壁內吻合 的英文怎麼說

中文拼音 [bìnèiwěngě]
壁內吻合 英文
intramural anastomosis
  • 壁 : 名詞1 （墻） wall （of a house etc ） : 銅墻鐵壁 bastion of iron2 （作用像圍墻的部分） wall of st...
  • 內 : 名詞1. （內部; 里頭; 里邊） inner; inside; within 2. （妻子或妻子的親屬） one's wife or her relatives 3. （姓氏） a surname
  • 吻 : Ⅰ名詞1. （嘴唇） lips 2. （動物的嘴） an animal's mouthⅡ動詞（用嘴唇接觸人或物） kiss
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 吻合 : fit; be identical; coincide; tally
  1. In this paper, some characteristics of flow movement and sediment transport are analyzed by using the flume experiment data. the cross section of compound channel can be divided into four regions : the undisturbed region in main channel, the interactive region between channel and plain, the undisturbed region in flood plain and the boundary region. in the undisturbed regions, the distribution of longitudinal velocity along the depth has the feature of lograithmic. whereas, in the interactive region, the longitudinal velocity does not obey the logarithmic distribution law, but it can expressed as a revised logarithmic function by using a wake function. on the basis of the kinematic equation the velocity distribution of transverse velocity is obtained. in the boundary region, the longitudinal velocity obeys the law of parabolic distribution. furthermore, according to the simplified diffusion equation, the transverse distribution of sediment concentration in the interactive region is deduced. the analysis is in good agreement with the measured data

    本文根據漫灘水流的運動特點，將漫灘水流的復式斷面分為主槽平衡區、灘槽交互區、灘地平衡區及邊壁區等4個區，並給出了各區寬度的經驗公式.根據灘槽交互區垂線流速分佈的變化特點，提出了附加尾流函數的對數流速分佈公式.在簡化水流運動方程和泥沙擴散方程的基礎上，對灘槽交互區內垂線平均流速及含沙量沿橫向分佈進行了理論分析，提出了反映灘槽水流動量交換強度的橫向渦量粘性系數及橫向擴散系數的表達式，得到了漫灘水流垂線平均流速及含沙量沿橫向分佈的解析解，並與實測資料吻合較好
  2. Abstract : according to sidewall unstable problem during dr illing, the study on sidewall stability is developed. the paper analyses sidewall stress state and sidewall unstable type, and combines with log data and indoor e xperimental result of core. through analysis and calculation, the method of calcul ating slough formation pressure is proposed. by application of the method in 3 wells in yancheng area, result shows that slough pressure section fits in with field practical condition. it supplies some basis for design of drilling fluid d ensity

    文摘:針對鉆井中井壁失穩問題開展井壁穩定性研究，文中就井壁應力狀態和失穩類型進行分析計算，並結合測井資料和巖心的室內實驗結果進行分析，建立了一套計算地層坍塌壓力的方法，結合鹽城地區3口井應用對比，坍塌壓力剖面基本吻合現場實際，為鉆井液密度設計提供了一定的依據。
  3. The mostly content is as follows : ( 1 ) such plate was analyzed continuously in the stimulating sandwich plat method, according to the overseas tests ’ phenomena and results, a crack mode is supposed in the test, and a formulas is deduced to calculate the punching capacity of thin - wall core box cast - in - site reinforce concrete hollow slab, the calculation results agree well with the test results

    主要研究內容如下: （ 1 ）採用夾層板理論對這種空腹板進行連續化分析，根據國外的試驗現象和結果，假定破壞模式，推導出薄壁箱體現澆混凝土空腹板柱節點在豎向荷載作用下的抗沖切承載力計算公式，公式的計算值與試驗值吻合良好。
  4. Combined with a project financially supported by the construction bureau of hunan province, some studies on this floor have been carried out in this thesis. the valuable results achieved are outlined as below : 1. compared with the current concrete criterion, a method for the stiffness of thin - wall core box cast - in - site concrete hollow floor which is analyzed in this thesis is proposed

    本文結合湖南省建設廳重點資助項目對薄壁箱體現澆混凝土空心樓蓋進行研究，取得了的研究成果，如下: 1 、對薄壁箱體現澆混凝土空心樓蓋的剛度進行了分析，以《混凝土結構設計規范》為基礎，提出了現澆空心樓蓋剛度和內力的簡化計算方法，其計算結果與已有的試驗結果吻合良好，使樓蓋內力和變形的計算過程得以簡化。
  5. In order to study the regeneration mechanism of dpf in detail, we still need a mathematical model of the channel unit, which present temperature field and the soot reaction rate of the channel. finally, it points out the influences of various factors to the regeneration process by computing the numerical solution of model under different boundary conditions and geometry parameters, such as the initial temperature, the gas flow rate, the oxygen concentration, the sediment quantity and the wall thickness of the filters, and so on. in this way, the paper provides theoretical guidance for optimization design of the dpf

    首先研究了干凈壁流式過濾體的加熱特性，然後在加熱和燃燒理論的基礎上建立了微粒捕集器再生過程的數學模型，並對模型進行了數值計算，得到了捕集器內部的三維溫度場分佈以及溫度梯度分佈，結果與實驗值吻合較好，驗證了模型的正確性;為了詳細的研究微粒捕集器的再生機理，建立了孔道單元數學模型，得到了孔道內的溫度場分佈和微粒反應速率分佈;最後，通過求解模型在不同邊界條件和不同幾何參數下的數值解，分析了各種因素對再生過程的影響，如過濾體初始溫度、過濾體內氣流的流動速率、氧濃度、微粒沉積量以及過濾體壁面厚度，為微粒捕集器的優化設計提供理論指導。
分享友人
分享到 Line

分享到臉書