匹配電抗 的英文怎麼說

中文拼音 [pīpèidiànkàng]
匹配電抗 英文
matching reactance
  • 匹 : Ⅰ動詞（比得上; 相當; 相配） be equal to; be a match for Ⅱ形容詞（單獨） lone Ⅲ量詞1. （用於馬、騾等） 2. （用於整卷的綢或布）
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 匹配 : 1. [書面語] （婚姻配合） mate; marry 2. [電學] matching
  1. The main work and achierement are as following : ( 1 ) by using shock impedance matching technique and electric probe method, 5 shots of impact experiments were conducted to measure the hugoniot equation of state for enstatite ( mg0. 92, fe0. 08 ) sio3 with the average initial density 3. 05g / m3 from shock pressure 50 gpa to 115gpa, using two stage light gas gun

    本文研究取得的認識主要有以下幾點： （ 1 ）用阻抗匹配法和電探針技術在80 115gpa壓力范圍內對平均初始密度為3 . 05g / cm ~ 3的頑火輝石樣品進行了5發hugoniot狀態實驗測量。
  2. The trained neural network model can be used to solve a variety of problems emerged in rf / microwave circuit design, such as in microwave circuit cad, the established model structure can be used to characterize the nonlinear behavior of microwave circuits

    如用於微波電路cad ，可用所建立的模型結構來描述這么一類微波電路的非線性行為特徵；如用於微波電路設計，則可進行如共面波導、晶體管、傳輸線、濾波器和放大器等的設計；如用於微波電路優化，則可用所建立的電路模型優化電路參數，進行阻抗匹配等。
  3. The experimental goal synthesizes the electromagnetic absorber in the discussion al2o3 content and the multilayer impedance matching group to influence the electromagnetic absorption effect, by makes further the discussion to the electromagnetic absorption effect

    實驗目的在探討氧化鋁的含量及多層阻抗匹配組合成電磁波吸收體對電磁波吸收效果之影響，作進一步之探討。
  4. The fourth chapter : in this chapter, it introduces the hardware designing of the dsp system based on pci bus and states every module of the hardware designing : circuit of signal adjusting, filter circuit of anti - overlap, circuit of data - acquisition automatically, expanding circuit of dsp memory, circuit of voltage matching, interfaces circuit of pci etc. it also includes theoretic basis and procedure of pcb designing

    第四章介紹基於pci總線的dsp系統硬體設計。敘述了硬體設計的各個模塊：信號調理電路、抗混疊濾波電路、自動數據採集電路、 dsp存儲器擴展電路、電平匹配電路、 pci介面電路等，以及pcb設計的理論基礎和設計過程，並給出了設計和調試的結果。
  5. Water dielectric pulse power modulator has been widely applied because of its merits of high energy storage density, compactness, and capability to drive low impedance high power microwave sources. research for multi - pulse operation of high power spark gap switch with high current and comprehending its physical properties are the basis to study multi - pulse operation or repetitive operation of water dielectric pulse power modulator

    水介質脈沖功率調制器具有儲能密度高，結構緊湊、與低阻抗微波源較好匹配的特點，因此得到廣泛的應用，但是受到高功率、大電流氣體開關的絕緣恢復的影響，水介質等低阻抗脈沖功率調制器的重復頻率運行或多脈沖運行受到較大的限制。
  6. The exportation resistance of a device work device with what link after loading the resistance s the certain connections for should satisfying, in order to prevent mount to load the appearance produce the obvious influence. with each other connect to say to electronics equipments, for example after signal connect the enlarger, ex - class to connect class, only behind first - degree importation resistance before larger than first - degree exportation resistance 5 - 10 times are above, can think the resistance to match good ; connect the box come saying, electronics tube the machine should choose to use with for the enlarger its output to carry the mark to call the resistance the box for, but transistor enlarger then have noing this restrict, can take officing why resistance of equal or approximate box

    一件器材的輸出阻抗和所連接的負載阻抗之間所應滿足的某種關系，以免接上負載后對器材本身的工作狀態產生明顯的影響。對電子設備互連來說，例如信號源連放大器，前級連后級，只要后一級的輸入阻抗大於前一級的輸出阻抗5 - 10倍以上，就可認為阻抗匹配良好對于放大器連接音箱來說，電子管機應選用與其輸出端標稱阻抗相等或接近的音箱，而晶體管放大器則無此限制，可以接任何阻抗的音箱。
  7. The negative sequence current of impedance - matching balance transformer

    阻抗匹配平衡變壓器的負序電流
  8. After analyzing the noise in the high frequency carrier channel and computing the parameter of channel, we solved the kernel problems of coupling and matched impedance. separate designing the power, power amplification, port, transceiver and other circuits, we fitted together all circuits become the whole lonworks node circuit, and then triumphantly debugged it

    經過對高頻載波通道的干擾特性分析和線路參數的計算，解決了耦合和阻抗匹配等核心問題，並對電源、功放、介面、收發器等部分電路分別設計，最後形成了完整的lonworks節點硬體電路，並調試成功。
  9. An adaptive impedance matching system model for power line communication system

    電力線載波通信中的自適應阻抗匹配系統模型
  10. The possible factors including the deviation of temperature in length and breadth of rod, the changes of transfiguration resisting force under the changes of temperature, the adjustment of roll gap, the variation of rolling pressure, the changes of roller speed during dynamic adjusting press, the unmatched of seconds - flux under the dimension fluctuation of the coming sample and so on. the whole system was a closed loop which factors in it interacts each other

