工作性能 的英文怎麼說

中文拼音 [gōngzuòxìngnéng]
工作性能 英文
operational use
  • 工 : Ⅰ名詞1 （工人和工人階級） worker; workman; the working class 2 （工作; 生產勞動） work; labour 3 ...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 能 : 能名詞（姓氏） a surname
  1. Finally, the controller working based on the combination of rbf neural networks and traditional pid control was applied to in aclinic kinetic machinery and lifting machinery of tower crane. the simulation of this controller was made using matlab, and the simulation results showed that the control system has some merits, such as quick response, little overshoot, well anti - jamming capacity, and little steady - state error, etc. both the dynamic property and static characteristic of this controller are better than traditional pid controller, and meet the tower crane

    應用matlab對塔機的變幅和起升機構的運動控制進行模擬，模擬結果表明基於rbf神經網路整定pid的控制系統具有響應快、超調小及穩態誤差小等優點，其動、靜態性能優于單一pid控制，從而提高了塔式起重機工作機構的工作性能。
  2. The results of research on the workability of hbc concrete show that hbc concrete, when compared with opc concrete, has excellent compatibility with superplasticizer, in terms of better initial fluidity, less slump loss, definite saturation point and less dosage at saturation point. in addition, good mineral admixture such as i class fly ash can obviously improve the workability of hbc concrete. moreover, hbc concrete exhibits more excellent workability under the condition of low w / c ratio, which indicates hbc is more suitable for making super high strength concrete whose w / c ratio is very low

    對高貝利特水泥高性能混凝土工作性能的研究結果表明，高貝利特水泥與高效減水劑具有良好的適應性，表現為初始流動度較大，經時損失較小，具有明顯的飽和點且飽和點摻量較小；此外，優質的礦物摻和料如一級粉煤灰能明顯改善hbc混凝土的工作性能；更為突出的是hbc混凝土在低水膠比的情況下表現出更為優異的工作性，這一特性預示著高貝利特水泥更適宜配製水膠比很低的超高強混凝土。
  3. Many engineering experience demonstrate that in order to elevate subbase working properties, lower project investment, prolong pavement using life - span and raise synthetical benefic,

    大量的工程實踐表明，為了提高基層工作性能，延長路面使用壽命，必須在配合比設計時將抗裂性考慮在內。
  4. Propellant binders based on these materials have excellent mechanical properties and good performance.

    用這些材料製成的推進粘結劑的工作性能很好，而機械性能則更為突出。
  5. In this dissertation, by virtue of self - developed test system, the studies on the optical and electric properties of oled of little molecule with different material, configuration manufactured with different processes have been presented. concepts of chromatics and the mechanism of carrier transportation in the semiconductor device have been applied here to qualitatively analysis and interpret the result of measurement. some interesting conclusions have been given which will be helpful in the further optimization of the performances of oled

    在oled研究過程中，對器件性能的表徵工作起到十分重要的作用，本文利用自主開發的測試平臺（包括軟體、硬體的搭建） ，對不同材料、結構、工藝的小分子oled器件進行了光學、電學性能的測試和評估，並依照色度學、半導體電輸運等理論成功的對測試結果作出了定性分析，揭示了制約器件工作性能的相關因素，為器件性能的進一步優化奠定了基礎、指明了方向。
  6. At the same time the influence of the cavity in front of slow - wave structure and the length of a smooth drift tube which connect two sections of slow - wave structure are also studied in this dissertation

    然後利用magic粒子模擬軟體模擬了反射器對器件工作性能的影響，同時還分析了慢波系統前面的腔體以及兩段式慢波結構中過渡段的長度對器件工作性能的影響。
  7. Plasma technique was introduced in the research of high power microwave ( hpm ) sources in recent decade. the performance of hpm sources is improved much by filling plasma which is promising in this field. filled - plasma travelling - wave tubes ( fptwt ) is a part of them. it is the main task of this paper to research and design fptwt ' s electron optics system and simulate it

    近十年來，在高功率微波的研究熱潮中，引入了等離子體技術。引入等離子體能顯著改善高功率微波源各方面的工作性能，已經成為高功率微波源發展一個頗有前景的新方向，等離子體行波管即是其一個典型代表。
  8. In pumping fluid with gas, pressure boost can be improved by enhancing the pump rotation speed, thereby improving the performance of the pump to a certain degree ; when the gas content is constant, by increasing the inlet pressure, the pressure boost can be enhanced and the pump efficiency be improved remarkably ; when the gas content is rather high, there will be a problem of matching between the gas pressure and the fluid pressure ; the performance of the multiphase pump can also be improved by means of rational design of buffer vessel and homogenizer

    試驗分析認為，氣液混輸工況下，提高泵轉速可以提高增壓，在一定程度上能改善多相泵的工作性能；含氣率一定時，增加進口壓力，可使多相泵增壓值增大，泵效明顯增加，最大含氣率點后移，但含氣率很高時，存在氣液壓力相匹配問題；改進緩沖罐和均化器的設計，有利於氣液互相夾帶，避免氣囊產生，可改善多相泵的輸送性能。
  9. We require a full refund for all the equipment on the grounds that your company has misrepresented its performance capabilities.

