塗敷 的英文怎麼說

中文拼音 [túfū]
塗敷 英文
application
  • 塗 : Ⅰ動詞1 （抹） spread on; apply; smear 2 （亂寫或亂畫） scrawl; scribble 3 （抹去） cross [blot; s...
  • 敷 : Ⅰ動詞1. （搽上; 塗上） apply 2. （鋪開; 擺開） spread; lay out 3. （夠; 足） be sufficient for Ⅱ名詞（姓氏） a surname
  1. Use the applicator provided to spread the glue

    使用所附塗敷器塗用膠水
  2. This film is deposited on the surface of the glass by evaporating crystals, use of cryolite or magnesium fluoride, in a vacuum.

    塗敷薄膜時，通常是將玻璃置於真空之中，然後使冰晶石或氟化鎂晶體氣化，令其沉積于玻璃表面上。
  3. The film is deposited on the surface of the glass by evaporating crystals, usually of cryolite or magnesium fluoride, in a vacuum.

    塗敷薄膜時，通常是將玻璃置於真空之中，然後使冰晶石或氧化鎂晶體氣化，令其沉積于玻璃表面上。
  4. Effects of latent heat on temperature field in laser cladding process

    潛熱對激光塗敷過程中溫度場的影響
  5. Surface-coating techniques may be classified into two major types: brittle coatings and photoelastic coatings.

    表面塗敷技術分為兩個主要類型：脆性塗層和光彈性塗層。
  6. Medical instruments ; plaster cast spreader type henning

    醫療器械亨寧氏管形石膏塗敷器
  7. The direct chiral separation of ( ? 3 - s ) - bridged racemic metal clusters was performed on cellulose - tris ( 3, 5 - dimethylphenylcarbamate ) chiral stationary phase ( cdmpc - csp )

    摘要在自製的塗敷型纖維素三（ 3 ， 5 -二甲基苯基氨基甲酸酯）手性固定相上直接拆分了? 3 - s蓋帽的外消旋四面體金屬簇合物。
  8. Among various fabrication techniques of thin film, the sol - gel process has gained much interest for the preparation of pzt thin film, due to ihe advantages of good homogeneity, easy control of composition, low in - ill i reaving temperature, easy formation of large area thin films pb ( zrxti : - k ) 0 :, ( pzt ) films were prepared on the ito coated glass plates and low resistor silicon wafer in sol - gel dip - coating process associated wi di heat treatment : at different temperatures and characterized by x - ray diffraction ( xrd ) and transmission electron microscopy ( tem ). lt is shown that the pzt ferroelectric thin films with ( 110 ) preferred orientation and well - crystallized perovskite structure can be obtained after annealing at 680 ? for 30 minutes on ito substrate and at 800 " c for lornin on silicon substrate

    Pzt的制備方法有很多，其中溶膠?凝膠（ sol - gel ）方法可以和集成電路（ ic ）光刻工藝相互兼容，處理溫度低，有大面積塗敷性能，能精確地控制組分，無需復雜的真空設備，成本低廉，所以對于集成鐵電薄膜電容的應用這種方法有很廣闊的前景。本文利用sol - gel技術在摻錫的in _ 2o _ 3透明導電薄膜（ ito ）襯底和低阻硅襯底上成功地制備了pzt鐵電薄膜。運用了x射線衍射， sawyer - tower電路和lcr電橋分別對薄膜的晶化溫度，結構和電學性能進行了測試。
  9. Stainless steel shaft bearings coated with nickel - reinforced ptfe for perfect stem guiding and smooth closing

    不銹鋼軸軸承外層塗敷鎳強化聚四氟乙烯，用於完善閥桿導向和平滑關閉。
  10. And then the extended ipo hybridized with fem is employed for the analysis of electromagnetic scattering by dielectric coated, electrically large cavities with complex terminal. green ' s functions of the dielectric coated board is involved

    在此基礎上，將改進的ipo與fem相結合對工程實際中所常見的具有復雜幾何結構終端的電大尺寸介質塗敷腔體的電磁散射特性進行分析。
  11. Iterative physical optics is extended to the analysis of electromagnetic scattering by dielectric coated targets. the theoretical model of the extended ipo is formulated by fresnel reflection coefficient. it is applied to analyze the scattering by geometrically simple, electrically large, dielectric coated cavities

    將迭代物理光學（ ipo ）法推廣到非完純導體邊界目標的電磁散射特性分析中，建立了具有阻抗邊界的ipo理論模型，並應用這種推廣的ipo方法分析幾何結構簡單的電大尺寸介質塗敷腔體的電磁散射特性。
  12. Continuously hot - dipped coated steel sheet products - dimensional and shape tolerances

    連續熱浸塗敷鋼薄板產品.尺寸和形狀公差
  13. All sizes are standardly equipped with awwa epoxy coated, ul / fm listed osy resilient seated gate valves, cfm ( cubic feet per minute ) or gpm ( gallon per minute ) meter and ball type test cocks

    作為標準配置，所有通徑美國自來水廠協會（ awwa ）認可的環氧樹脂塗敷， ul / fm認證外閥桿軛架彈性閥座閘閥， cfm （立方英尺/分鐘）或gpm （加侖/分鐘）水表和球型測試旋塞。
  14. Heavy - gauge steel is automatically formed, rolled and welded to assure a continuous seam for glass lining. each tank is double tested to ensure quality

    內膽由超厚鋼板通過自動化控制設備滾軋、成型、焊接而成，確保在塗敷烘烤熔融藍鈷陶瓷工藝過程中內膽不會出現縫隙。每個內膽都經過雙重質量檢驗以確保質量合格。
  15. Installation of sheet roof and wall coverings - profiled fibre cement - code of practice

    薄板屋面和墻面塗敷層.成形纖維水泥.實施規程
  16. Design and construction of fully supported lead sheet roof and wall coverings - code of practice

    全面支撐的鉛板屋面和墻面塗敷層的設計與結構.實施規程
  17. Testing of colouring materials ; conditions of measurement and evaluation for the determination of colour differences for paint coatings, similar coatings and plastics

    著色劑的檢驗.測定色漆塗敷層類似塗層和塑料色差的
  18. Standard specification for titanium and titanium - 6 aluminum - 4 vanadium alloy powders for coatings of surgical implants

    外科植入物塗敷用鈦及鈦- 6鋁- 4釩合金粉末的標準規范
  19. The shaft is guided by teflon - coated bearings to protect against deflection

    閥桿通過特氟隆塗敷的軸承引導，以確保不會偏轉。
  20. On the aspect of the research of the rcs computation methods, this dissertation did many work as : it discussed the application of the stationary phase method for the integral of the physical optics and gave the expressions of the stationary phase method based bezier surface for the perfect conduct and coated target ; focused on the application of the stationary phase method, it discussed some important techniques such as the searching of the stationary phase method and the handling of the singularity ; it also discuss the application of the gauss method for verifying the correction of the stationary phase method, and gave their compares of the efficiency and the precision

    在rcs演算法研究方面，本文做了以下研究：討論了在bezier曲面上物理光學積分的駐相法求解，給出了bezier曲面上理想導體和塗敷目標駐相公式；圍繞駐相法的應用，討論了駐相法應用中的一些關鍵的技術問題，包括駐相點的搜索、駐相法的奇異性；為了檢驗駐相法的精度，還討論了gauss積分的應用，給出了兩種方法計算效率和精度的比較。
分享友人
分享到 Line

分享到臉書