實用腐蝕試驗 的英文怎麼說

中文拼音 [shíyòngshíshìyàn]
實用腐蝕試驗 英文
service test
  • : Ⅰ形容詞1 (內部完全填滿 沒有空隙) solid 2 (真實; 實在) true; real; honest Ⅱ名詞1 (實際; 事實...
  • : Ⅰ動詞1 (使用) use; employ; apply 2 (多用於否定: 需要) need 3 (敬辭: 吃; 喝) eat; drink Ⅱ名...
  • : Ⅰ名詞(豆腐) bean curdⅡ動詞(腐爛; 變壞) decay Ⅲ形容詞(腐爛) rotten; corroded; putrid
  • : Ⅰ動詞1. (損失; 虧耗) lose 2. (腐蝕) erode; corrode Ⅱ名詞(天體現象) eclipse
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 腐蝕 : 1 (通過化學作用使物體逐漸消損破壞) corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  • 試驗 : trial; experiment; test
  1. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵摩擦零部件材料發展的需要,在室摩擦磨損機上研究了按環/塊線接觸方式作往復運動條件下的碳化硅和氧化鋁基陶瓷材料摩擦副在水、化學性介質作潤滑劑和無潤滑時室溫下的摩擦磨損特性。
  2. In order to make integration of theory with practice, a lot of experiments have been done. mask - making technology, photoetching and wet - etching processes have been optimized. the author also presents the application and commercial value of silicon v - groove arrays

    踐上,對製作工藝積極探索,提出新的制備硅掩蔽膜的工藝方案,對影響光刻質量的因素深入分析,摸索出適於v型槽的各向異性濕法液配方,獨立優化設計了製作硅v型槽的相關工藝,製作出高質量的硅v型槽。
  3. Based on the test data of the crc beams taken from some chemical plants, which were mainly corroded by chloride, a calculation model was derived to calculate the ultimate load bearing capacity of such crc beams. then, bp nn model was built up to predict the ultimate load bearing capacity of crc beams. using such nn model to analyze many groups of test data ( under various corrosion cases ), satisfactory results are achieved

    基於目前較少開展的環境下鋼筋混凝土構件受力性能的研究,通過引入受混凝土和銹鋼筋的損傷因子導出了受氯離子鋼筋混凝土構件極限承載力計算模型;建立了bp神經網路模型對受鋼筋混凝土梁承載力進行了預測,通過對多組國外研究結果(不同情況下)的分析均取得了令人滿意的預測結果,並且隨著資料的積累,預測效果可以得到進一步的改善;因此,本文建立的神經網路模型對受鋼筋混凝土構件承載力研究是一種十分有效的方法,具有較好的應前景。
  4. The specific methods : 1. to ascertain five control indications including suspended solid content, grain diameter median, oil content, iron bacteria and saprophytic bacteria by carrying out the experiment of core flow ; 2. to ascertain indications of sulfate reducing bacteria and average corrosion rate by carrying out the experiment of revolving corroded test pieces ; 3. to ascertain indications of average scaling rate and total mineralization degree by carrying out the experiment of scaling prediction and sensibility

    具體的做法是:採巖心流動確定懸浮固體含量、顆粒直徑中值、含油量、鐵細菌和生菌五項控制指標;採旋轉掛片確定硫酸鹽還原菌和平均率指標;採結垢預測和敏感性確定平均結垢率和總礦化度指標。
  5. Beams are researched, and the relation between strains of corroded re - bars and fatigue life of beams are obtained. the main research contents and conclusions are as following : 1. under the fatigue loads, the overstrain of concrete approximately coincidences three stages strain development and accumulation rule, and the mechanical property of concrete is deteriorated

    鑒于際工程中大量存在鋼筋混凝土結構承受反復荷載作,但其力學性能研究不多的問題,本論文進行了銹鋼筋混凝土梁抗彎疲勞,研究了應力比和鋼筋銹率對銹鋼筋混凝土梁抗彎疲勞性能的影響,得出了銹鋼筋的應變與構件疲勞壽命之間的關系曲線,主要研究內容及結論如下: ( 1 )在循環荷載下,混凝土殘余變形基本符合三階段變形規律,力學性能劣化,疲勞損傷積累。
  6. Comparing the results which were obtained when the reagent and temperature and time varied, we found the dislocation was displayed very clearly and accurately when we etch with koh at 290 for fifteen minutes, which was the best condition

    進行了不同溫度、不同的劑以及不同的時間條件下的缺陷顯示。發現,熔融的koh劑在290下15分鐘時,顯示的位錯最為清晰、準確,效果最佳。
  7. Abstract : iron - based alloy aluminum liquid maceration experiment is done. transmission ele ctron microscope ( tem ) and energy dispersive spectrometer ( eds ) are employed to in vestigate the characteristics of microstructure and the distrbution of compone nts. based on fe - al alloy phase diagram and the experiment results, a model is propo sed for iron - based alloy aluminum erosion

    文摘:進行了鐵基合金鋁液浸,利透射電鏡和能譜儀對樣進行微觀組織觀察和成分分析,結合鐵鋁相圖和結果.論述了鐵基合金鋁液過程
  8. As for chemical and medical laboratory, chemical corrosion - resistant function should be considered first since the overall work environment, including spills, corrosive reagent & solvents and overses & other improper handlings, etc., may do a certain harm to the furniture, which requires that our furniture should be firm and enduring

    對于化學、醫學室而言,耐化學是首先要考慮的功能,其整體的工作環境對于其內的家具有一定的損害性,如各種濺出物、劑及溶劑、超負荷使及其他不當使等,這就要求我們的室傢具必須堅固耐
  9. Making test of waterpower removal in the condition of different flow, pressure and pipe caliber, and also analyses the strength, steady, duration, safety and corrosively resistance, and testing and verifying the used composite energy removal construction, and the writer gives suggestion to improve the technology and construction

    進行了不同流量、壓力和管徑條件下的消能水力,並對其強度、穩定性、耐久性、安全性和抗性等進行了綜合分析,對已的綜合式消能構築物進行了證和復核,提出了工藝、結構改型建議及推廣適范圍。
  10. Based on theoretical analysis, experimental and field test data, the method of durability evaluation and service life prediction of reinforced concrete structure exposed to chloride environments are studied in the paper

    論文採理論分析與工程測和數據分析相結合的方法,圍繞氯環境混凝土結構的耐久性和壽命預測進行了系統的研究。
分享友人