定子試驗器 的英文怎麼說

中文拼音 [dìngzishìyànqì]
定子試驗器 英文
stator fester
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 試驗 : trial; experiment; test
  1. Electronics engineers build their models with breadboard circuits, using the laws of physics to determine expected values for various properties and then precision instruments to measure actual values

    電子學工程師通過電路試驗板建造模型，運用物理學法則確定不同屬性的期望值，然後使用精密儀器來測量出實際值。
  2. Test method for calibration verification of laser diffraction particle sizing instruments using photomask reticles

    用光掩模原版校準檢驗激光繞射粒子定尺寸儀器的試驗方法
  3. Aiming at the problem that the seeds picked up by the suction plate of the seed metering device cannot accurately fall into the seed pit opener as well as into the seed pit, an innovated seed metering device on which the seed dropping angle can be adjusted within a certain range and a new testing stand have been developed in accordance with the mathematical calculation model that had " in accordance with the mathematical calculation model that had been established previously. then an experimental study is conducted and the seed dropping law has been found out through the study

    本論文根據2bqm - 2型氣吸式精量鋪膜播種機的結構和工作原理，針對該機在實際播種中，吸種盤吸出的種子不能滿足準確地落入在膜上滾動開穴的鴨嘴內，並及時地排入到鴨嘴所成的穴孔內的設計要求，進行了一定的試驗研究，利用已建立的計算數學模型，設計新的試驗臺，改進排種器，使排種器的落種角度可以在一定的范圍內調整。
  4. Standard test method for determination of chlorinated organic acid compounds in water by gas chromatography with an electron capture detector

    通過伴有電子俘獲檢測器的氣相色譜法測定水中氯化有機酸成分的標準試驗方法
  5. Fixed capacitors for use in electronic equipment - methods of test

    電子設備用固定電容器.第1部分:試驗方法
  6. In order to investigate the unsteady flow frequency domain performances of an axial flow compressor at different mass flow, rotating speed and blade row spacing, plus inlet flow distortion, and considering aerodynamic characteristics and stability of the compressor, the low speed research compressor ( lsc ) at college of energy and power in nuaa is used to carry out the experiment studies. a large amount of test data has been gained through dynamic pressure transducers embedded in the stator blades at the tip, middle and hub section, then fast fourier transform algorithm ( fft ) is applied to calculate the frequency data

    為探討軸流壓氣機在工作流量、工作轉速及動?靜葉排軸向間距變化時的葉片排流場非定常頻譜特性變化規律，並耦合進氣畸變的影響，同時與壓氣機氣動性能和氣動穩定性相關聯，作者利用南京航空航天大學能源與動力學院的低速大尺寸軸流壓氣機（ lsc ）試驗器，採取在靜子葉片表面埋入動態壓力傳感器的實驗方法，對葉尖、葉中和葉根三個截面的動態壓力進行了測量，獲得了大量的可靠的實驗數據。
  7. Test methods for determining hermeticity of electron devices with a helium mass spectrometer leak detector

    用氦質譜儀檢漏器測定電子元件密封性的試驗方法
  8. Testing of ion exchangers - determination of the total capacity of anion exchangers

    離子交換器試驗.陰離子交換器總效能測定
  9. Testing of ion exchangers - determination of the total capacity of cation exchangers

    離子交換器試驗.陽離子交換器總效能測定
  10. The simulated test of the mechatronics soft start equipment is made regarding the experimental platform of belt conveyor as load, the sensor design is had for selecting type, the testing datum are gatherd and analyzed, the rational curve of velocity in the starting and braking progress are gained, the best matching ratio of driving power for the double asynchronous moters is found

    以帶式輸送機實驗臺為負載進行了機械電子式軟起動裝置的模擬試驗，對傳感器進行了選型設計，對試驗數據進行了採集與分析，確定了合理的起、制動速度曲線，求出雙電機驅動功率的最佳配比。
  11. Two new methods have been put forward to estimate the reliability characteristic parameter. a software package has been developed to process the data obtained from reliability testing for electric apparatus. it consists of both the determination of failure distribution and the estimation of reliability characteristic parameter

    最後，設計出電器可靠性試驗數據處理軟體包，此軟體包含了產品失效分佈類型的確定和可靠性試驗結果為大子樣、小子樣、無失效數據時可靠性特徵量的估計方法，以及恆定應力加速壽命試驗數據下的可靠性特徵量的估計方法。
  12. Standard guide for selection and use of neutron sensors for determining neutron spectra employed in radiation - hardness testing of electronics

