均勻電流密度 的英文怎麼說

中文拼音 [jūnyúndiànliúmìdù]
均勻電流密度 英文
uniform current density
  • 均 : Ⅰ形容詞（均勻） equal; even Ⅱ副詞（都; 全） without exception; all
  • 勻 : Ⅰ形容詞（均勻） even Ⅱ動詞1. （使均勻） even up; divide evenly 2. （分出一部分） spare
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 密 : Ⅰ名詞1 （秘密） secret 2 [紡織] （密度） density 3 （姓氏） a surname Ⅱ形容詞1 （距離近; 空隙小）...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. The distributions of current density and potential on the negative plates with the radiational or expanded grid designs are more uniform than those on the positive plate

    輻射式和拉網式負極板在化成開始時電流密度和電位的分佈都比正極板上分佈均勻得多。
  2. At the end of the formation, both current and potential distributions are uniform. however, their distributions on the negative plate with the expanded grid design are a little more uniform

    化成結束時電流密度和電位分佈都比較均勻，且拉網式負極板比輻射式負極板更均勻。
  3. When formed for 8h, because most of paste on the negative plate has converted into lead, the polarization increases and the potential changes greatly, these distributions on the two kinds of negative plates become non - uniform again

    當化成8h時，由於負極板上的鉛膏大部分轉化為鉛，極化上升，電位變化很大，所以兩種負極板上電流密度和電位分佈又變得不均勻。
  4. Nowadays, our company applied many international advanced technology in production equipments, from aluminum pole casting, mould design, profile extrusion, even spraying, anode oxidation, mono - bino alkali dyeing, electrophoresis coating, color powder spraying, fake wooden texture to exact test, which automation level is high

    目前，我公司從鋁棒熔鑄，模具開發，型材擠壓均勻噴沙陽極氧化，單雙鹽著色電泳塗裝多彩粉末噴塗模擬木紋，以至精密檢測等生產線和設備均採用了國際先進技術，自動化程度極高，使產品質量達到了世界一流的先進水平。
  5. When it is discharged at high - rate, the distributions are also the most uniform at the end of the discharge. this indicates that the positive plate with the red lead has the better discharge performance than the other two kinds of positive plates

    含紅丹的正極板在化成初期電流密度和電位的分佈最均勻，極化最小，在高倍率放電結束時，其電流密度和電位分佈也最均勻，表明含紅丹的正極板的放電性能比其它兩種正極板好。
  6. Alcl3 + lialh4 system conforms to the relation of current efficiency and cur rent density of complex electrolysis lead to uniform distribution at cathode plate

    Alcl _ 3 + lialh _ 4體系符合絡合物電解中電流效率與電流密度的關系，使鋁鍍層在陰極上的分佈趨于均勻。
  7. During the formation, the positive plates with red lead and bapbo3 additives are easier formed than that without additive, so the current and potential distributions on the plates with additives are more uniform than that without additives in the early stage of the formation. these distributions on the plate with red lead are the most uniform, and the polarization is the smallest

    在正極板化成過程中，含紅丹和鉛酸鋇鉛膏的正極板比不含添加劑的正極板更容易化成，所以在化成初期含添加劑正極板的電流密度和電位分佈比不含添加劑正極板上的電流密度和電位分佈更均勻。
  8. Seen from the experiment result, it is clear that the deposited coating obtained with the trivalent chromium electrodepositing method we use is smooth, homogeneous, dense, and has good unti - erosive ability, high stiffness. the color ol ihe deposited coaling ol irivalent chromium is similar with that of hexavalent chromium. further more, this process has a good ability of homogeneous and deep depositing with simple facility, high current efficiency, and wide working current flow and even more it avoids environmental pollution

    實驗結果表明，本文採用的三價鉻鍍鉻方法能電鍍出鍍層光滑、均勻、緻密、抗蝕性好、硬度高的鍍層，而且解決了鍍層顏色的問題，使三價鉻鍍層不僅具有現行六價鉻鍍層的天藍色光澤，同時還具有電流效率高、均鍍能力與深鍍能力好、工作電流密度寬、設備簡單、無環境污染等特點。
  9. Aluminum products with shing uniform surface was prepared by electrochemical graining process, including alkaline cleaning, 1 % naoh etching, electrochemical roughing in hcl, naoh treating and anodizing in 5 % h2so4 etc

