幀結構分析 的英文怎麼說

中文拼音 [zhèngjiēgòufēnxī]
幀結構分析 英文
frame structure analysis
  • 幀 : 量詞（幅, 用於字畫）
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  • 結構 : 1 （各組成部分的搭配形式） structure; composition; construction; formation; constitution; fabric;...
  1. It has also been proved correct in practice by testing with cooperator. the paper analyzed the character of our radio and introduced the procedure of designed base band frame architecture. it showed the application of channel coding in our radio, and encode / decode method implemented in dsp

    本文針對本電臺的特點介紹了基帶幀結構的設計，重點介紹了幾種常用通道編碼在本電臺的應用，以及編解碼方法在dsp中的實現，並從理論上分析了通道編碼給本電臺帶來的處理增益。
  2. The synchronization of frequency hopping method referenced the jtrs radio system of usa military, and designed a synchronization method used in our radio include creating the frequency hopping map and the base band frame architecture in frequency hopping mode. the paper also analyzed the synchronization capability on theory. it has been proved correct on theory by showing the false probability, capture probability and the synchronization time

    對跳頻圖案的產生和跳頻的幀結構，本文不僅從理論上分析了同步性能，給出了虛警概率和檢測概率，估算了同步的捕獲時間，證明均能滿足系統指標要求，而且通過與合作單位進行的整機聯調和實測證實了該方案的可行性。
  3. Further investigated and analyzed composition structure and flow data that dsa ' s formation of image is systematic at first in this paper, carried on intact summing up to the data in the system, having given out the plan of design of high speed and large capacity data channel of digital formation of image system of x - ray ; deeper discussion of control way on sdram, give solution that many pieces of sdram works togetherses of realizing heavy capacity, designing of heavy capacity deposit board realize storing at a high speed to vision data by frame on the basis of this ; through further investigations of interface of pci bus, optimize back end state machine design and urge procedure making with lower, giving intact pci interface scheme that realize high speed dma data transmission and satisfy request of video transmitting ; further investigate the figure systematic design method of programmable logic devices, due to the difficult point of drifting about of enabled signal in fifo in common use and setting up and keeping of output signal, method has been proposed of improving stability of system making use of signal utilizing the phase locking ring in fpga to offer a lot of clocks to move thus realize coordinating the data between every module of system to transmit at a high speed by making use of fifo

    本文首先對數字減影血管造影（ dsa ）成像系統的組成結構和數據流向進行了深入研究和分析，並對系統中的數據流向進行了完整的歸納和總結，給出了x線數字成像系統中的高速大容量數據通道的設計方案；在對sdram的控制方式做了深入探討后，給出了實現大容量多條sdram共同工作的解決方案，在此基礎上設計了大容量幀存板實現對圖象數據進行高速存儲；通過對pci總線介面的深入研究，優化後端狀態機設計和低層驅動程序開發，給出了完整的pci介面方案實現高速dma數據傳輸，完全可以滿足視頻傳輸要求；深入研究了基於大規模可編程器件的數字系統設計方法，針對通用fifo使能信號漂移、輸出數據難于建立和保持等設計難點，提出了利用fpga中的鎖相環提供多個時鐘相移的信號來提高系統穩定性的解決方案，從而實現利用fifo來協調系統各模塊之間的數據高速傳輸。
  4. Then it studies the implementation, architecture and characteristic of embedded guis based on framebuffer, designs testing programs to test several embedded gui system ' s performances ( stability, efficiency ), and finally chooses qt / embedded as the development platform of the bsas. chapter 3 firstly briefly describes the embedded system hardware architecture, and then enumerates functions of system software

    在分析了若干種基於幀緩沖（ framebuffer ）的嵌入式gui的實現、體系結構和特點的基礎上，設計了測試程序對比它們在穩定性、繪圖速率等方面的性能，最終選擇qt embedded作為嵌入式系統軟體開發平臺。
  5. Carry on emulation to melp standard, realize that the compression of the pronunciation file is solved and pressed. first this thesis sample to wav file, carry on the speech to analyze and draws with the parameter to the speech data of every frame. these parameter include pitch, bpvc, jitter, lpc, etc. then, these parameters will be quantized by msvq technology

    該系統首先對語音信號進行采樣；按幀對語音數據進行語音分析和參數提取，提取的參數包括基音周期（ pitch ） 、多帶清濁音判別、非周期抖動標志、線性預測參數（ lpc ）等語音生成模型參數；接著對這些參數進行了量化，量化採用了多級矢量量化技術；最後在解碼端對各個量化參數進行解碼，利用這些參數結合語音合成模型重構語音。
  6. In chapter 5, the complex envelop simulation block diagrams of fh transmitter and receiver are presented at first. then key techniques of simulation system are discussed, including frame processing structure, fh sequence generator, etc. finally, simulation models of fh transmitter, receiver and jammer are presented. the influence of frequency excursion on performance of multi - tone continuous wave jamming is analyzed

