劑量增大系數 的英文怎麼說

中文拼音 [jìliángzēngdàxìshǔ]
劑量增大系數 英文
dose enhancement factor
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 劑量 : [物理學] [醫學] dosage; dose; dosis劑量槽 dosage bunker; 劑量測定（法） dosimetry; health work; ...
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. Finally, we can not use electric power but the engine of bus or subsidiary engine to drive air compressors of bus air conditions. because the change range of turnaround speed of engine is very wide, that brings difficulties in controlling the rate of flow of cold - producing medium. in the control of bus air - conditions, preventing evaporator from freezing to make the air - conditions work with high efficiency and controlling the temperature of railway carriage are the basic tasks in air - condition control

    與一般的建築空調相比，汽車空調的工作環境惡劣，條件差，控制難度要增加很多，主要體現在以下幾個方面：一是車外熱負荷變化大，難以確定控制參數；二是要求空調負荷大，而且要控制空調使其降溫迅速：三，不便於用電力作為動力源，必須用汽車發動機或輔助發動機來帶動壓縮機，當採用汽車發動機作為動力源時，由於汽車的車速變化大，發動機轉速的變化可從600r min到4000r min ，壓縮機轉速與發動機轉速成正比，其轉速變化高達7倍，給空調系統製冷劑流量控制帶來困難。
  2. Eev should be selected for various refrigeration systems according to the thermal properties of refrigerants ; the discharge coefficient of eev is sensitive to the aperture and impulse quantity of eev ; when the eev structure is made, the discharge coefficient goes up with the lowering of evaporation temperature or goes down with the hoisting of the condensation temperature. it is le

    對于不同工質的冷藏集裝箱製冷系統，電子膨脹閥應該根據具體製冷劑的熱力性質選取；電子膨脹閥流量系數對孔徑和脈沖數比較敏感；在結構固定時，流量系數隨蒸發溫度的降低而升高，隨冷凝溫度的增加而增大，受過冷度變化的影響較小；電子膨脹閥的容量受孔徑影響最大。
  3. The hot - dip - depth and temperature difference between fluid and platelet wall are influenced by many factors, such as the coefficient of heat conductivity of platelet and fluid, the coolant fluid, the knudsen number, and so on. high temperature make kn number become bigger, and then microscale effects become notable

    3 、熱浸深度、流體與層板壁面的溫差大小要受層板的導熱系數、冷卻劑流量及流動的kn數等因素的影響。高溫條件使kn數增大，微尺度效應增強;而高壓條件下kn數減小，微尺度效應減弱。
分享友人
分享到 Line

分享到臉書