射電透熱法 的英文怎麼說

中文拼音 [shèdiàntòurèfǎ]
射電透熱法 英文
radiothermics
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 透 : Ⅰ動詞1 （滲透; 穿透） penetrate; pass [seep] through 2 （暗地裡告訴） tell secretly; let out; lea...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  1. In chapter two, we fabricated r - ni - fe / al2o3 nanocomposites successfully by using ball - milling mixing method plus hot - pressing process. meanwhile, their microstructures are characterized by x - ray diffraction ( xrd ) analyser, transmission electron microscopy ( tem ), field emission scanning electron microscopy ( fe - sem ) and brunauer - emmett - teller ( bet ). the results indicate that ni - fe particles are homogenously dispersed in the matrix in the composites

    在第二章中，我們採用高能球磨混合方法加上熱壓燒結工藝，成功制備了ni - 20fe al _ 2o _ 3納米復合材料，並通過x射線衍射儀（ xrd ） 、透射電鏡（ tem ） 、場發射掃描電鏡（ fe - sem ） 、比表面孔隙儀（ bet ）對該復合材料的微結構進行了表徵。
  2. In this paper, the property difference of sio2 sols used for preparing thin films by esam method or sol - gel process has been discussed. three kinds of sio2 sols were prepared, catalyzed by hcl or nh3 h2o only, or hcl first and then nh3 h2o respectively ( please note : in following text, the sio2 sol catalyzed by hc1 first and then nh3 h2o and its correspondent films will be named sio2 sol 1 # and film 1 ; the sio2 sol catalyzed by nh3 h2o only and its correspondent films will be named sio2 sol 2 # and film 2 # ). through investigating the assembling properties of the sols, observing thin films " microscopic structure with tem and testing their transmissivity with 721 spectrophotometer, we find that the first kind of sol is not suitable for preparing esam films, but the last two, i. e. sol 1 # and sol 2 #, are good

    本文討論了esam法制備薄膜所用的溶膠與sol - gel法所用的溶膠在性能上的區別，在hc1或nh _ ? h _ 2o分別單獨催化和hc1 nh _ 3 ? h _ 2o分步催化三種催化條件下制備了sio _ 2溶膠（以下規定hc1 nh _ 3 ? h _ 2o分步催化的sio _ 2溶膠為1 ~ #溶膠，相應的薄膜為1 ~ #薄膜， nh _ 3 ? h _ 2o催化的sio _ 2溶膠為2 ~ #溶膠、相應的薄膜為2 ~ #薄膜） ，在通過組裝薄膜並用透射電鏡（ tem ）觀察薄膜微觀結構以及用721分光光度計測試樣品的光透射率，得出了后兩種催化方法所制備的溶膠適合於esam法鍍膜，而第一種溶膠不適于用此法鍍膜的結論，用傅立葉紅外光譜（ ft - ir ）研究了溶膠組成；用差熱失重分析儀（ dta - tg ）對膠體進行了熱分析。
  3. Powders properties of different phases such as the granularity, the shape and the component have been analyzed by the methods of sieving, gravity sedimentation, spectrophotometry, scan electronic microscope ( sem ), transmission electronic microscope ( tem ) and x - ray diffraction ( xrd ). the results show that technic of ball milling and parameters of heat treatments are important influencing factors to properties of cu - zn powders

    採用篩分法、重力沉降法、分光光度法、掃描電鏡法、透射電鏡法和x射線衍射法對不同階段的銅鋅粉末的粒度、形貌、成分等性質進行了分析，結果表明：球磨工藝及熱處理參數對銅鋅粉的性能有重要影響。
  4. In this thesis, the physical properties of a series of na2fepo4f cathode materials synthesized by various routes are instigated and discussed in the light of structural ( xrd ), thermal ( dta ) analyses and particle size distribution. their microstructures were studied by transmission electron microscope ( tem ) and scan electron microscope ( sem ). the electrochemistry property were evaluated with cells containing the synthesized na2fepo4f as positive electrode

    本文將藉助x -射線衍射、掃描電鏡、透射電鏡、差熱分析以及電化學測試等方法，系統研究多種制備法對所合成的鈉離子二次電池正極活性材料氟磷酸亞鐵鈉的微結構以及循環可逆容量、循環伏安性能、交流阻抗譜的影響。
  5. Catalysts were prepared by impregnation reduction, thermal reduction, advanced thermal reduction and sol - gel methods from these metals. electrochemistry measurements, xrd, tem were used to test these catalysts. the results showed that these metals have some electrocatalysis activities towards hydrogen oxidation reaction