    摘要研究了鋁材無掛灰電化學砂化處理工藝。以鹽酸作為電解液的主成分，控制合適的電流密度和電解時間等工藝參數，通過6步處理，得到砂化均勻、粗糙度適中及光亮的砂面。
  10. The x - ray diffraction, scanning electronic microscope and the squid were used to characterize the properties of the mgb2 core in mgb2 / fe tapes and wires. the effect of the proportion of mg, b and sic as well as the sintering parameters on the phase formation, microstructure and the critical current densities of mgb2 / fe tapes and wires was discussed in details. the results showed that the high purity of mgb2 core could be synthesized by both the traditional vacuum sintering and the sparking plasma sintering and the vacuum sintering environment restrained the oxidation of mg effectively

    相對于傳統真空燒結， sps燒結方式成相速度快、樣品晶粒細小均勻、 mgb2超導芯緻密性好、晶間連接優良，因而sps燒結樣品的臨界電流密度明顯高於傳統真空燒結樣品，其中未摻雜的帶材樣品經過sps800 ， 15分鐘燒結后，自場下的臨界電流密度jc值在10k時達到8 . 64 105a / cm2 ，而且隨著測量溫度和外加磁場的增加， sps燒結樣品的臨界電流密度下降率比傳統真空燒結樣品緩慢，在20k ，自場時為5 . 97 105a / cm2 ， 20k ， 3t時，臨界電流密度值仍大於104a / cm2 。
  11. The highest jc of 8. 64 105a / cm2 at 10k, 0t was obtained in the un - doped mgb2 / fe tape sintered at 800 for 15 minutes by sps. it is worthwhile to note that the jc value was decreased much slowly in this sample with the increase of the testing temperature and magnetic field. for example, the jc was 5. 97 105a / cm2 at 20k, 0t, and at 20k, 3t the jc value was

    從目前試驗結果看，摻雜量為5mol %時線材性能較好，樣品的臨界電流密度在自場下達到6 105a / cm2 ，並且sic摻雜改進了樣品在高場下的jc值，在4t時，摻雜線材樣品的臨界電流密度大大超過未摻雜樣品，這是由於sic的摻入生成了細小均勻的mg2si ，分佈在晶粒
  12. Also considered is the dependence of the guidance performance of the superconductor upon such elements as geometrical and current parameters of the system, the movement of the superconductor. comparison between the experimental and theoretical results indicates the effectiveness of the method utilized in the thesis

    這些元素包括以下三方面，系統的幾何尺寸：高溫超導體的幾何尺寸、永磁導軌的幾何尺寸；系統的電流參數：高溫超導體的臨界電流密度、永磁導軌中永磁體的均勻磁化強度；高溫超導體相對導軌的運動方式。
  13. The morphology examination by sem and tem showed that the carbon nanotubes were arranged in the array uniformly and paralleled, with smooth walls, the outside diameter of 120 nm and the inside diameter of 110 nm. from the cyclic voltammetry, the array electrodes in an acidic electrolytic solution had greater capacitance than the case in a neutral electrolytic solution. the specific capacitance of 365 f / g was achieved with the discharge current density of 210 ma / g in the solution of 1 mol / l h2so4

    掃描電子顯微鏡和透射電子顯微鏡對碳納米管陣列電極的形貌表徵表明碳納米管形狀規整，排列有序，尺寸均勻，管壁光滑，外徑約為120nm ，內徑約為110nm ；循環伏安實驗表明mwnts陣列電極在酸性溶液中比在中性溶液中具有更好的電容性能；根據恆電流充放電法得出mwnts陣列電極在1mol / lh _ 2so _ 4水溶液中，在210ma / g的放電電流密度下的比電容可達353f / g ，比目前報道的無序碳納米管和活性炭電極的比容量都高得多；其它電化學實驗顯示該電極具有很低的內阻和良好的充放電循環穩定性。
  14. The experimental results showed that firstly, the distribution of resistiveity, mobility, carrier concentration, epd and ab - epd in gaas substrate was not uniform ; secondly, the distribution of electrical parameters depended on that of epd and ab - epd ; thirdly, mesfet devices performance correlated with ab microdefects ; last, as shown by pl mapping results, it is substrate with better parameters quality that could provide more chance to fabricate good mesfet devices

    實驗結果表明， lecsi - gaas的電阻率、遷移率、載流子濃度、位錯密度和ab微缺陷分佈都不是均勻的，且電參數的分佈與ab - epd 、位錯密度分佈有關。製作的mesfet器件的性能參數分佈與ab微缺陷有明顯聯系。從plmapping測量結果可以看出材料的襯底參數好，則pl譜的強度高， pl譜均勻性也好，器件參數也好，就有可能製作出良好的器件與電路。
分享友人
分享到 Line

分享到臉書