匹配負載 的英文怎麼說
中文拼音 [pīpèifùzǎi]
匹配負載
英文
matched load- 匹 : Ⅰ動詞(比得上; 相當; 相配) be equal to; be a match for Ⅱ形容詞(單獨) lone Ⅲ量詞1. (用於馬、騾等) 2. (用於整卷的綢或布)
- 配 : Ⅰ動詞1 (兩性結合) join in marriage 2 (使動物交配) mate (animals) 3 (按適當的標準或比例加以...
- 負 : Ⅰ名詞1 (負擔) burden; load 2 (虧損) loss 3 (失敗) defeat Ⅱ動詞1 [書面語] (背) carry on th...
- 載 : 載Ⅰ名詞(年) year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
- 匹配 : 1. [書面語] (婚姻配合) mate; marry 2. [電學] matching
- 負載 : [電學] load
-
According to the operation condition, it is shown that the protector presented in this paper can duly follow the motor ' s load fluctuation and capitally match with motor ' s tolerance overload characteristic, thus it is valuable to be actually used
運行結果表明,本文所研製的單片機式熱保護電器能較好地動態跟蹤負載變化,其熱保護特性能較好地與電動機的允許過載特性相匹配,有一定的工程實用價值。And the basis of microstrip is recalled. after this, we analyzed and computed several microstrip resonators with ads, making impedance match between the resonator and impatt diode
然後利用ads軟體對幾種微帶諧振器進行了分析和計算,使雪崩二極體的負載阻抗與其匹配。( 3 ) it is known that load effect is not consistent with the section resistance incommon section continuous composite beam. a kind of composite beam with itsrational section size is suggested, which is consist of the t shape concrete beam andsteel girder. this kind of composite beam not only has enough carrying capacity, almost has same positive and negative resistance moment, but can decrease theamount of the steel
( 3 )分析可知連續組合梁的跨中、支座截面處荷載作用效應及截面抗力規律不匹配,本文提出了採用t形混凝土梁和工字鋼代替一般的混凝土板和工字鋼的組合梁截面形式,並給出了截面尺寸比例,能使正負截面抵抗矩接近,符合組合梁受力特徵,減少了材料用量,滿足承載力和剛度等要求。Thirdly, it simulated the pumping circuit & dividing circuit with the widely used software matlab / simulink. the displacement of the rod piston and the impact of hydraulic are analyzed in the different input flow ( frequency of pump ) and different reversing time. it found out the cause of hydraulic impact ( one - to - one incorrespondence between the response time of dividing circuit and the operation time of rod piston ), and gave some methods to weaken hydraulic impact. in the final part of the paper, the reliability of the theory analysis is further verified by the experiment of hydraulic system
首先在流變學原理的基礎上,深入分析混凝土在輸送管道內的流動狀態,得出混凝土泵的負載特性方程;然後根據功率鍵合圖的建模方法,建立泵送迴路和分配迴路的數學模型,並運用模擬軟體matlab simulink對泵送和分配迴路模型進行了模擬,分析了在不同的輸入流量(泵送頻率)和換向時間下,活塞桿的位移和系統的液壓沖擊情況,找到了引起液壓沖擊的根本原因(即分配迴路的響應時間(固定值)與活塞桿的運動時間(變化值)不相匹配) ,並提出了相應的改進方法。The exportation resistance of a device work device with what link after loading the resistance s the certain connections for should satisfying, in order to prevent mount to load the appearance produce the obvious influence. with each other connect to say to electronics equipments, for example after signal connect the enlarger, ex - class to connect class, only behind first - degree importation resistance before larger than first - degree exportation resistance 5 - 10 times are above, can think the resistance to match good ; connect the box come saying, electronics tube the machine should choose to use with for the enlarger its output to carry the mark to call the resistance the box for, but transistor enlarger then have noing this restrict, can take officing why resistance of equal or approximate box
一件器材的輸出阻抗和所連接的負載阻抗之間所應滿足的某種關系,以免接上負載后對器材本身的工作狀態產生明顯的影響。對電子設備互連來說,例如信號源連放大器,前級連后級,只要后一級的輸入阻抗大於前一級的輸出阻抗5 - 10倍以上,就可認為阻抗匹配良好對于放大器連接音箱來說,電子管機應選用與其輸出端標稱阻抗相等或接近的音箱,而晶體管放大器則無此限制,可以接任何阻抗的音箱。3 > the power - load matching control of pump and diesel is also investigated in this paper, which includes economic working control and load limit control of diesel
3 、對液壓泵與柴油機之間的功率匹配控制進行了研究,其中包括柴油機經濟工作點的控制和防止柴油機過載的全程極限負荷控制。Using its two characteristics - fully automatic and rapid, this system can accomplish simultaneous, rapid, stable and repeatable matching with the load impedance, especially the dynamic load impedance ( eg : plasma load ). at the same time, it maintains the reflection coefficient at the desired value ( eg : 1. 2 ) to assure that the microwave transmission is at its best
