寬度計 的英文怎麼說

中文拼音 [kuāndùjì]
寬度計 英文
width gauge
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  1. There are five natural sample zones of adiantum reniforme l. var. sinense y. x. lin investigated, and recorded 34 species. 10 dominant species were used to calculate the niche width of populations and the niche overlap interpopulations

    調查了5個自然樣地，記錄了34個伴生種，取10個優勢種進行種群生態位寬度與生態位重疊的計算。
  2. Based on the real situation of submarine and antisubmarine warfare ( asw ), according to the classical design theory of transducer or transducer array, a sonar will be researched and made, which has the feature of more wider bandwidth, more lower operating frequency, more lager radiation acoustic power, more farther operating distance, more higher researching efficiency and more higher directive accuracy

    本文根據現代潛戰和反潛戰（ asw ）的實際情況，按照經典的換能器和基陣的設計理論，研製聲吶，旨在擴展其頻帶寬度、降低其工作頻率、增大其發射功率、擴大其作用距離以及提高其搜索效率和定向準確度。
  3. The average fission width can be obtained from a statistical argument.

    能夠從統計理論得到裂變寬度。
  4. For hoods with shutters in four sides, the results show : 1 ) the hoods positively placed boards are called hoods used for venting airflow ; hoods negatively placed boards are called hoods used for leading airflow ; 2 ) among the hoods used for venting airflow, the most effective hoods should have positive declining angle value of 30, the ratio 4 of areas between the four windward faces and the gular section ( fy / fj = 4 ), the value of b range from 70 mm to 120 mm and the value of b / h range from 0. 5 to 0. 6 ; 3 ) the most effective hoods should have negative declining angle value of 60, the ratio 4 of areas between the four windward faces and the gular section ( fy / fj = 4 ), the value of b range from 100 mm to 170 mm ( the optimum value is 120 mm ) and the value of b / h range from 1. 4 to 2. 2 ( the optimum value is 2. 0 )

    對於四面設百葉型風帽，計算表明: l ）正裝傾斜擋板的百葉型風帽可認為是排風型風帽，倒裝擋板傾斜的百葉型風帽可認為是進風型風帽; 2 ）排風型風帽中，擋板正裝30 」 、風帽四個迎風面的有效面積fy和風管凈斷面積fj的比值（ fy腸）為4 、擋板寬度b在70inln到120inln之間、板間距比值隴在0 . 5到0 . 6的百葉型風帽排風效果最好; 3 ）進風型風帽中，擋板倒裝裝60 「 、風帽四個迎風面的有效面積和風管凈斷面積的比值（ fy例）為4 、擋板寬度b在100咖到170mm之間（ 120mm為最佳） 、板間距比值隴在1 . 4到2 . 0的進風型風帽（ b爪= 2 . 0為最佳）的百葉型風帽進效果最好。
  5. Corneal surfaces in eyes with regular astigmatism are thought to be toroidal surfaces. based on mathematical models for corneal surfaces before and after treatment, a corneal ablation model is given for such refractive errors as spherical myopia, compound myopic astigmatism, and simple myopic astigmatism. a similar corneal ablation model is also given for such refractive errors as hyperopia, compound hyperopic astigmatism, and simple hyperopic astigmatism

    採用超環面（ toroidalsurface ）建立起規則散光下的角膜曲面模型方程;定量研究了手術光學區屈光不正兩種通用的矯正模型，一種模型適用於單純近視、復性近視散光、單純近視散光的矯正，另一種模型適用於單純遠視、復性遠視散光、單純遠視散光的矯正;另外，作為影響手術效果的重要因素，提出了一種用於光學區直徑和過渡區寬度均可調節時過渡區角膜切削量的計算模型。
  6. The deliberation of calculating concrete crack width for steel lined reinforced concrete penstock

    鋼襯鋼筋混凝土壓力管道混凝土裂縫寬度計算問題的商榷
  7. Calculating crack width of penstocks with inner steel liner and reinforced concrete due to its internal pressure

    內壓作用下鋼襯鋼筋混凝土壓力管道裂縫寬度計算公式
  8. The formulas on crack width of rc beams and src beams are analyzed at home and abroad too. the calculation formulas on the maximum crack width of src beam under short time load are suggested. the calculation result tallies that of tests well

