圓錐掃描 的英文怎麼說
中文拼音 [yuánzhuīsǎomiáo]
圓錐掃描
英文
conical scan-
According to tracking theory, automatic following can be divided into three systems : step - advance tracking, taper - scan tracking and single - pulse tracking
按跟蹤原理，自動跟蹤可分為三種體制：步進跟蹤、圓錐掃描跟蹤和單脈沖跟蹤。The glint suppression using high resolution range profile under conical angle measurement is studied, the angle information in signal components of scatters are extracted and averaged to suppress the glint. nonlinear kalman filtering methods under near spherical coordinate are analyzed and used to get more accurate tracking
研究了圓錐掃描測角體制下基於距離高分辨的角閃爍抑制方法，利用距離維高分辨像，提取強散射中心反射信號分量，在此基礎上估計出各個強散射中心的角度測量值，採用平均方法減少角閃爍對測角的影響。Analyse the technology principle of program tracking, step - in tracking, conical scan tracking and singleshot tracking, and contrast the advantage and disadvantage of them. select program tracking and conical scan tracking considering performance and cost
二、對程序跟蹤、步進跟蹤、圓錐掃描跟蹤和單脈沖跟蹤這四種自動跟蹤技術的原理進行了具體的分析，並比較了它們各自的優缺點，從性價比的角度，選擇了程序跟蹤與圓錐掃描跟蹤相結合的方式。According to the technical requirements of data relay satellite system, we determine to exploit and analyze the oscillation amplitude comparison mono - pulse mode in a single channel mono - pulse, angular tracking manner in comparisons among several angular tracking modes e. g. cone scanning, step tracking, phase comparison mono - pulse and oscillation amplitude comparison mono - pulse
根據數據中繼衛星系統技術指標與技術要求，通過比較圓錐掃描、步進跟蹤、相位比較單脈沖與振幅比較單脈沖等跟蹤方式的優、缺點，確定採用振幅比較單脈沖方式中的單通道單脈沖角跟蹤方式，並對此跟蹤方式進行了詳細的研究。In this paper, high resolution range steady imaging under the conical angle measurement, angle glint suppression under conical angle measurement, target recognition under momopulse angle measurement are studied
本文主要研究了圓錐掃描測角體制下距離維高分辨穩定成像，圓錐掃描測角體制下角閃爍的抑制，單脈沖測角體制下目標識別等課題。Csro conical - scan - receive - only
圓錐形掃描單獨接收4. conclude and verify detailedly attitude algorithm and conical scan control algorithm in process of initial alignment. on the base of static initial alignment technology, reach the dynamic initial alignment technology used on moving carrier
四、對在初始對準中採用的姿態解算和圓錐掃描控制演算法進行了詳細的理論推導和模擬驗證，然後在靜態初始對準的基礎上，引出了用於載體移動過程中的動態初始對準。Based on the engineering application, this paper firstly introduces the mathematics foundation of the antenna - tracing system, and then summarizes the trace technique, analyzes the strongpoint and the disadvantage of them, especially the taper - scanning trace technique
論文從工程應用出發，首先介紹了天線自動跟蹤系統的數學基礎，然後對天線跟蹤技術作一個概述，分析了各種跟蹤技術的優缺點，並對本項目採用的圓錐掃描跟蹤進行了詳細的介紹。First of all, this paper summarizes the history and actuality of tracking technology, and analyse the basic principle of programme tracking 、 taper scanning tracking and single pulse tracking, and compare it with the others
本論文首先概述了跟蹤技術的發展歷史與現狀，對程序跟蹤、圓錐掃描跟蹤、單脈沖跟蹤的基本原理進行了論述與比較分析。The impact of the conical scan on range profile is analyzed, and the cyclostationary method is used to estimate and dispel the interference of conical modulation. simulation test results show the method can provide good profile
研究了圓錐掃描測角體制對目標距離維成像的影響，針對低信噪比環境，同樣採用循環平穩方法估計圓錐掃描對信號的調制。分享友人