傾斜面板 的英文怎麼說

中文拼音 [qīngxiémiànbǎn]
傾斜面板 英文
sloping desk
  • 斜 : 形容詞（跟平面或直線既不平行也不垂直的） oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 面板 : [機械工程] face plate; panel; panel board; frontpanel; face ply [veneer]; surface veneer; skin pl...
  1. For hoods with shutters in four sides, the results show : 1 ) the hoods positively placed boards are called hoods used for venting airflow ; hoods negatively placed boards are called hoods used for leading airflow ; 2 ) among the hoods used for venting airflow, the most effective hoods should have positive declining angle value of 30, the ratio 4 of areas between the four windward faces and the gular section ( fy / fj = 4 ), the value of b range from 70 mm to 120 mm and the value of b / h range from 0. 5 to 0. 6 ; 3 ) the most effective hoods should have negative declining angle value of 60, the ratio 4 of areas between the four windward faces and the gular section ( fy / fj = 4 ), the value of b range from 100 mm to 170 mm ( the optimum value is 120 mm ) and the value of b / h range from 1. 4 to 2. 2 ( the optimum value is 2. 0 )

    對於四面設百葉型風帽，計算表明: l ）正裝傾斜擋板的百葉型風帽可認為是排風型風帽，倒裝擋板傾斜的百葉型風帽可認為是進風型風帽; 2 ）排風型風帽中，擋板正裝30 」 、風帽四個迎風面的有效面積fy和風管凈斷面積fj的比值（ fy腸）為4 、擋板寬度b在70inln到120inln之間、板間距比值隴在0 . 5到0 . 6的百葉型風帽排風效果最好; 3 ）進風型風帽中，擋板倒裝裝60 「 、風帽四個迎風面的有效面積和風管凈斷面積的比值（ fy例）為4 、擋板寬度b在100咖到170mm之間（ 120mm為最佳） 、板間距比值隴在1 . 4到2 . 0的進風型風帽（ b爪= 2 . 0為最佳）的百葉型風帽進效果最好。
  2. What little space there was below the sloping ceiling was as closely covered with pictures as an italian votive chapel

    傾斜的天花板下面那一點點空間，如同義大利還願禮拜堂那樣密密地貼滿了圖畫。
  3. However, when extremely high oblique impacts occurred ( 55 degrees or more ), as on turret roofs and decks, face - hardened armor, due to its brittleness, was a very poor choice since it could break and throw pieces into the region behind it even if the shell glanced off

    然而當炮彈以極大的彈著傾斜角（ 55度或以上）擊中炮塔頂部和甲板時，由於裝甲的脆性，即便炮彈只是擦過，裝甲的背面也會破碎飛散，這時表面硬化裝甲便是個拙劣的選擇了。
  4. This then allows the lower plate lug to make contact of its two corners with the slanting walls of "v" groove.

    這便於下面的極板年的兩角與「V」字形溝槽的兩個傾斜的壁相接觸。
  5. An upper section, often with a sloping floor, projecting from the rear or side walls of a theater or an auditorium to provide additional seating

    邊座，樓座劇院或大禮堂中為了增加座席，而從後面或側墻突出的具有傾斜地板的上面部分
  6. Its mast can be installed in inclination according to the requirement of construction the angle between the axis of mast and vertical line should be 10, while the floor of cage always remains level

    該系列升降機無對重，導架按施工需要而傾斜安裝導架軸線與鉛垂線夾角10 ，但吊籠地板始終與水平面平行。
  7. The udaloy has two helicopter hangars with doors that serve as a ramp to the flight deck. the udaloys air - defense system consists of 8 klinok launchers, and the ak - 630 and ak - 100 gun mounts

    勇敢級則擁有兩個帶有傾斜機庫門的直升機庫和寬敞的直升機甲板，防空系統方面則裝備了8套sa - n - 11導彈發射裝置， ak - 630近防炮和ak - 100高平兩用炮。
  8. The crusher of our company will fix toothed segment, is bevel, campaign toothed segment is regular surface, when crusher works, campaign toothed segment does not produce, promote the force of stone material upward, so when solving conventional crusher work the problem that falls out on stone material, therefore the crusher of our production of company has the stone material broken rate that is strong character of service high, stone material breakage is even, machinery has continuously, avoids since stone falls out on material, and additional manpower labor raises daily out put, ensure safety first a series of characteristic

    我公司研製的破碎機，將固定齒板定為傾斜面，活動齒板定為長垂直面，在破碎機工作時，活動齒板不產生向上推動石料的力，從而解決常規破碎機工作時石料上翻的問題，因此，我公司研製生產的破碎機有「石料破碎率高，石料破碎均勻，機械連續工作性能強，避免因石料上翻而附加入力勞動，提高日產量，確保安全生產」等一系列特點。
  9. The point of this test was to find out if unfolding the aluminum foils wrapping the backs of the aerogel tiles would tilt or distort the aerogel significantly

    此項試驗的目的是查明打開包裹在凝膠塊背面的鋁襯板是否會對凝膠塊造成顯著的扭曲或傾斜。
  10. This was much less likely with soft homogeneous armor that could dent and tear slowly, easing the shell away and staying more intact, with few pieces torn off