    分析比較了國內外鋼筋混凝土梁和勁性鋼筋混凝土梁裂縫計算公式，提出了勁性鋼筋混凝土梁在短期荷載作用下的最大裂縫寬度計算公式，其計算值與試驗值吻合較好。
  9. ( 3 ) to discuss thereasonable section shape of the continuous composite beam. the works of this paperare as follows : ( 1 ) contrast the cracking course of the concrete beam and the composite beam, atthe point of the bending state of the beams, put forward the crack width mode : bending curvature 、 crack height 、 the distance between crack

    據此，本文的主要研究成果如下: （ 1 ）通過分析、對比普通混凝土梁和組合梁負彎矩區裂縫出現、發展過程，以構件受彎狀態為出發點，提出了以彎曲曲率、裂縫高度、裂縫間距為主要參數的裂縫寬度計算模式。
  10. In addition, the calculating methods about the gap of the connectors and the maximum width of crack are discussed in the thesis

    另外，作者對組合梁剪力連接件的設計理論及組合梁最大裂縫寬度計算方法作了逐一地探討。
  11. Abstract : simplifying the formula in code for concrete structure design ( gbj10 - 89 ), we obtaine the appoximate formula of crack width, that is used to the beam of rectangular section in design

    文摘:對《混凝土結構設計規范》 （ gbj10 - 89 ）中的裂縫寬度計算公式進行化簡，得出矩形截面梁裂縫寬度實用計算公式，供工程設計時使用。
  12. The above fruits may be of important theoretical significance and of practical value for reasonably using the results of model test of reinforced concrete structures to forecast and judge the character of crack development of prototype structures and for founding more reasonable calculating formula of crack width henceforth

    上述研究成果有益於合理利用鋼筋混凝土結構模型試驗的結果預測和評判原型結構的裂縫開展情況，及建立更為合理的裂縫寬度計算公式。
  13. ( 2 ) base on the crack width mode, separately establish formula of the bendingcurvature 、 crack height 、 the distance between crack, and compost the formula of thecrack width. and put the experiment data of others literature into the formula, thecalculated result also show good agreement with the experiment data

    （ 2 ）在上述模式的基礎上，分別建立使用荷載下曲率計算、裂縫高度取值及裂縫間距計算的公式，由此形成最終裂縫寬度計算公式，該公式概念清楚、計算簡單，並引用其他文獻的試驗數據代入公式，計算結果與試驗數據吻合較好。
  14. Magnetic scale width meter gauge

    磁柵式寬度計
  15. This article analyzes the difference of theories calculating the effective width between chinese code and north american codes. the author finds the results based on the technical code for design of cold - formed thin - wall steel structure is lower than that of north american codes, especially for flat plate with relatively larger width - thickness ratio whose thickness is thinner than 2mm, the difference is more obvious

    本文分析了國內外關于冷彎型鋼屈曲后強度的有效寬度計算理論，通過理論分析和計算對比發現，按我國《冷彎薄壁型鋼結構技術規范》計算的板件有效寬厚比值較北美規范低，特別是對于厚度小於2mm的大寬厚比板件，其差異更明顯。
  16. Photoelectric width meter gauge

    光電式寬度計
  17. A discussion has been done on the limit width of double holes, moment holes, circular ring and disc so that the coefficients of light sources are calculated

    摘要分析了雙孔（雙縫） 、矩孔（線） 、圓環及圓盤光源的極限寬度，計算出這些光源的光源系數。
  18. According to the width of strip noises, the frequency band corresponding to the strip noises can be figured out. thus, after wavelet transform, by setting proper wavelet coefficients zero, the strip noises can be removed effectively. ideal result has been obtained in the practical processing to 0 - level data of cbers - 1

    根據條帶干擾的寬度，計算出這種寬度對應的信號分支的頻率，然後將原遙感圖像在小波變換后對應于該頻率的小波分支系數有選擇地設置為零，有效地消除了條帶干擾。
  19. Solid scanning width meter gauge

    固體掃描式寬度計
  20. Calculation of the reliabitity index of the concrete structure based on the maximum crack width

    基於最大裂縫寬度計算混凝土結構的可靠度指標
分享友人
分享到 Line

分享到臉書