勻加速度 的英文怎麼說

中文拼音 [yúnjiā]
勻加速度 英文
uniform acceleration
  • : Ⅰ形容詞(均勻) even Ⅱ動詞1. (使均勻) even up; divide evenly 2. (分出一部分) spare
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  1. It starts from rest and falls vertically downward with uniform acceleration.

    它從靜止開始以勻加速度豎直下落。
  2. Best concentration of ions is 1. 5mol / l and dispersant pvp monomer 0. 8mol / l. spin - coating speed, which affected the quality of limn2o4 film greatly, was also studied. it demonstrated that smooth limn2o4 film without cracks could formed under 2000 rotates / min with the solution cion = 1. 5mol / l, cpvp = 0. 8mol / l, what ’ s more, fewest spin - coating times were needed at that speed

    實驗結果表明:採用離子總濃溶液為1 . 5mol / l ,聚乙烯吡咯烷酮單元濃為0 . 8mol / l的溶液旋轉塗覆時,轉在2000轉/分鐘時最佳,所得到的濕limn204薄膜平整光滑均熱后無龜裂現象。
  3. Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution

    在此基礎上模擬在冬夏兩季不同情況下,不同流對熱管空氣預熱器壁面溫的影響;然後對影響整個流場分佈的各種因素:包括分流板長、厚、偏離中心流道位置的偏離、飛灰濃、飛灰粒徑等因素進行數值模擬;最後提出在分流煙道轉彎處裝導流板,並模擬裝導流板后的流場分佈,得到下級空氣預熱器出口、熱管空氣預熱器進口處的斷面場分佈、濃場分佈,以論證裝導流板能達到流場均化的作用。
  4. Shotcrete - rock bolt support and concrete lining are important parts of timbering structures in modern tunnel construction, and there are also essentials for natm. the intensity difference of concrete is big because of the big randomicity at the aspects of material, metage of additive, mix round, ratio of water and lime, spray construct and water maintain

    由於噴射混凝土和二次襯砌在拌和料、外凝劑的稱量、拌以及水灰比的配比、在噴射作業及灑水養護上都存在著很大的隨機性,其強的差異也較大。
  5. From a numerical simulation on a practical possible mode : uniform acceleration - uniform speed - uniform deceleration, we obtain the relationship between the measurement error and the acceleration value

    運動為例,分析了測量誤差與之間的關系,模擬結果驗證了該方法的可行性。
  6. The moderate supersonic carbon added to the mold flux for ultra - low carbon steel is used to stay the melting speed as skeleton. then the mold flux coils have the good adiabatic, insulation and even flow property. at the same time it cause the carbon increase in the steel slabs and the operation of the ultra - low carbon is affected at last

    超低碳鋼連鑄結晶器用保護渣中,外中超碳黑作為骨架降低熔化,使保護渣具有良好的絕熱保溫性、均流動的潤滑性,但同時卻會引起鋼鑄坯的碳增量,最終影響超低碳鋼的成功操作。
  7. Adopted far infrared metal heating tube, fast heating and energy saving

    採用遠紅外線金屬電熱管熱、熱風循環,快、溫、省電。
  8. Increasing the cooling velocity and additions of nb and zr can refine the a - fe dendrites in as - cast alloys, decrease the amount of a - fe phase after homogenization treatment. as a result, the magnetic. properties were improved

    提高鑄錠的凝固及添nb和zr可以促進鑄態合金內- fe相的晶粒細化及均分佈,減少均后殘留的- fe相,提高均化的效率和質量,從而提高磁體的矯頑力。
  9. The x - ray diffraction, scanning electronic microscope and the squid were used to characterize the properties of the mgb2 core in mgb2 / fe tapes and wires. the effect of the proportion of mg, b and sic as well as the sintering parameters on the phase formation, microstructure and the critical current densities of mgb2 / fe tapes and wires was discussed in details. the results showed that the high purity of mgb2 core could be synthesized by both the traditional vacuum sintering and the sparking plasma sintering and the vacuum sintering environment restrained the oxidation of mg effectively

    相對于傳統真空燒結, sps燒結方式成相快、樣品晶粒細小均、 mgb2超導芯緻密性好、晶間連接優良,因而sps燒結樣品的臨界電流密明顯高於傳統真空燒結樣品,其中未摻雜的帶材樣品經過sps800 , 15分鐘燒結后,自場下的臨界電流密jc值在10k時達到8 . 64 105a / cm2 ,而且隨著測量溫和外磁場的增, sps燒結樣品的臨界電流密下降率比傳統真空燒結樣品緩慢,在20k ,自場時為5 . 97 105a / cm2 , 20k , 3t時,臨界電流密值仍大於104a / cm2 。
  10. Diamond ( diamond glass ) with a large polishing powder particles to the use and performance : ultrafine polishing powder particle size, particle size uniform, cut power and polishing speed, high - yield diamond, easily washable, is essential to the processing of diamond polishing materials

    信息描述:水鉆用大顆粒拋光粉的用途及性能:拋光粉粒超細,粒,削力強,拋光快,水鉆成品率高,易清洗,是水鉆工必不可少的拋光材料。
  11. Meanwhile, the fracture was accelerated due to the uneven surface hardness and the unreasonable distribution of the hardening layer on the crankshaft, and the bad lubrication condition in service