    電子輻射強度試驗中中子波譜測定用中子探測器的選擇和使用標準指南
  13. Methods of test for petroleum and its products - petroleum products and used oils - determination of pcbs and related products - separation and determination of selected pcb congeners by gas chromatography using an electron capture detector

    石油及其製品試驗方法.石油產品和用過的油. pcbs及相關產品的測定.通過帶電子俘獲探測器的氣相色譜法分離和測定選定的pcb同種類物
  14. The outcome shows that such digital electronic speed governor is in possession of stable timing rate of 1. 0 % and instantaneous timing rate of 6. 2 %. and it is worth a wide popularization for its simple structure and low cost

    在對hondagx31汽油機進行了大量試驗后結果表明：在標定轉速6000r min時，該電子調速器可以達到1 . 0的穩態調速率和6 . 2的瞬態調整率，優于國家標準的要求。
  15. The tests of e - o applications by our flux ktp has been realized, the results showed : optical waveguides fabricated by using an ion - exchange process, which have an exchange - ion concentration depth profile and refractive - index profile, is close to a complementary error - function distribution, optical homogeneity and device thermal stability is much better. amplitude modulation switch formed by our flux ktp has the contrast ratio of 150 : 1 and insert loss is 2. 5 % at 1064 nm. high quality optical pulse with 1 ns width was cut successfully by using an e - o modulator from a laser pulse with 50 ns width, this modulator had run for three years, and the crystal did n ' t blackened, it showed our low conductivity flux ktp can endure high modulation voltage for a very long time

    Ktp晶體的電光應用試驗表明：用離子交換法製作的電光波導，其離子交換濃度、折射率變化符合餘弦誤差函數，光學均勻性以及器件的溫度穩定性較好；製作的強度調制電光開關，消光比為150 ： 1 ，對1064nm激光的插入損耗為2 . 5 ；製作的電光調制器用於激光脈沖整形試驗，從脈沖寬度50ns的激光脈沖削出脈寬1ns的高質量光脈沖，該電光開關經過長達三年多的使用，沒有出現晶體變黑現象，說明本實驗的低電導率ktp晶體能夠耐受長時間的調制電壓。
  16. Test method for evaluating automotive spark - ignition engine fuel for electronic port fuel injector fouling by bench procedure

    火花點燃式汽車發動機燃油電子口噴油器結垢的工作臺評定試驗方法
  17. On the basis of confirming the plan of the whole design, the technique of modern digital communication, computer and electronic technique are supplied to design the hardware of the large - scale telephone line expander and program the software, also the debugged and the tested experiment are done

    在確定總體設計方案的基礎上，本文採用現代數字通信技術、計算機技術、電子技術研製了大規模電話線路擴容器的硬體，編制了相應的運行軟體，並進行了調試和試運行試驗。
  18. The company is engaged in the distribution and sales of all sorts of r & d and qc equipment for analysis and inspection, electric measuring instruments, electronics measuring instruments, industrial calibration standard equipment, high - voltage test equipment, equipment for material analysis and inspection, teaching equipment for education, etc

    代理及銷售國內外： r & d及qc檢測設備、電機測定儀器、電子測定儀器設備、工業校正儀器、高壓試驗設備、材料分析檢驗、學校教學設備等服務。
  19. Standard test method for evaluating automotive spark - ignition engine fuel for electronic port fuel injector fouling by bench procedure

    Bench法評定電子口燃油噴射器結垢情況用汽車火花點燃式發動機燃油的標準試驗方法
  20. On the basis of investgation on the related literature of electronic speed governor at home and abroad, this proper control parameters are obtained through the experimental research of the pid digital control parameters with the orthogonality method and through the analysis of the speed change of gasoline engine rev. the electronic speed governor designed hereby performs its controlling fuction through programs, the stable rev and static timing rate of which are also set and controlled by software, has, therefore large universality and function flexibility. so for different types of gasoline engines, the obtainment of relevant parameters and the designing of relevant programs suffice to realize the control functions of the electronic speed governor

    本文在分析研究國內外有關電子調速器的基礎分析方法及其研究狀況的基礎上，採用pid數字控制，並用正交試驗方法對pid數字控制的控制參數進行試驗研究，得到了合適的控制參數。所設計的電子調速器是靠控制軟體來實現調節和控制功能，穩定轉速、穩定調速率等都可以進行程序設定控制，具有很強的通用性和功能擴展能力。對不同型號的汽油機，只要經試驗取得合適的控制參數，編制出相應的控製程序，就可以使用此電子調速器進行轉速控制。
分享友人
分享到 Line

分享到臉書