尾隨的位置 的英文怎麼說

中文拼音 [wěisuídewèizhì]
尾隨的位置 英文
following play
  • : Ⅰ動詞1 (跟; 跟隨) follow 2 (順從) comply with; adapt to 3 (任憑; 由著) let (sb do as he li...
  • : 4次方是 The fourth power of 2 is direction
  • : Ⅰ名詞1 (所在或所佔的地方) place; location 2 (職位; 地位) position; post; status 3 (特指皇帝...
  • : 動詞1. (擱; 放) place; put; lay 2. (設立; 布置) set up; establish; arrange; fix up 3. (購置) buy; purchase
  • 尾隨 : tail behind; tag along after; follow at sb. 's heels; at the tail of
  1. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd : yag激光器發展狀況、主要特性及其應用,從四能級速率方程出發,推導了ld泵浦nd : yag激光器閾值、輸出功率和斜效率表達式,並簡述了激光器工作原理、結構型式和倍頻方法;其次,以空間相關速率方程為基礎,提出了ld端面泵浦nd : yag激光器設計方法,給出了一定泵浦耦合方式下,振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑等參數選取依據,以此為依據,設計了自聚焦透鏡耦合小功率ld泵浦nd : yag激光器和透鏡組耦合高功率ld泵浦nd : yag激光器,對激光器輸出功率和功率穩定性等特性進行了實驗研究;再次,在帶纖輸出高功率ld泵浦nd : yag激光腔內插入一隻空液晶盒,觀察到了激光器以單縱模運轉;最後,根據泵浦光焦斑端面對激光輸出功率影響規律,提出了ld端面泵浦nd : yag激光移傳感新方法,並進行了理論和實驗研究,研究結果表明:當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學論文蕩光束腰半徑時,激光輸出功率自然指數與泵浦光焦斑縱向成高斯變化規律,測量范圍和靈敏度依賴于泵浦功率,著泵浦功率增加,測量范圍擴大,靈敏度提高,當端面泵浦功率為7 . 24w (最大輸出功率為1 . 926w )時,激光移傳感器測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
分享友人