    同時軸左頸表面硬不均、淬硬層分佈不甚合理,工作過程中潤滑條件差,了曲軸的斷裂。
  12. By stirring water with the impeller, splash water to the air evenly and widely, strengthen the pond water ' s flowing circulation, make pond water dissolve into oxygen and death of fish, shrimp and eel, raise the breeding density, quicken the growth so to achieve high and stable yields

    通過葉輪攪水,把水均而彌散地潑向空間,強池水流動循環,使池水溶入氧而稀釋和排出有害物質,增水中的溶氧量,改善水質,防止魚蝦鰻浮頭死亡,提高養殖密生長,從而達到高產穩產。
  13. The results indicate that the regenerative ladle baking with high temperature air combustion techniquecan speed up ladle heating rate and increase the temperature uniformity of lining

    結果表明,採用助燃空氣煤氣雙預熱的蓄熱式燃燒技術能夠有效地提高鋼包的烘烤熱均性;氣體預熱溫越高,包襯終點溫越高,溫性也越好。
  14. In addition, there will be some asymmetrical condition for shelling ; if the shell speed is different, there will be crusting phenomenon and then damage precision of shell thickness

    另外一些覆膜砂還可能出現結殼厚不均的現象,如果結殼不同,將出現覆膜砂熱過程中的「起皮」現象從而破壞了結殼厚的準確性。
  15. According to thermal state similitude model experiment of the langya mountain hydropower station, we adopt different velocity of air ventilation and exclude air proportion of upriver and downriver, this paper contrast the air distribution of the dynamo floor on each method, and educe the best projects of arch crest supply air that adapt to langya mountain hydropower station ’ s dynamo floor : g = 17. 4 10 ~ 4m ~ 3 / h, 22 vents, d = 600mm, the scale of volume 1 : 3, t0 = 16. 9. it ’ s also thought that improved any side of volume can reduce its temperature. when study on the air supply of langya mountain hydropower station ’ s underground dynamo floor by cfd software, it proved that cfd software is correct when compare with model experiment. when arrange the number of 5 kinds of vents, it concluded that the number of vents 14 to 22, it can ’ t change velocity, in 36 to 40 can lead to reduction of velocity. when vent in 14 to 36, the parameter kt doesn ’ t change, when the number is as large as 36, kt reduces

    在此基礎上,模擬了5種風口布置方案和送風量的改變對發電機層溫場和場的影響,獲得了些可供參考的結論:在風量和送風不變的條件下,風口個數在( 14 ~ 22 )小范圍變化時,工作區平均風基本不變,大幅風口個數( 36 ~ 44 )就會導致工作區平均風的降低,風口數在14 ~ 36之間對工作區的溫不均系數影響不大,當風口數> 36時,溫不均系數隨著風口數的增多而變小,不均系數一直隨著風口數的增而減少;在風口布置和尺寸不變的情況下,送風量變化時,工作區平均溫隨送風量增大而降低,平均溫的降低量逐漸趨于減少,能量利用系數先是隨著送風量的增而增大,后隨送風量增而減少。
  16. There are two parts in this paper : firstly, a set of single doppler velocity models are presented for typical ambient windfields that include those of being uniform horizontally, macroscale convergence and divergence, which overlap warm and cold advection. which are marked by different signatures in the single doppler velocity field. the models proposed can help users identify useful information from the dopple velocity patterns

    本論文包括兩個部分:第一篇通過對典型風場的單多普勒天氣雷達徑向圖象進行模擬,典型風場包括水平均一致的風場、非均水平風場的大尺運動的輻合輻散風場以及大尺運動的輻合輻散風場與冷暖平流的迭等。
  17. The transformation of the platelike ? - alfesi to spherical a - alfesi during homogenization is markedly accelerated by the addition of minor mn and cr in al - mg - si alloy, as well as the recrystalization of alloys during hot extrusion has been inhibited, and ? " strengthening phase improved to precipitate in the process of aging

    合金鑄錠均化處理過程中,形成含mn 、 cr的第二相al ( mnfe ) si和al ( mncrfe ) si等,這些顆粒長棒狀的b - alfesi相向尺較小的粒狀的- alfesi相轉化,減少了粗大結晶相對合金性能的不利影響。
  18. In the next part, after verifying the simplified computational method of turbulence, the movement of fibers in turbulent pipe flow was simulated by 3 - d integral method and simplified computational method of turbulence. it was found that the fluctuation of turbulence caused random of fibers " orientation and its distribution became broader as the re numbers increased

    然後,在驗證了湍流的簡化方法的合理性后,利用三維分段計算方法和湍流簡化方法模擬了大量纖維粒子在管道湍流內的運動,得出的結果為:湍流的脈動導致了纖維的偏角趨于無序,且隨著re數的增,纖維偏角的分佈越來越趨于均
  19. The maximum transmission efficiency of two - stage three - ring gear reducer is 93 %, and the load distribution non - uniform coefficient is less than 1. 1, and its vibration acceleration is less than acceleration of ordinary three - ring gear reducer that has the same properties

    該兩級三環減器的傳動效率達93 %以上,載荷分配不均系數小於1 . 1 ,振動值也小於同等傳動能力的一般三環減器。
  20. It reveals that, for a target with constant acceleration, the return signal in doppler domain, which is obtained by range fft of intermediate frequency return signal of othr, can be approximated as a lfm signal, whose fm rate is related to acceleration

    機動目標回波分析結果表明:對于模型而言,高頻地波雷達的中頻回波信號經過距離維fft處理后在多普勒域可以近似為一個線性調頻信號,其調頻率與有關。
分享友人