實測溫度 的英文怎麼說

中文拼音 [shícèwēndù]
實測溫度 英文
measured temperature
  • 實 : Ⅰ形容詞1 （內部完全填滿 沒有空隙） solid 2 （真實; 實在） true; real; honest Ⅱ名詞1 （實際; 事實...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 溫度 : [物理學] temperature
  1. 2 the theoretical values of the second virial coefficient are precisely fitted into some simple expressions. according to one of them, a new temperature function for the quadratic terms in cubic equations was derived : the function is simple, general, without acentric factor, truly predictive, theoretically sound, and applicable to all the van der waals - type equations

    2將第二維里系數的理論值較精確地擬合為幾種簡單的表達式，並據此導出了立方型狀態方程中二次項溫度函數的新形式該式簡單、通用，不含偏心因子，具有真正的預測功能和堅實的理論基礎，原則上適用於所有vanderwaals型方程。
  2. The thesis has summarized the development of the oblique - pull bridge, its construction technology and the importance of bridge construction control, then has introduced project general situation, and has narrated detailed regulation, organization construction, the major work and difficult part of this bridge construction control. the following is the key part of this thesis, firstly, it has introduced the experiment work of early stage, structural calculation and its theoretical result : the absolute altitude of each operating mode, the absolute altitude of building mould in each section and the absolute altitude after pouring concrete ; then, it has discussed the method and content of the line shape control of the main beam, actual absolute altitude of building mould is put forward, and it has described the method of structural stress monitoring, how to arrange measure point and collect data, and how to analyze data. it has also narrated the method of rope force detection and structural temperature inspection

    本論文在總結了斜拉橋的發展及其施工工藝，並指出了橋梁施工控制的重要性之後，簡要的介紹了工程概況，敘述了炳草崗金沙江大橋監控細則、組織機構及監控的主要工作和難點部分；論文的核心部分，在介紹了炳草崗金沙江大橋施工控制與監測工作的前期實驗工作和施工各工況標高、各節段支模標高、澆注混凝土后的標高的結構計算和其理論計算結果之後，詳細論述了主梁的標高線形控制方法和內容，實際支模標高的提出，結構應力監控的方法、布點、測讀及其對測讀數據的合理分析方法，索力檢測和結構溫度監測的方法。
  3. The box beam ' s temperature stress of longitudinal direction and transverse direction with different conformation are analyzed, it finds that there is largish temperature tensile stress in the bottom of top deck and the haunch of box beam increase temperature tensile stress in the bottom of top deck. the paper makes a study of different thermal effects resulted from several kinds of closed rigid frame

    根據大量實測溫度場結果建議採用一個有利於理論推導的指數函數的公式來擬和箱梁體內的溫差分佈，既貼近實測數值，計算又比較簡單；通過對空腹式剛架拱橋尤溪洲大橋所在地夏季、秋季、冬季的溫度場及溫度應力的實測，以及與本文所提出計算方法的理論解進行的分析比較，證實了本文計算方法的正確，同時改進了已往混凝土箱梁溫度自應力的計算方法。
  4. Summarize : multi - input, can be used cooperate with various sensors / transducers, measure 、 display and alarm control the physical quantities such as temperature 、 humidity 、 liquid level and flux # 118alues and transform them to export, can read and write all parameters via the computer through serial communication, besides it can offer 24vdc power supply for 2 - wire transducers, four - bit led displaying, the multi - segment curve correcting function is selectable, one meter can equip four alarm relay outputs 、 one transform ( or communication ) output and one equipped power supply outputs

    萬能輸入，可與各類傳感器、變送器配合使用，實現溫度、濕度、壓力、液位、流量等物理量的測量、顯示、報警控制和變送輸出；通過串列通信口，可在上位計算機中實現全部儀表參數的讀寫；還可為兩線制變送器提供24vdc電源； 4位高亮度led數字顯示；對輸入信號有多段折線修正功能可選；一臺儀表最多可配4個報警繼電器輸出、一路變送（或通信）輸出和一路配電輸出。
  5. Due to temperature performance of fbg, a reference fbg is adopted to compensate temperature and the compensation principle is expounded. moreover, this scheme not only realizes temperature compensation but also reduces repeatability error of ffptf and errors from power fluctuation of light source, noise of pd and noise of electro - circuit. in the end, temperature and strain performance of fbg is tested and

    基於光纖光柵的溫度響應特性，提出用一個參考光柵來進行光纖光柵傳感陣列溫度補償的設計方案，並論述了其補償原理，證明了該方法的可行性；同時可以看出，該方法不僅可以實現溫度補償，也可以減小光纖f - p可調諧濾波器的重復性誤差以及光源功率波動、探測器噪聲和電路噪聲等引起的誤差。
  6. Examine the warm triangular awl composition and adopt mineral raw materials to compound, its physics performance and ceramic glaze medicine are self - same, utilize fire - resistant degree of it as melt temperature of pouring, in cooking, set according to the operation instructions free in examined warmly position in products, can examine to the actual temperature of the products ( can be observed with the naked eye ), especially push away and pull the kiln, tunnel kiln, drawer kiln observe temperature must spend products, general difference in temperature 5 - 10 degrees centigrade, please and soften some forms of contrasting according to the operation instructions, serial number before using

    測溫三角錐成分採用礦物原料配製的，它的物理性能與陶瓷釉藥完全相同，利用它的耐火度作為熔倒溫度，在產品燒成中，按使用說明放在所測溫的位置，可測到產品的實際溫度（用肉眼可觀察到） ，尤其是推扳窯、隧道窯，抽屜窯內觀察溫度必用產品，一般溫差5 10 ，使用前請按使用說明、編號及軟化點對照表。
  7. According to the structural characteristics and process requirement of ceramic kiln, we design the control system based on personal computer and single micro controller, realizing the control system and control over temperature and pressure and medium

