供油系統 的英文怎麼說

中文拼音 [gōngyóuxìtǒng]
供油系統 英文
oil feeding system
  • 供 : 供Ⅰ名詞1 （供品） offerings 2 （口供; 供詞） confession; deposition Ⅱ動詞1 （供奉） lay （offerin...
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 統 : Ⅰ名詞1 （事物間連續的關系） interconnected system 2 （衣服等的筒狀部分） any tube shaped part of ...
  • 系統 : 1. （按一定關系組成的同類事物） system 2. （有條理的;有系統的） systematic
  1. Design of a vehicular gas turbine fuel system

    車用燃氣輪機的供油系統設計
  2. Installations for oil supply systems for oil burners - part 2 : safety requirements and tests : parts, valves, pipes, filters, oil de - aerators, meters

    燃油鍋爐供油系統的安裝.第2部分:安全性要求和試驗.零件閥門，管道過濾器油排氣器和儀表
  3. For further product information to the topic fuel system components, please contact gkf " qualitas "

    以自己高精確度著稱的企業gkf " qualitas "是一家製造燃料系統構件、供油系統構件的現代化的、靈活的商務夥伴。
  4. The insurer pay for fire cause by default of electrical wires, energy supply fault of the vehicle itself ; this insurance does not cover for fire cause by outer hazards

    負責賠償保險車輛因本車電器、線路、供油系統發生故障及運載貨物自身原因起火燃燒，造成保險車輛的損失；而由於外界火災導致車輛著火的，不屬于自燃損失險責任范圍。 。
  5. However, many of those studies focused on the structures of bearing itself. and few studies have been done on the gas cavity caused by the decrease of oil - pressure in the oiling system, which influences bearing

    但是大多數研究都集中在軸承結構本身，對供油系統中由於供油壓力變化而造成油腔中出現氣穴現象對軸承特性影響的研究較少。
  6. Manufacture and test of common oil supply system for synthetic gas compressor unit and ammonia compressor unit

    氨壓縮機組共用供油系統的製造與實驗
  7. Installations for oil supply systems for oil burners - safety requirements and tests - parts, valves, pipes, filters, oil de - aerators, meters

    油燃燒器供油系統的安裝.安全性要求和試驗.部件閥門管道過濾器油空氣分離器油量計
  8. Control system ' s features of supercritical steam turbine made in domestic with 600mw grade capacity was analyzed and compared in this paper from following aspects : regulating mode ， admission machanism ， deh system and oil supply system

    本文從調節方式、配汽機構、 deh及供油系統等幾個方面，分析比較國產超臨界汽輪機調節系統的特點。
  9. Installations for oil supply systems for oil burners - part 1 : safety requirements and tests : parts, oil feed pumps, control and safety devices, supply tanks

    燃油鍋爐供油系統的安裝.第1部分:安全性要求和試驗.部件加油泵控制和安全裝置，供油罐
  10. Research on effects of fuel supply system parameters to emissions of turbo - charged diesel engine

    供油系統參數對增壓柴油機排放的影響規律
  11. Installations for oil supply systems for oil burners - safety requirements and tests - parts, oil feed pumps, control and safety devices, supply tanks

    油燃燒器供油系統的安裝.安全性要求和試驗.零部件供油泵控制和安全裝置供油罐
  12. Installations for oil supply systems for oil burners - part 1 : safety requirements and tests ; parts, oil feed pumps, control and safety devices, supply tanks ; german version en 12514 - 1 : 2000

    油燃燒器供油系統的安裝.第1部分:部件供油泵控制
  13. In this paper, a matching platform for a model lh150 four stroke motorcycle engine is set up and a electronic fuel injection system is designed. the design of the electronic fuel injection system include the fuel supply system design, the intake pipe and throttle body design, the electronic control unit ( ecu ) develop, the way to use sensor of the system and the means to deal with sensor signal

    本論文建立了一套針對lh150型四沖程摩托車發動機的匹配臺架，設計了一套用於摩托車發動機的電控燃油噴射系統，對發動機供油系統、進氣系統進行了設計和選配；建立了一套傳感器的使用和信號處理方法；設計了一套電控單元硬體，並初步確定了電控單元的控制方法。
  14. Installations for oil supply systems for oil burners - part 2 : safety requirements and tests ; parts, valves pipes, filters, oil de - aerators, meters ; german version en 12514 - 2 : 2000

    油燃燒器供油系統的安裝.第1部分:安全要求和試驗.部
  15. This test - bed is made of five part, oil supplying system, oil heating system, specimen constant temperature system, position control system and loading system

    該試驗臺共有五個部分，包括供油系統、油液加熱系統、試件恆溫系統、位置控制系統和液壓伺服加載系統。
  16. Afs auxiliary fuel supply system

    輔助供油系統
  17. This thesis focused on the pressure control problem of apron - hydrant - system in modern airport. implied with expert theory, intelligent pid was used to solve pressure control problem, and statistics method was innovatively used in parameter optimizing process. with the practice in realization, the expert pid control policy and parameter optimizing method introduced in this thesis turned out successful

    論文介紹了機坪自動供油系統中的管線壓力控制問題，針對供油管線中的時滯、干擾問題提出了應用專家思想的智能pid控制策略，在控制參數的尋優過程中創新性地應用數理統計的方法來權衡各組參數控制指標的優劣，通過模擬與實施證明了控制策略和參數整定方法的優越性。
  18. The contents are as followed : 1. to make an analysis of how the components of bearing influence the stability of oil pressure

    具體工作內容如下： 1分析供油系統諸元件對供油壓力的影響。
  19. Research on the vertical fairness and progressien of health financing

    改善渦流室柴油機供油系統和利用廢氣再循環降低排放研究
  20. Spraying circulation is adopted to lubricate the gears, reducing noise and prolonging the service life

    齒輪傳動採用噴淋式循環潤滑供油系統，降低噪音，增加齒輪工作壽命。
分享友人
分享到 Line

分享到臉書