    第五章首先設計了跳頻發信機成員和接收機成員的復包絡模擬框圖;其次討論了跳頻模擬系統實現的關鍵技術，包括幀處理結構、跳頻序列發生器等;最後給出了跳頻通信發信機、接收機以及干擾機成員的模擬模型，分析了頻率偏移對多頻連續波干擾性能的影響。
  7. Our analysis is aiming at the slot allocation in the tdd cdma system

    本文所作的分析就是針對tddcdma系統中幀結構的時隙分配進行的。
  8. Moreover, video control program to implement internal function of fpga is designed including video capture time sequence control, ping - pang frame buffer read and write time sequence control and lcd display time sequence control, and program ' s simulation and analysis is also provided. at last, this paper presents a portable iv ' s video processing system, and proposes three buffer strategy to control capture buffer. and a moving object detection algorithm of combing an adaptive background subtraction technique with a three - frame differencing is adopted

    設計了基於fpga系統結構的車載視頻顯示電路板；利用單片機io口模擬i2c時序，實現了視頻解碼晶元控制；利用fpga實現視頻控制，研究了採集通道時序控制、雙幀存ram讀寫時序控制及lcd顯示時序控制的方法，並進行了軟體模擬和分析；設計了車載視頻檢測系統方案，給出了管理採集緩沖區的三幀緩沖策略，採用綜合三幀差分和自適應背景相減的演算法實現運動檢測，連通體檢測去除虛目標，模擬實驗證明其有效性，同時分析了該演算法在dsp視頻檢測系統中的簡單實現方法。
  9. In the first part of this thesis, current situation of the access network and the technical of pon are introduced briefly. then, the epon system structure, osi protocol model, especially the mpcp sublayer are introduced, the epon control frame and data frame changed form ethernet frame are analyzed

    本文首先介紹接入網技術的發展狀況和無源光網路的主要技術類型，以及epon系統的網路結構、 osi分層模型，重點介紹epon系統特有的mpcp子層，分析epon系統對以太網數據幀所做的修改和新添加的epon控制幀。
  10. 1 ) realization of software packet embedded in m - es and md - is respectively to accomplish main function of mdlp, including assignment of tei ( temporary equipment identifier ), establishment of multiple frame operation, framing, flow control and error - free transmission of packets, is detailed. 2 ) a test model is established to evaluate the robustness and stability of mdlp and verify the validity of software packets. 3 ) according to the design of radio modem construction used in m - es, the modules of interface between data terminal equipment and radio modem are achieved to enable transmission of short message and continuous pseudo - random bit stream via rs232 uart

    本文首先概述了蜂窩數字分組數據網的結構和空中協議，詳細分析了移動數據鏈路協議，並在此基礎上，重點敘述了以下方面的工作： 1 ）設計並完成了分別應用於m - es和md - is端無線控制器的兩套程序實現數據鏈路層的主要功能，包括分配臨時設備號、建立鏈路、組幀和面向連接的服務保證分組正確無誤地傳輸，並進行適當的流控； 2 ）建立測試模型測試移動數據鏈路協議的可靠性和穩定性，證明了程序包的效用； 3 ）根據cdpd系統無線數據機的軟硬體總體設計方案，完成了介面模塊，實現了rs232異步串口通信，使用戶可以根據需要發送短消息或連續的偽隨機比特流； 4 ）在tms320c54x的軟體、硬體模擬平臺上，建立了cdpd試驗模型，實現了cdpd系統的mdlp基本功能。
  11. Then time domain synchronization including symbol, frequency and carrier synchronization algorithms is discussed according to the characteristics of frame structure in merged scheme. at the same time, pointed out its merit that high rate of spectrum utilized and rapid synchronization retrieved. and simulation and much improvement are done to realize the algorithms in project

    然後根據融合方案的幀結構的特點，分析和探討了時域同步演算法，包括符號同步、載波頻率同步和采樣同步演算法原理，指出時域同步有頻譜利用率高，同步恢復快等優點，並對其進行了工程可實現的改進和模擬。
  12. Main contents of this thesis include following parts : firstly the frame format and frame type in 802. 11b are summarized. two mac layer access methods : dcf ( distributed control function ) and pcf ( point control function ) are deeply analyzed. physical layer, management entity and security mechanism are generally narrated

    全文內容主要包括以下幾部分：第一部分總結了802 . 11b協議中的mac層幀結構和幀類型，較深入地分析了mac層的pcf （中心網控方式）和dcf （分散式接入方式）兩種接入方式，概述了物理層、管理實體和安全機制。
  13. Then the new idea of using two steps, that is to say, inner - frame image segmentation and inter - frame multitarget tracking to analysis the sequence frames is presented. and all the algorithms of parameters extracting are presented too. otherwise, the factors, which are affecting system precision, the evolution methods to analysis quality and several different aspects of system are discussed deeply

    本論文在給出系統實現的系統結構基礎之上，詳細闡述了系統的設計原理，提出了我們自己的幀內分割和幀間跟蹤的精子動態圖像分析的思想，給出了所有量化參數計算的全部演算法流程，同時對分析精度的影響因素、分析質量的評估方法、采樣頻率對參數計算的影響等方面進行了深入的討論。
分享友人
分享到 Line

分享到臉書