、低孔滲的特點,孔類型主要為粒間溶孔、殘粒間孔、粒內溶孔、晶間孔及晶間溶孔,裂縫不發育,儲集巖排驅壓力和中值壓力較高,孔結構類型以細小孔-微孔,微細喉-微喉型為主。
  5. During the process of measuring compression ratio, the viscous fluid instead of burning gas is applied to measure the maximal volume. residual volume and working volume of the engine combustion cylinder respectively

    在壓縮比測量裝置中,採用粘性液體,代替發動機工作燃氣,分別測量出發動機燃燒工作室的最大容積、余隙容積和工作容積,方便地計算出發動機的壓縮比。
  6. Railway applications - insulation coordination - part 1 : basic requirements - clearances and creepage distances for all electrical and electronic equipment

    鐵路設施.絕緣協調.第1部分:基本要求.所有電氣和電子設備的余隙距離和漏電距離
  7. Insulation coordination for equipment within low - voltage systems - a comprehensive method for determining clearances and creepage distances equal to or less than 2 mm

    低壓系統內設備的絕緣配合.等於或低於2mm的余隙距離和漏電距離的綜合測定法
  8. Not only does it study the plasma characteristics of the arcing and after - arcing between contacts, but also its diffusion to outside of the contacts and its effect on the arc shield. for the first time, it proves the non - stability of the plasma diffusion of after - arcing by experiments

    同時,分析了燃弧和弧后觸頭間等離子體的特性,探討了它向觸頭間外的擴散及對屏蔽罩的作用效果,用實驗證明真空滅弧室弧后殘等離子體消散的不穩定性。
  9. Moreover, it was found that the microstructure and physical properties of dlc film were affected to some extent by the distance between target and substrate. when the distance between target and substrate increases, sp 3c content in the deposited dlc film decreases. accordingly, the value of surface roughness, microhardness, friction coefficient, residual stress and band gap became lower in the same way

    此外,靶基距對dlc薄膜的結構和性能也有一定的影響,隨著靶基距增加, dlc薄膜中的sp ~ 3c含量減少, dlc薄膜的表面粗糙度降低,顯微硬度降低,摩擦系數減小,殘應力減小,光學帶eg減小。
  10. It is found that the microstructure and properties of as - deposited dlc films is seriously dependent on the substrate temperature used in deposition processes. with the increase of substrate temperature, sp 3c content in the deposited dlc film decreases, surface roughness and friction coefficient of deposited dlc films increase. at the same time, microhardness, residual stress and optical band gap became lower

    研究發現,基片溫度對dlc薄膜的結構和性能影響最明顯,隨著薄膜沉積過程中基片溫度的增加, dlc薄膜中的sp ~ 3c含量減少, dlc薄膜的表面粗糙度增加, dlc薄膜的顯微硬度降低, dlc薄膜的摩擦系數增大, dlc薄膜的殘應力都是減小的,光學帶eg變窄。
  11. Among them, the equal - channel angular pressing ( ecap ) technique has been proved to be an effective method for the fabrication of various bulk ufg materials without residual porosity

    在目前通過強烈塑性變形制備超細晶材料的幾種方法中, ecap變形法已經證明是制備無殘塊狀超細晶材料的有效方法。
  12. With the established dynamic pore pressure model, the calculated results of total stress method and effective stress method are compared. consolidation settlement induced by dispersion of residual pore pressure is calculated, and the effect of pore pressure on pavement settlement is discussed

    採用本文建立的軟土地基動孔壓模型,對比分析了不排水有效應力法和總應力法計算結果,計算了殘水壓力消散所產生的固結沉降,探討了孔壓對道路變形的影響。
  13. Residual pore water pressure

    水壓力
  14. A lot of diagenetic dolostones have remainder granulation structure, and the native rock of it may be various intraclast limestone. this type of rock usually has high primary porosity. the high primary porosity is the important base of forming the pore of dolostone reservoir

    一部分成巖白雲巖仍具有殘粒屑結構,其原巖可能主要為各種類型的粒屑灰巖,這類巖石通常具有較高的初始孔度(原生孔度) ,這是以後形成成巖白雲巖儲層孔的重要基礎條件。
  15. Cylinder clearance volume

    氣缸余隙容積
  16. Experimental study on effect of clearance volume on performance of rotary compressor

    余隙容積對滾動轉子式壓縮機性能影響的試驗研究
  17. Insulation coordination for equipment within low - voltage systems - part 5 : a comprehensive method for determining clearances and creepage distances equal to or less than 2 mm

    低壓系統內設備的絕緣配合.第5部分:等於或低於2mm的余隙距離和漏電距離的綜合測定法
分享友人