此系統可利用它全自動化和快速的特點,實時的為負載尤其是動態負載(比如:等離子體負載)提供快速,穩定,可重復的匹配,自動將反射系數保持到工程理想值,從而實現微波功率的最佳傳輸。The possible factors including the deviation of temperature in length and breadth of rod, the changes of transfiguration resisting force under the changes of temperature, the adjustment of roll gap, the variation of rolling pressure, the changes of roller speed during dynamic adjusting press, the unmatched of seconds - flux under the dimension fluctuation of the coming sample and so on. the whole system was a closed loop which factors in it interacts each other
可能的影響因素有:沿軋件縱橫向溫度變化、由溫度引起的軋件變形抗力變化、軋機輥縫值變化、負載變化、電機調節系統由不穩定向穩定過渡過程中軋輥轉速的變化(如咬鋼過程中的動態速降后的回復階段) 、來料尺寸波動造成秒流量不匹配等,整個模擬系統是各個因素相互影響關聯的一個閉環系統。Not only can gain mismatch of the sigma - delta modulator be minimized, but the overload of the later stage sigma - delta modulator can also b e resolved without sacrificing the signal noise ratios ( snr ) of the over all system
不僅可以減輕積分三角調變器增益不匹配之困擾,並且可以解決后級積分三角調變器容易過負載之問題;然而,卻不會讓整體系統的訊號雜訊比( snr )降低。Static state analysis of voltage source induction heating inverter load - matching
電壓型感應加熱電源靜電感應負載匹配電路靜特性分析The ic modulation circuits and microprocessor are used in the control unit. on the side of input of inverter, the maximum power point tracking of solar module is well realized by using a kind of thought of self - optimizing control ; on the side of output of the inverter, a kind of approximate optimum v / f control strategy is used in order to optimize the match between the output of the inverter and load of motor - pump
在逆變器輸入側,採用自尋優控制思想實現太陽能電池最大功率點跟蹤( mppt ) ;在輸出側,採用了v / f近似優化的控制策略,以優化逆變器輸出與機泵負載之間的匹配。Through study of match of the system with load, the paper suggested thin hole as damping parts which can make system working in optimal working site and efficiently converting wind energy to heat energy
通過對系統與負載匹配的研究,提出採用薄壁孔元件作為阻尼元件可使系統始終工作在最佳工作點有效地將風能轉化為熱能。Theoretical and experiment researches of transmission mechanism and control strategy of the cvt have been carried out under the project ( 59835160 ) financed by national natural science foundation which includes follow content : 1 ) the kinematic relation of the metal pushing v - belt type transmission is analyzed. the relation among oil pressure of pulley cylinder, transmission ratio and input torque under load condition is studied. optimal design method for metal pushing v - belt type continuously variable transmission is put forward
本文在國家自然科學基金重點項目(資助號: 59835160 )資助下,對金屬帶式無級變速傳動系統的傳動機理、匹配及控制策略等進行了系統深入的理論分析和實驗研究,具體研究內容如下: 1 )系統地分析了金屬帶無級變速傳動的基本運動規律,研究了在負載狀態下,帶輪油缸壓力與速比和輸入轉矩的關系,提出了對金屬帶式無級變速傳動系統進行優化設計的方法。Gas - appliances ; completing determinations for appliances for instantaneous water heaters with automatic adaption of efficiency
煤氣設備.熱負載自動匹配的快速熱水器的全面測定Matched - load voltage
匹配負載電壓Using an equivalent circuit model, the limit to the achievable rising time with spark technology was calculated, and a pulse conditioning system consisting of coaxial transmission line and sub - nanosecond switches was designed and built
調制器由脈沖形成線、傳輸線、主開關、亞us開關( pc開關)和匹配負載組成,其中的亞us氣體開關能穩定運行於45atm 。Finally, the design and the test experiment of a high power matching load are introduced. the load has a steady resistance of 5. 82
最後,介紹了實驗中設計並研製的大功率低電感匹配負載,該負載冷測電阻值5 . 82Finally, a compact uwb pulse source composed of pzt95 / 5 ferroelectric ceramic, a 50 coaxial transmission line charged by a pulse transformer, a peaking - chopping switch, a coaxial matched load and a pulse diagnostic system was built and tested, which can produce pulse voltage on a matched 50 load with peaking voltage of 100kv, rising time of 870ps, falling time of 670ps, and fwhm of 1. 410ns
在上述工作的基礎上,我們研製了一臺以pzt95 5鐵電陶瓷沖擊去極化為能源的新型緊湊型脈沖發生器。該發生器由pzt9515爆電能源、空心脈沖變壓器、單同軸脈沖形成線、 pc開關、同軸匹配負載和脈沖診斷系統組成,能產生100kv 、上升前沿870ps 、后沿670ps 、脈寬1 4us的超寬帶脈沖。Detail specification for waveguide bj100 bj140 matching loads, model gh12513 gh12514a
Gh12513型3cm波導和gh12514a型2cm波導匹配負載詳細規范Detail specification for coaxial matching loads, model tt22
T22型同軸匹配負載詳細規范分享友人