外置增壓器 的英文怎麼說
中文拼音 [wàizhìzēngyāqì]
外置增壓器
英文
external blower- 外 : Ⅰ名詞1 （外面） outside; external side 2 （外國） foreign country 3 （以外） besides; beyond; in ...
- 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
- 壓 : 壓構詞成分。
- 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
-
As the microbolometer which is voltage biased express some characters different from other infrared detectors under the effect of electric heat and infrared radiation together, the computing method of parameters, such as responsivity, noise, noise equivalent temperature different ( netd ), noise equivalent power ( nep ), optical gain, detectivity and so on is given in this paper. some of these parameters are particular compared with other detectors, and some have difference between microbolometer and other detectors
由於微測輻射熱計在施加偏置電壓的情況下，電熱效應與紅外輻射的共同作用使它表現出與其他紅外探測器完全不同的一些特徵，文中給出了響應率、噪聲、噪聲等效功率、噪聲等效溫差、光學增益、探測率等參數的計算方法，這些參數中的部分是微測輻射熱計獨有的，或者與其他的紅外探測器的同一參數有所區別。The control and mitigation measures cover mechanical ventilation, filtration, differential pressure control, directional airflow control, local exhaust ventilation, and ultraviolet germicidal irradiation ( uvgi ) disinfection
控制和降低污染物的方法有控制機械通風的量，過濾法，控制壓力差，控制氣流方向，增加局部排器裝置及利用紫外殺菌光來消毒。The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier
本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
分享友人