場感應線圈 的英文怎麼說

中文拼音 [chǎnggǎnyīngxiànjuān]
場感應線圈 英文
tapped inductor
  • 場 : 場Ⅰ名詞1 （平坦的空地 多用來翻曬糧食 碾軋穀物） a level open space; threshing ground 2 [方言] （...
  • 感 : Ⅰ動詞1 （覺得） feel; sense 2 （懷有謝意） be grateful; be obliged; appreciate 3 （感動） move; t...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 圈 : 圈名詞1. （養豬羊等牲畜的建築） pen; fold; sty 2. （姓氏） a surname
  • 線圈 : [電學] coil
  1. Being a method of time - domain electrical magnetic surveying, the transient electromagnetic method ( tem ) can transmit first pulse electromagnetic field to underground making use of loop or electrical source and receive secondary induction field during of the pulse intermission

    瞬變電磁法是一種時間域電磁測量方法，是利用不接地回線或接地線源向地下發送一次脈沖磁場，在一次脈沖磁場的間歇期間，採用不接地線圈接收感應二次磁場。
  2. Dry reed relays are also operated by energizing a coil, but in this type of relay, the coil is wound around the switch so that the induced magnetic field closes the switch

    干簧繼電器也是靠激勵一個線圈進行工作的，但是在這種類型的繼電器中，線圈環繞著開關，從而感應的磁場使開關閉合。
  3. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。
  4. We also analyzed the interaction among the distribution of the magnetic field around the magnet, the induced electromotive force in the coil and the vibration of the magnet

    對永久磁鐵在空間產生的磁場分佈、感應線圈中的感應電動勢與磁鐵相應振動等因素的相互關系進行了計算分析。
  5. Induced current electrical impedance tomography ( iceit ) is a new branch of electrical impedance tomography ( hit ). it applies several excitation coils on the boundary of the object. when one of the coils is stimulated by constant alternating current, the magnetic field is established

    感應電流電阻抗斷層成像（ inducedcurrentelectricalimpedancetomography ， iceit ）是電阻抗斷層成像技術的一個分支，它在被測目標的外圍放置若干個激勵線圈，對其施加時變電流，在空間產生交變磁場，從而在被測目標內激勵出感應電流。
  6. 2 ) the inductance transducer used to identify large wear particle is developed. the analytical theory of wear particle and detection windings are expatiated and inner magnetic distribution of inductance transducer is discussed, the geometry parameters are optimized by using genetic algorithm, and the finite element analysis method is used in the designing

    2 ）研製了識別大磨損顆粒的材質和測定其粒度的電感傳感器，闡述了磨損顆粒與檢測線圈的解析關系，探討了傳感器的理論基礎，分析了電感式檢測傳感器內部的磁場分佈，並應用遺傳演算法優化了傳感器幾何參數，最後進行了有限元模擬分析。
  7. At present such as inductance coil and etc. devices are adopted by most signal control systems to obtain field traffic information, which exists much deficiency both in installation, debugging, maintenance and technique

    目前大多數交通信號控制系統採用了諸如感應線圈等設備來獲取現場交通信息，不管是從安裝維護方面還是從技術方面來講，都存在一定的不足。
  8. In this paper, the electromagnetic problems of the passive feedback coils that restrain the vertical displacement of plasma in fusion device is discussed and the induced currents on the passive feedback coils, the eddy currents magnetic field and the electrical parameters of coils are also analyzed

    本文研究了聚變裝置中用於抑制等離子體垂直位移的被動反饋線圈電磁問題，分析了被動反饋線圈感應電流分佈、渦流磁場及線圈電氣參數等問題。
  9. Secondly, methods of improving on probe are investigated in detail : using the electromagnetic shielding effect to decay the direct - coupled magnetic field and using the dual probe to control the energy flow, so as to make the probe to be shorter ; designing 3 - d pick - up coil array to increase detection sensitivity. at last, experiment system is set up to verify the simulation result and the comparing result shows simulation result agrees with experiment result