    然而當炮彈以極大的彈著傾斜角（ 55度或以上）擊中炮塔頂部和甲板時，由於裝甲的脆性，即便炮彈只是擦過，裝甲的背面也會破碎飛散，這時表面硬化裝甲便是個拙劣的選擇了。
  11. With the help of this program, this paper does research on the moved backwards of the slide surface, lengthening the anchor section, the soil nail ' s total force, gets conclusion about relations between the soil nail ' s length and the slope ' s grade, height, soil ' s mechanical parameter ; relations between soil nail ' s total force and coulomb soil pressure. with the help of the large multiuse finite element program ansys, this paper analyzes the soil nailing in one - step ' s slopes, in two - steps " slopes, puts the emphasis on the axis force ' s distributing along the soil nail at each rows, the effect of both the excavating mode and the original slope figure to the axis force of the soil nail, the one another effect between the upper - step slope and the nether - step slope in the soil nail ' s axis force, gets conclusion about the design of soil nail at the first low, different slope body is the same with different excavating mode, the original slope figure has more effect to some than others because of the slope body, the reasonably design of the step width in two - steps slopes, the two - steps excavating and retaining has more virtue than the one - step ' s. through soil pressure analysis this paper does research on the differences and the links between the coulomb soil pressure theory and the rankin ' s, the vertical pressure at the slope surface when the slope surface is inclined and the retaining wall is rough, the soil pressure ' s distributing behind the panel, gets conclusion about the effect of both the slope body inner stability and the slope surface local stability to the soil pressure

    通過分析比較，論證了對數螺旋線型比圓弧形作為邊坡的假設滑裂面具有較多的工程優點，並為此編制了一個採用極限平衡法分析土釘支護的fortran語言程序，以此作工具對滑裂面的后移、土釘錨固段的超長、土釘總力的大小等方面作了研究，得出了有關土釘的長度與邊坡的坡角、坡高、土體力學參數的關系、土釘總力與庫侖土壓力間的關系等結論；採用大型通用有限元數值分析程序ansys分別對採用土釘支護的一階邊坡、二階邊坡進行分析，重點是研究各排土釘的軸力分佈規律、開挖方式及原始邊坡形態對土釘的軸力的影響、上下階邊坡在土釘軸力方面的相互作用，得出了有關第一排土釘的設計問題、不同類型的土體應適用於特定的開挖方式、原始開挖出的邊坡形態對一些類型坡體的邊坡土釘支護有較大的影響而對另外一些影響不大、二階邊坡臺階寬度的合理確定、二階開挖及支護比一階時具有較多的工程優點等結論；通過土壓力分析對朗肯、庫侖兩種經典土壓力理論的區別與聯系、坡面傾斜及墻背有摩擦時的坡面豎向應力分佈、面板背土壓力的分佈形態作了研究，得出了邊坡支擋土壓力受坡體內部穩定與坡面局部穩定兩個方面的影響、土釘支護面板背土體中卸荷拱的存在對面板受力有利等結論。
  12. Testing methods of floor compressibilities for coal mining face under conditions of gently inclined seam

    緩傾斜煤層採煤工作面底板抗壓入特性測定方法
  13. In this paper, several moulding boards are used to restrict the uneven plane in the practical measurement. the error caused by the lean of part plane is conquered and the precision of measurement is improved

    文中利用多個模板對實際測量中不平整的待測平面進行了約束，克服了由平面局部傾斜帶來的誤差，提高了實際平面測量的精度。
  14. This then allows the lower plate lug to make contact of its two corners with the slanting walls of " v " groove

    這便於下面的極板年的兩角與「 v 」字形溝槽的兩個傾斜的壁相接觸。
  15. Talking about the roof management at slope thick seam blast mining surface

    淺談傾斜厚煤層炮采工作面的頂板管理
  16. In order to study basic roof ' s destruction movement that affects working face in horizontal section top coal caving in mining steep seams, this paper analyses tension of roof using elastic and thin board theory and concludes criterion of roof destruction based on long and narrow thin board

    摘要為研究急斜煤層水平分段放頂煤開采過程中基本頂破壞活動對工作面的影響，根據急斜煤層基本頂具有傾斜狹長板的特點，運用彈性薄板理論對基本頂巖層進行了拉應力分析，得出了頂板破斷的判別準則，建立了基本頂初次破斷后形成的「鉸接結構」的力學模型。
  17. In order to study the basic roof ' s destruction movement that affects working face in horizontal section top coal caving in mining steep seams, this paper analyses tension of roof using elastic and thin board theory and obtains criterion of roof destruction based on long and narrow thin board

    摘要為研究急斜煤層水平分段放頂煤開采過程中基本頂破壞活動對工作面的影響，根據急斜煤層基本頂具有傾斜狹長板的特點，運用彈性薄板理論對基本頂巖層進行了拉應力分析，得出了頂板破斷的判別準則，建立了基本頂初次破斷后形成的「鉸接結構」的力學模型。
  18. With two structures of bore cylindrical or tapered and retainers made of steel sheet or synthetic resins, the bearings are characteristic of their spherically formed outer ring raceways allowing for misalignment within 3 degree deflection between inner ring and outer ring, so as to compensate concentricity and deflection errors

    詳細信息:調心球軸承由圓柱孔和圓錐孔兩種結構，保持架的材質有鋼板、合成樹脂等，其特點是外圈滾道成球面形，具有自動調心性，可以補償不同心度和軸撓度造成的誤差，但其內、外圈相對傾斜度不得超過3度。
分享友人
分享到 Line

分享到臉書