冪律流動 的英文怎麼說

中文拼音 [mìlǜliúdòng]
冪律流動 英文
power-law flow
  • 冪 : Ⅰ名詞1. [書面語] （覆蓋東西的巾） cloth cover2. [數學] （表示一個數自乘若干次的形式） power Ⅱ動詞[書面語] （覆蓋; 罩） cover with cloth
  • 律 : Ⅰ名1 （法律; 規則） law; rule; statute; regulation 2 （律詩的簡稱） short for lüshi 3 （姓氏） a ...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 流動 : 1. （液體或氣體移動） flow; run; circulate 2. （經常變換位置） going from place to place; on the move; mobile
  1. When two spheres with an interstitial herschel - bulkley fluid translate normally, the velocity and the squeeze force distributions are investigated. it is shown that the solution of the squeeze force can reduced to the bingham and power - law fluid cases, respectively. 6

    研究了存在填隙herschel - bulkley流體時兩球法向運動時的擠壓力，並且證明了法向擠壓力的解分別可以退回到賓漢流體或冪律流體情形。
  2. According to the principle of mutual transformation between potential energy and kinetic energy, the vertically falling law of power law fluid by the action of unconstant static pressure and the relation between rheological parameter and time were studied, thus providing a theoretical basis for calculating the rheological parameters of fluid in funnel viscometer

    根據位能與動能的變化關系，作者研究了在非恆定靜壓作用下冪律流體垂直下落的規律及流變參數與時間的關系，從而為計算漏斗粘度計中流體的流變參數提供了理論依據。
  3. On the basis of experiment, by using the exponential viscous model, a flow constitution equation of the pattern material ( w ax stock ) used in investment casting has been established. by applying it to the n umeric al simulation system, the numerical simulation on die - filling process of the fus ible pattern material ( wax stock ) used in investment casting has been successfully realized

    在實驗基礎上，採用冪律粘度模型建立了熔模鑄造用模料的流動本構方程，將其應用到數值模擬系統中，成功地實現了對熔模鑄造用模料充型過程的數值模擬。
  4. In the first part, turbulent motion in convection zone as source to generate alfven waves is studied following lighthill - stein theory, in which the turbulent source was described by nonlinear terms in mhd equations

    就是將mhd方程中的非線性項通過fourier變換轉化為湍動源項，並採用kolmogroff冪律譜來描述對流層的湍動譜。
  5. Numerical simulation of three dimensiona isothermal power - law polymer melt flow within an extrusion die with the quot; l quot; shaped cross section

    型異型材擠出口模內聚合物熔體三維等溫冪律流動的數值模擬
  6. With increasing viscosity, the velocities of power law fluid and particle showed the same trend

    隨著稠度系數的增加，冪律流體和顆粒相的主流速度分佈出現了與流動指數帶來的影響相似的趨勢。
  7. The characteristics of power law fluid governing equation was elaborated and the effect of viscosity and flow exponent on two - phase flow was studied

    摘要闡述了冪律流體控制方程的特點，研究了冪律流體的稠度系數和流動指數的變化對兩相流動的影響。
  8. With increasing flow exponent, the velocity of power law fluid near the pipe center decreased, and the velocity of particle near the pipe center increased but decreased near the pipe wall

    隨著流動指數的增加，冪律流體在圓管中心附近的主流速度減小，同時顆粒相速度在圓管中心附近增大，而在管壁附近減小。
  9. Numerical simulation on power - law fluid flow in helical pipes with circular cross - section

    螺旋管道內冪律流體流動數值模擬
  10. In order to study the stability of non - newtonian fluid and its flow pattern discrimination method, the integral stability theory and local stability theory are applied to the concentric annulus flowing of plastic fluid and power - law fluid, then a relevant stability parameter expression of discriminating flow pattern is derived and set up in the paper

    摘要針對非牛頓流體的穩定性問題及其流態判別的研究，將整體穩定性理論及局部穩定性理論應用於塑性流體和冪律流體在同心環空的流動中，建立和推導出相對應的判別流動狀態的穩定性參數表達式。
  11. Normal stress distribution on the inner cylinder forced by power law fluid flowing in annulus with inner cylinder executing a planetary motion

    冪律流體在內管做行星運動的環空中流動時的內管法向應力分佈
  12. The character of pseudothermal temperature equation is expounded ; numerical computation of two phase flow of power law fluid in different kind of pump impeller blade and under the influence of its material parameters ( viscosity and flow exponent ) has been performed

    摘要詳細闡述了顆粒擬溫度方程，計算了不同型線的葉輪及改變冪律流體物性參數對湍流流動的影響。
  13. It was found be compared the two - phase flow of power law fluid - solid with that of liquid - solid that the fluid velocity of power law fluid - solid was bigger than that of liquid - solid and the particle velocity distribution of power law fluid - solid was flatter than that of liquid - solid

    對帶顆粒的冪律流體的兩相流流動與液固兩相流流動做了比較，冪律流體兩相流的流體速度在管道中心附近的大部分區域比液固兩相流的流體速度流動的速度大，而顆粒相的速度分佈比較平坦。
  14. Viscous force of squeeze flow between two spherical particles with power - law fluid

    圓球顆粒間有冪律流體時擠壓流動的法向粘性力
  15. Numerical simulation of three dimensional isothermal power - law polymer melt flow within a rectangular convergent channel

    矩形收斂流道內聚合物熔體三維等溫冪律流動的數值模擬
分享友人
分享到 Line

分享到臉書