    其次，對改進傳感器性能的幾種方法進行了詳細研究:利用電磁屏蔽效應以衰減在直接路徑上的磁場傳播、採用復式探頭激勵方式以實現能流控制，從而減小傳感器體積，模擬證實這兩種改進方案有效;設計三維周向檢測線圈陣列以提高缺陷檢測靈敏度，模擬結果證實三維探頭的周向靈敏性。
  10. The finite element method ( fe '. i ) is adopted to analyze the effects of the numbers of coil turns, current intensity and current frequency upon the rate of joule heat generation in details. the thermo - radiation analytical countermeasures of various types are adopted to carry out the numerical analysis of the effects of the crucible with different shapes and sizes and the blind holes with different depths opened in the tops of crucibles as well as coil positions upon the thermal field distribution whereby solving the main problem of field the thermo - field design of the induction - heating sic crystal growth system. a new combination idea of the thermo - field design obtained by means of the united design of the thermo - insulator and blind holes has been presented

    採用有限元分析方法對線圈匝數、電流強度、電流頻率等對焦耳熱產生速率的影響進行了詳細的分析討論；採用不同的熱輻射分析策略，對不同坩堝形狀、坩堝頂部開設不同深度的盲孔以及線圈的位置等對熱場分佈的影響進行了數值分析，解決了感應加熱碳化硅晶體生長系統熱場設計的主要問題，提出了通過絕熱層與盲孔的聯合設計獲得所需熱場設計的思路，給出了根據軸向溫度梯度的波動對線圈位置實行動態調節以控制熱場的理論依據。
  11. A sensing magnetic field and displacement type of giant magneostrictive microdisplacement actuator with the functional of sensing driving magnetic field and microdisplacement is developed, and the design theories and approaches being applicable this type of microdisplacement actuator are pointed out : a circular diaphragm type of flexible construction that acts as integration mechanism of microdisplacement transferring and sensing of giant magnetostrictive microdisplacement actuator is adopted, sheet flexure theory of elasticity mechanics and approach of finite element are applied to design and calculate it, corresponding deflection and analytic formula and distribution curve of stress are given, and the specific achieving approaches of measuring principle and magnetic field sensing function of driving field in giant magnetostricitive rod are pointed out the magnetic field sensing function of the actuator is used to practically measure driving magnetic field of actuator and to obtain the relationship of driving magnetic field and coil current, which is also analyzed and studied

    其中，採用圓形膜片式柔性結構作為超磁致伸縮微位移執行器的微位移傳遞、感知一體化機構，應用彈性力學中的薄板彎曲理論、有限元方法對其進行了設計、計算，並給出了相應的撓度和應力解析式及分佈曲線；應用電磁理論給出了超磁致伸縮棒內驅動磁場的測量原理及磁場感知功能的具體實現方法，並利用執行器的磁場感知功能對其驅動磁場進行了實際測量，得出了驅動磁場與線圈電流之間的關系，並對其進行了分析和研究；對執行器內部的電磁路和偏置磁路結構進行了設計計算與實驗研究，為了減小驅動線圈的發熱，對其形狀進行了優化設計。
  12. Eddy current nondestructive testing ( ecndt ) is widely used to detect the thinness and defects of the sample, because of its characteristics of non - contact, high sensitivity and ease of detection. the principle of ecndt is that : when a probe coil with the ac exciting source is put near a sample, eddy current will be produced in the sample which will conversely affect the impedance of the coil according to the farad theorem. any un - uniformity in the sample will change the impedance of the coil and the output voltage

    渦流無損檢測技術具有靈敏度高、檢測速度快、非接觸等特點廣泛應用於厚度檢測和缺陷探傷，它的原理是當載有交變電流的檢測線圈靠近金屬導體時在導體中產生渦流，該渦流又影響原磁場，使得線圈的阻抗和感應電壓發生變化，通過分析阻抗或感應電壓的變化來獲得被測導體的信息。
  13. On the basis of producing the mathematical model of calculating the induced currents on the passive feedback coils, the distribution and variation of the induced currents and the eddy currents magnetic field are given by numerical calculation. these conclusions are necessary to study the vertical unstability of plasma and design the coils

    在建立求解被動導電板感應電流數學模型的基礎上，通過數值計算，給出了感應電流的分佈和變化情況，同時對渦流磁場的分佈和變化也給出詳細的計算結果，這些結論對研究等離子體垂直不穩定性和線圈的設計是必需的。
分享友人
分享到 Line

分享到臉書