    根據陶瓷窯爐的結構特點和生產工藝要求，本文採用上下位機相結合，設計了陶瓷窯燒成過程式控制制系統，實現溫度、壓力和氣氛的在線測量和監控。
  8. Aiming at mulongtan hydropower station, this paper introduces the meaning of and protection about the temperature of hydro - generating units, the system composition, the configuration and work elements of sensors anti instrument, the means of realization with plc for temperature protection, and puts forward several measure of enhancing the temperature control system

    摘要水輪發電機組溫度的監測是機組安全運行的重要保證，是水電站計算機監控系統監測的重要參數，介紹了木龍灘水電站水輪發電機組溫度測量和溫度保護系統的一般組成模式，測溫傳感器、儀表的配置與工作原理，及採用plc實現溫度保護的方法，並提出了提高溫控系統可靠性幾點措施。
  9. The actual temperature measurement is done by measuring the pressure

    測量壓力就可以測得實際溫度。
  10. The problem of monitoring the wear - line of a blast furnace is treated as the inverse problem of the static heat conduction system, and the latter has been turned into the optimization of the squared residual of the measured and calculated temperature at the sensor locations

    摘要把確定高爐爐缸爐底熱侵蝕邊界歸結為穩態熱傳導方程的反問題，並轉化為極小化在若干測溫點處由設定侵蝕邊界對應的偏微分方程邊值問題求得的溫度與實測溫度之間誤差的優化問題。
  11. ( 3 ) the saturated temperature of refrigerant - oil mixture has different definitions because of the superheat temperature of the mixture. one is the real saturated temperature of the mixture and the other is the saturated temperature of pure refrigerant corresponding to the tested pressure of the mixture. in this paper, the heat transfer coefficients based on the two different saturated temperatures are compared and the results showed the latter is larger

    （ 3 ）由於製冷劑含油混合物過熱溫度的存在，使其具有兩種不同的飽和溫度定義，一種是所測實際溫度，另一種是所測壓力對應純工質的飽和溫度，文中就這兩種飽和溫度定義下的冷凝平均換熱系數進行了比較，發現後者大於前者。
  12. Multipoint wireless real time temperature detection system based on gprs

    的多點無線實時溫度檢測系統
  13. 2. the sign of temperature is by extracted mini - thermal - electronic - couple transducer, and amplified by preamplification circuit and main magnifier. the processed data are sent to the computer after a / d conversion, which is displayed in curve form through the software controlling panel built by delphi 3

    設計製作了無失真、抗干擾的溫度信號檢測電路，實現了加熱過程的實時溫度監測，尤其解決了以往由於金屬材料在微波場中的熱傳導及歐姆熱效應而引起的干擾問題。
  14. By ansys, we can build temperature - calculating modes of p. c box girder t and then calculate the effect of temperature fields on the stress and the line deformation. 3. adopt the spot - measure method

    2 、用ansys建立預應力混凝土箱梁t構的溫度計算模型，由實測溫度給定邊界條件，分別計算出溫度對預應力混凝土箱梁t構撓度的影響以及對預應力混凝土箱梁截面應力的影響。
  15. In addition, put forward a sensing scheme and solution of cross - sensitivity of fbg measurements which uses the matching performance fiber grating - pair

    此外，本文提出了一種用兩個性能匹配的光纖光柵實現溫度與應變同時測量的傳感方案。
  16. From error of trapezia quadrature and hardware design of calorimeter, we introduce sampling factor to obtain factual temperature and adopt shorter interval to perform cooling emendation. the appropriate interval is confirmed through thermal capacity demarcating and caloric measuring experiments

    從梯形法求解定積分的誤差出發，結合恆溫式氧彈儀硬體電路設計的具體情況，引入采樣因子來準確獲得測量過程的實際溫度，並採用較小的時間間隔進行冷卻校正的計算。
  17. Then, the model of house is set up with system identification method after the model has been analyzed in theory

    根據所建立的數學模型對階躍響應的模擬結果和實測溫度進行比較，從中可以選擇所需精度的數學模型。
  18. As practical engineering examples the poper has shown the analyses oncrack control in two mass concrete structures by use of the procedure mentionedabove, in which the transient temperature fields were obtained from the results bythe finite difference method or the temperature curves measured in construction

    作為實例，本文採用實測溫度曲線求得瞬態溫度場，按上述步驟對北京地區兩個大廈基礎進行了抗裂分析，結果與實際情況相符，未發現裂縫。
  19. As practical engineering examples the paper has shown the analyses on crack control in two mass concrete structures by use of the procedure mentioned above, in which the transient temperature fields were obtained from the results by the finite difference method or the temperature curves measured in construction

    作為實例，本文採用有限差分法及實測溫度曲線求得瞬態溫度場，按上述步驟對寧波地區兩個大廈基礎進行了抗裂分析，結果與實際情況相符，未發現裂縫。
  20. On some reasonable assumptions, the existence and the uniqueness of the solution of partial differential equation are proved by using the semigroup theory ; then based on the current basin temperature from the practical survey, the mathematical model about the identification problem is established, and the identifiability and the existence of the optimal solution of the identification problem are proved ; in terms of the adjoint method presented by chavent, the optimality condition of the identification problem is given ; finally the corresponding algorithm is devised

    在適當的假設條件下，利用運算元半群方法證明古地溫度場方程解的存在惟一性；根據現今實測溫度，建立了問題的參數識別模型；證明了可識別性、最優解的存在性；利用chavent等人提出的伴隨方法，給出參數識別問題最優解存在的最優性條件和求該參數識別問題的演算法。
分享友人
分享到 Line

分享到臉書