幀中繼信息 的英文怎麼說
中文拼音 [zhèngzhōngjìxìnxī]
幀中繼信息
英文
fri frame relaying information-
Qe1 achieve the whole synchronization by software and hardware. during the course of the initialization of the qe1 system, the chip pm4354 can accomplish the task of synchronization of bit, frame and multiframe after the chip initialization by the software. after pm4354 accomplishes the bit synchronization, qel will read the status registers of the pm4354 to get the status of each el circuit and choose recovered clock of the specified the el circuit as the external timing source of the whole htc - 5200an equipment
Qe1系統在系統初始化時，通過軟體完成對硬體晶元pm4354的初始化工作后，便可利用該晶元完成4路e1的同步（位同步、幀同步和復幀同步） ；在pm4354完成時鐘提取的任務后， qe1通過不斷地訪問pm4354的狀態寄存器，獲得每路e1的狀態信息，在時鐘源的選擇原則下，選擇指定e1線路的恢復時鐘作為整個htc - 5200an節點設備的外部參考時鐘，從而解決了htc 5200an的中繼板卡由e1變為qe時所帶來的網同步時鐘源。The mpls technology was raised just in order to make the most of the switching technology in the core of the network and the ip routing technology on the edge of the network. before presenting the solution of the mpls, there are many integration model, the basic method adopted by them were all carry the control information from the ip router, and combine it with the transmition capability and the label switching of the atm switching machine, accordingly constructing a high speed and economic multi layer switching router. but, all these solutions can not communicate and just suit for adapting the atm as the second layer transmiting link, can n ' t work on other interface ( fr, ppp, and ethernet ), this is obviously conflict with the developing way of the based on packet of the internet
多協議標簽交換（ mpls ）技術就是為了綜合利用網路核心的交換技術和網路邊緣的ip路由技術各自的優點而產生的。在mpls技術方案提出之前已有的各種集成模型解決方案所採取的基本方法都是從ip路由器獲取控制信息，將其與atm交換機的轉發性能和標簽交換方式相結合，從而構建成一個高速而經濟的多層交換路由器。但是，各種方案彼此不能互通，而且僅適用於以atm作為第2層的傳輸鏈路，不能工作在其他多種媒體（如幀中繼、點對點協議、以太網）中，這與internet基於分組的發展方向相矛盾。Dtp information systems - x. 25 data transfer phase procedures for operation with frame relay
信息系統.幀中繼操作的x . 25數據傳輸相位
分享友人