    可能的影響因素有:沿軋件縱橫向溫度變化、由溫度引起的軋件變形抗力變化、軋機輥縫值變化、負載變化、電機調節系統由不穩定向穩定過渡過程中軋輥轉速的變化（如咬鋼過程中的動態速降后的回復階段） 、來料尺寸波動造成秒流量不匹配等，整個模擬系統是各個因素相互影響關聯的一個閉環系統。
  11. The impedance matching criterion that the sum of all the radiating slot normalized conductances is equal to 2 for the inner feed, and also the sum of all the coupling slot normalized impedances for the series - shunt inner feeder is equal to 2 are verified by using microwave network theory

    採用微波網路理論，在內部饋電情況下，分別對一條輻射波導上輻射裂縫的歸一化導納和為2的匹配設計準則，以及對串並形式饋電裝置，對耦合裂縫的歸一化阻抗和為2的匹配設計準則進行了證明。
  12. Research of the impedance matching in the rf power for the co2 lasers

    射頻電源中的阻抗匹配研究
  13. Spectrum analyzers or rf - receivers. the power can be supplied either from batteries, ni - cads or through a power cord directly connected to an hm5010 5011 5012 5014 series spectrum analyzer

    輸入阻抗器匹配的，探頭所用電源可以由乾電池，或鎳鎘電池提供，也可以通過電源線由
  14. Impedance - matching balanced traction transformers ( balanced transformers in this paper for short ) are step - down transformers, they transfer symmetrical three phase voltage in primary side to perpendicular two phase voltage in secondary side. they are different from any other transformers, so their short - circuit current analysis and short - circuit test method must be taken into special account

    阻抗匹配平衡牽引變壓器（本文中簡稱平衡變壓器）是一種將一次側三相對稱電壓變換為二次側二相垂直電壓的降壓變壓器，它不同於已有的任何一種變壓器，短路電流的分析計算和短路試驗必須予以重新研究。
  15. The methods above have been simulated using emtp and matlab, and the simulation results indicate that, ( 1 ) in the fault location method based on wavelet reconstruction, the influences of reflected waves from tee joints or resistance discontinuities except the fault point can be eliminated when the current difference between faulty phase and sound phase is used in fault location

    本文利用emtp和matlab程序對上述方法進行了數值模擬，結果表明： （ 1 ）在本文所提出的基於小波重構的電纜故障測距方法中，利用健全相和故障相的電流差信號進行故障定位，能消除故障點之外其他阻抗不匹配點的反射波的影響。
  16. As a result, this paper gives a corresponding harmonic prevent me asure. finally, according to the asymmetrical characteristics of electrical traction loads, this paper studies the negative sequence currents under different loads and makes a piece of advice for reducing the negative sequence currents produced

    最後，還根據電力牽引負荷三相不對稱的特點，分析了阻抗匹配平衡變壓器在不同負荷條件下的負序電流，對如何減小電力牽引負荷的負序電流提出了一點建議。
  17. It is convenient to adjust the circuit and easy to acquire sensitive signal by using this method, and there is not the impedance mismatching problem met in bridge - based self - sensing circuit

    該方法使得自感知電路的調節和感知信號的獲取變得容易，克服了電橋法自感知電路阻抗不易匹配的不足。
  18. Placing the amplifier at the electrodes in the design of active electrodes, the interference caused by the lines between the amplifiers and the electrodes is eliminated

    這種設計方法的中心思想是將電極與前置放大器設計為一體，可以有效地實現阻抗匹配，消除因導聯線移動而產生的明顯干擾。
  19. Through the monitoring on the frequency performance and square - wave response performance of manganese - zinc ferrite coil with different sizes., different ratios of winding and different matching impedances, the result shows that manganese - zinc ferrite coil with proper ratio of winding and matching impedance can effectively restrain the interference and damage which the over - voltage and large - current signals of the power system do to the on - line monitoring system

    通過對不同尺寸、不同匝數比和不同匹配阻抗下的錳鋅鐵氧體線圈的頻帶性能、方波響應性能測試實驗，結果表明：適當匝數比和匹配阻抗的錳鋅鐵氧體線圈可以有效地抑制系統過電壓和大電流信號對在線監測系統干擾和破壞。
  20. Presents the simple but highly reliable on - line detection of ultrasonic transducer clamping capacitance based on the impedance circuit model constructed through the impedance characteristics of the ultrasonic transducer under triple harmonics, and concludes from experimental results that this method can be used to effectively detect the variation of clamping capacitance while the transducer is operating, and the matching inductance can be dynamically regulated according to the results of detection, and dynamic matching can therefore be achieved in the real sense at the end of the transducer to improve the overall performance of the whole system

    為了解決大功率超聲應用的換能器電端匹配問題，分析了超聲波換能器在諧振頻率三次諧波下的阻抗特性，給出了超聲換能器三次諧波下的阻抗電路模型.並根據阻抗電路模型建立了對超聲換能器的夾持電容實現在線檢測簡單、可靠性高的方法，實驗證明該方法有效的.該方法可以在換能器工作過程中隨時檢測夾持電容的變化，根據檢測結果對匹配電感進行動態調整，實現真正意義上的換能器電端的動態匹配，從而大大改善匹配質量，提高系統的工作性能
分享友人
分享到 Line

分享到臉書