力學性能試驗 的英文怎麼說

中文拼音 [lìxuéxìngnéngshìyàn]
力學性能試驗 英文
test of mechanical property
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 學 : Ⅰ動詞1 （學習） study; learn 2 （模仿） imitate; mimic Ⅱ名詞1 （學問） learning; knowledge 2 （學...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 能 : 能名詞（姓氏） a surname
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. Test method for mechanical property of aerated concrete

    加氣混凝土力學性能試驗方法
  2. Mechanical performance experimentation of expansile - soil - amended - by - lime and construction way of commingle

    石灰改良膨脹土力學性能試驗
  3. This paper described the plc application in the pneumatic - electrical control of the test of swivel chair mechanical property

    介紹了可編程式控制制器在轉椅力學性能試驗機的氣-電控制系統中的應用。
  4. Study to the mechanical property testing of the tensioning band saw blades

    適張帶鋸條的力學性能試驗研究
  5. Otherwise, the tests of basic mechanical properties shows that block strength affects bearing strength of masonry and mortar strength decides shear resistance, block strength is greater than the masonry, the compressive and shear of two - rows masonry is greater than one - rows. the paper also elementary analyze the composite walls with ansys on seismic behavior out - of - plane

    此外，基本力學性能試驗表明:砌塊強度決定砌塊砌體的抗壓強度，砂漿強度決定其抗剪強度;雙排孔砌塊砌體的抗壓和抗剪強度均大於單排孔砌塊;單體砌塊抗壓強度高於砌塊砌體抗壓強度。
  6. The failure of evaporate - self vessel was analyzed by means of chemical composition analysis, mechanical property testing, ctod determination, micrographic and sem inspection

    摘要採用化學成分分析、力學性能試驗、宏微觀檢驗等方法對自蒸發器材質和裂紋成因進行了分析。
  7. The major performances of concrete and mortars, which are mixed with different quantities of expansion admixtures under the same mix proportions, are studied systematically and deeply in this work. sulphoaluminate mixed with a type of new expanding component by use of the composite methods are studied in the laboratory, and some achievements have been obtained. the service conditions, the characteristics and the shortcomings of expansion admixture in the concrete engineering are analyzed and summarized based on literatures, and the expanding mechanism of concrete is discussed

    本文試圖從膨脹劑不同摻量研究其對混凝土和砂漿主要性能的影響，進行了一系列宏觀力學性能試驗研究；利用差熱分析（ dta ） 、掃描電子顯微鏡（ sem ）等分析手段對鈣礬石等水化產物的結晶和生成量、形貌特徵進行微觀分析；並採用復合方法摻加新型膨脹組分對硫鋁酸鹽類膨脹劑（ uea ）進行了改性試驗研究，根據多因素模糊綜合評價方法就各類膨脹劑的主要性能進行綜合評價，得出摻加新型膨脹組分pt的膨脹劑性能較優，取得了明顯的效果。
  8. Methods for testing the mechanical properties of grey cast iron

    灰鑄鐵.力學性能試驗方法
  9. Guide rule of test for mechanical

    纖維增強塑料高低溫力學性能試驗準則
  10. Guide rule of test for mechanical properties of fiber - reinforced plastics at elevated and reduced temperatures

    纖維增強塑料高低溫力學性能試驗準則
  11. The 3 batches with 7 groups of prism concrete test specimens and the 3 batches with 22 groups of cube ones were used in mechanical properties test, and a series of parameters of rpc was acquired such as prismatic strength, the cubic strength, split and pull strength, deformation module, peak strain, poisson ' s ratio

    進行三批7組稜柱體試件和三批22組立方體試件的力學性能試驗，測定了rpc200稜柱體抗壓強度、立方體強度、劈拉強度、彈性模量、峰值應變、泊松比等參數，並建立了變形模量和峰值應變的擬合公式。
  12. Test methods for physical and mechanical properties of finger - jointed lumber

    指接材物理力學性能試驗方法
  13. Test methods of mechanical properties of mortar for ferrocement - bond test

    鋼絲網水泥用砂漿力學性能試驗方法粘結力試驗
  14. Experimental analysis and numerical simulation of mechanical behavior of glass curtain walls

    玻璃幕墻結構力學性能試驗分析與數值模擬
  15. Test method of mechanical properties of impermeable graphite materials - general

    不透性石墨材料力學性能試驗方法總則
  16. Cfrp laminae, cfrp wound nol rings and pressure vessels were manufactured, and different mechanical experiments and hydro - burst tests were performed

    制備了碳纖維單向板、碳纖維纏繞nol環、碳纖維纏繞壓力容器，進行了各項力學性能試驗與水壓爆破試驗。
  17. 4. the basic experiments were conducted to evaluate mechanical properties of stitched composite laminates and stitching foam - core sandwich, and the experimental results were presented

    通過常溫濕熱環境下縫紉復合材料層壓板以及縫紉泡沫夾層復合材料力學性能試驗，獲得了縫紉層壓板和縫紉泡沫夾層結構的部分力學性能參數。
  18. At the same time in this paper we analyze nonlinear behavior of masonry through finite element method program and obtain its load when the wall start to crack and when it destroy, the p - u curve and so on. a comparison has been made between the data obtained from the experiment and the calculated through finite element method program so that we can study the cause of crack. in this paper we use finite element method to study concrete ' s character to analyze masonry, satisfactory results have been attained

    因此本文在對灰砂磚砌體進行力學性能試驗的基礎上，分析其裂縫產生的破壞模式與開裂機理，並論述了將斷裂力學知識運用於研究砌體裂縫問題的可行性；同時，本文運用有限元方法對結構低周反復加載靜力試驗所做的灰砂磚墻片進行非線性分析計算，得出墻片的開裂荷載、極限荷載、 p ? u曲線，裂縫在墻體上的分佈等，與試驗所得數據對比，以便於研究裂縫的開裂機理，並將研究混凝土的有限元方法運用到對砌體的研究中，取得了較滿意的結果，為類似的試驗分析提供了一條新的思路。
  19. Research on mechanical properties and stiffness analysis of self - damping steel - plate - laminated - rubber - bearing - isolation support

    自阻尼疊層橡膠隔震支座力學性能試驗研究及剛度分析
  20. Test of mechanical properties of furniture - stability of storage units

    傢具力學性能試驗櫃類穩定性
分享友人
分享到 Line

分享到臉書