    本文選擇了w 、 mo 、 co等金屬，採用浸漬還原法、熱還原法、改進的熱還原法以及溶膠凝膠法分別制備了這幾種金屬的碳載催化劑，對制備出的非貴金屬催化劑進行了電化學測試、 x -射線衍射（ x - raydiffraction ， xrd ） 、透射電子顯微鏡（ transmissionelectronmicroscopy ， tem ）等測試，研究結果表明:這些非貴金屬在硫酸體系中對氫氣的氧化反應均有一定的催化活性。
  6. The performance of high and low temperature was improved simultaneity because the materials of modified asphalt had structure of the undee samdwich. the modified asphalt was characterized by element analysis, tem, xrd, tg and ft - ir. we discussed the possible mechanism of the modification

    另外，還採用了透射電子顯微鏡（ tem ） 、 x射線衍射（ xrd ） 、熱重摘要分析（ tg ） 、紅外光譜分析（ ft - ir ）等分析方法對改性瀝青進行了表徵，探討了可能的改性機理。
  7. The synthesis process of swnts by catalytic chemical vapor deposition ( ccvd ) was investigated and the product was characterized by transmission electron microscopy ( tem ), thermo - gravimetric analysis ( tga ) and raman scattering spectra and so on in this thesis

    本文研究了單壁納米碳管的化學氣相沉積法制備工藝，並運用透射電子顯微鏡（ tem ） 、熱重分析（ tga ）與拉曼（ raman ）光譜等分析手段，對產物及催化劑進行了表徵。
  8. According to the significant improvement in properties of ions and particles doped perovskite, tb and cnt doped pt materials were prepared, and the properties studied. tb and cnt doped pt powders and films were successfully prepared by sol - gel method. by differential thermal analysis ( dta ), scanning electron microscopy ( sem ), transmission electron microscopy ( tem ), x - ray diffraction ( xrd ), fluorescent analysis and dielectric constant analysis, the morphology and phase transformation, crystalline properties, fluorescent properties and dielectric properties of the materials were studied

    本研究中採用溶膠凝膠法制備了具有優良結晶性能的稀土離子tb及納米碳管摻雜的鈦酸鉛（ pt ）超細粉末和（ 100 ）取向生長的薄膜，並利用差熱分析、掃描電子顯微鏡、透射電子顯微鏡、 x射線衍射、熒光分析和介電常數等多種分析測試手段對摻雜后的pt薄膜及超細粉末的相結構、光學性能、結晶性能以及介電常數等進行了研究。
  9. The modified asphalt may be looked upon materials for highway road. the sea and island structure which the island lied in the sea and the sea lied in the island of the modified asphalt was characterized by sem. the modified asphalt was characterized by element analysis, tem, afm, gpc, tg and ft - ir

    通過掃描電子顯微鏡（ sem ）分析表明改性后瀝青呈島中有海、海中有島的海島結構；另外，還採用了元素分析、透射電子顯微鏡（ tem ） 、原子力顯微鏡（ afm ） 、凝膠色譜（ gpc ） 、熱重分析（ tg ） 、紅外光譜分析（ ft - ir ）等分析方法對改性瀝青進行了表徵，探討了可能的改性機理。
  10. The field emission property of carbon nanotubes could be increased by substitution of nitrogen for some of carbon, however, however, that of bcn nanotubes was poor. 1. study of disordered multi - wall carbon nanotube carbon nanotubes with different diameter distributions have been produced by thermal decomposition of a ferrocene - xylene mixture under different temperatures and different catalysts in an ar ( or n2 ) / h2 atmosphere

    結合透射電鏡、掃描電鏡及拉曼光譜，系統地研究了以鈷二茂鐵為催化劑時不同溫度下、以及在860時，分別以鈷二茂鐵、鎳二茂鐵、鈷、鎳鈷不同催化劑、不同保護氣體對高溫熱解法制備的多壁碳納米管結構、產率等的影響，對產物的形態、結構進行分析。
分享友人
分享到 Line

分享到臉書