    由於貴公司錯誤地宣傳這種設備的工作性能，我才要求償還全部設備的款數。
  10. Eventually, the digital correlator of the modificatory structure is designed and realized by fpga, and it manifests very high and reliable correlative performance

    最後用fpga晶元設計並硬體實現了修正結構的數字相關器，這種結構的數字相關器具有很好的工作性能。
  11. Static behavior of stepped t - type rhs joints

    型方管節點靜力工作性能的研究
  12. On the base of the familiarity with the working capacity of every unit the section is one of the main content of the task including the debugging motor servo amplifier servo controller and the whole hardware system ( 5 ) programming on the base of the above work, programming to control the system with mint

    控制系統硬體部分的調試。在熟悉各元件工作性能的基礎上，通過大量的實驗，找到正確的連接方法，使硬體系統正常工作。這一部分是本課題的主要內容之一，主要包括對電機、伺服放大器和伺服控制器的調試，以及對整個硬體系統的訝試。
  13. Firstly, a set of formula is developed for uniplanar x - and multiplanar xx - joints loaded with axial forces, in - plane bending moments and out - of - plane bending moments respectively. in china, it is the first time to develope a set of formula for full - width joints considering the membrane effect

    在總結國內外研究成果的基礎上，本文對方管平面x型和空間xx型相貫節點在軸力、平面內彎矩和平面外彎矩等荷載工況作用下的靜力工作性能建立了一種更合理的理論簡化模型研究方法。
  14. The realization of this system can act as a useful instrument for short periodic readjustment in ins. doppler velocimeter is an ideal apparatus for underwater velocity measurements for submarine

    多普勒測速儀是很理想的潛艇水下測速設備，但要獲得最理想的測速精度不能只考慮測速儀本身的硬體工作性能。
  15. Its field trial showed that the free grain loss is reduced and sp ecially invented windrowing device closely behind the stripping rotor located ju stified itself by the clear cutting with shorter stubble and being center - deliv ered windrow of the straw

    田間試驗表明落粒損失減少，作者發明的設置於摘脫流通筒後面的切割摟集裝置工作性能良好：割茬低條鋪放在兩履帶之間。
  16. The metal oxide varistors ( mov ), as the core organ, made under japanese technology license. it have good response to steep front surge, excellent volt - amper characteristics and high discharge capability, which provides a very consistent protection merit at steep front surge, lightning surge and seitching surge, and enhances protective capability

    它具有良好的陡波響應能力、卓越的非線性伏安特性和巨大的通流容量，在尖頂波、操作波和雷電波下均有優異的保護能力，工作性能幾乎不受波形影響。
  17. The shear mechanism, failure mode, deformation capacity, bearing capacity and the reliability of the anchored angle steels of the wrapped steel concrete cast - in - site frame typical story exterior joints under the middle and high axial compression ratio ( n = 0. 3, 0. 5, 0. 6 ), the working performance, failure mode, and the shear capacity of top story joints under the crack moment, the hysteresis characteristic and the dissipation energy capacity of the test joints are all analysed based on the 1 / 4 model pseudo - static tests of five specimens of wrapped steel concrete cast - in - site frame exterior joints, which varied in axial compression ratio, distribution of the beam angle steels and the stirrup ratio

    基於上述分析，本次試驗通過五個外包鋼混凝土邊節點1 4比例模型的偽靜力試驗，以柱的軸壓比、梁角鋼布置形式、配箍率等為主要參數，分析外包鋼混凝土現澆框架一般層邊節點在中高軸壓比（ n = 0 . 3 、 0 . 5 、 0 . 6 ）條件下，節點的抗剪機理、破壞模式、變形能力、承載能力和角鋼錨固的可靠性；分析了頂層邊節點在張開彎矩作用下的工作性能、破壞模式和抗剪承載力；分析了試驗節點的滯回性能和耗能能力。
  18. In order to study how the floor stiffnesses influence on the mega steel - frame structures, the results of mode 1 and mode 4 of example 1, and those of mode 2 and mode 3 of three examples are compared. some conclusions are obtained as follows : compared with beams and columns of the common steel - frame structures, the cross - sectional dimension of mega beams and mega columns in the main - frames of mega steel - frame structures are very large. because the mega structure system has great lateral stiffness and entirety work behavior, whether or not considering the floor stiffness has less influence on the entirety responses of the mega steel - frame structures and on the displacement and internal forces of columns of the mainframe, but larger influence on the response of columns of hypo - frame

    通過對算例1方案1和方案4及算例1 - 3方案2和方案3結構周期、位移和內力反應的比較，研究了樓板剛度對巨型鋼框架結構反應的影響，得到如下結論：與普通鋼框架的梁、柱相比，巨型鋼框架中主框架的巨型梁、巨型柱截面尺寸要大得多，並且由它們組成的這種超常規的大型結構具有巨大的抗側剛度和整體工作性能，因此，在地震作用下，考慮樓板剛度與否對巨型鋼框架結構整體反應影響不大，對主框架柱位移和內力反應影響也不大，但對次框架位移和內力反應的影響相對較大。
  19. At first we test and verify the communality between original design and data acquisition system with fifo cache ; then we quantitatively analyze the performance of data acquisition system with fifo cache, and the results are satisfied

    在數據採集系統的改進設計和實現中：首先對加入fifo緩存后數據採集系統工作的一致性進行了驗證；然後對加入緩存后系統的工作性能進行了定量分析得到了較為理想的結果。
  20. The experimental study of twelve push - out specimens with different hole molds and different materials filled in holes and two composite steel - fdpcp ( full - depth precast concrete panels ) beams of a full shear connection and different hole mold, as well as a composite steel - fdpcp beams of a partial shear connection and square holes was conducted in this paper, the authors gain following results : three composite steel - fdpcp beams all have good composite action and perfect work behaviors as a whole and the composite steel - fdpcp beams is a new - style structure which should get further research and development

    摘要對12個不同預留孔形、孔內不同填充材料的推出試件及2根不同預留孔形的完全剪力連接與1根部分剪力連接的鋼混凝土預制板組合梁進行了試驗，結果表明，只要預留孔形設計合理，灌孔混凝土強度得當，鋼混凝土預制板組合梁就具有良好的組合效應和整體工作性能，是一種有發展前途和廣泛應用領域的新型組合結構。
分享友人
分享到 Line

分享到臉書