庫侖分析法 的英文怎麼說

中文拼音 [kùlúnfēnxīfǎ]
庫侖分析法 英文
coulometry
  • 侖 : 名詞[書面語] （條理; 倫次） logical sequence; method; coherence
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  1. The effects of contact potential differences ( cpd ) in the experiments for testing coulomb ' s inverse square law and detecting the photon rest mass based on the concentric metal spheres were discussed, and the ultimate restrictions on hte experimental sensitivities due to cpd were presented for static experiments and dynamic ones respectively

    摘要分析基於同心導體球殼方法檢驗庫侖反平方定律和光子靜止質量的實驗中接觸勢的影響，並分別給出了靜態和動態實驗中接觸勢對實驗靈敏度的限制。
  2. The research and application of by the constant electric current coulometric analysis method replacing the capacity analysis method

    以恆電流庫侖分析法取代容量分析的研究與應用
  3. 5. numerous simulations are done with different initial docking misalignment by adams software and ddss : ( 1 ) influence of the contact columbus friction to simulation results is inspected ; ( 2 ) adams results are compared with that of ddss, both the results validate each other ; ( 3 ) simulation results show good capture ability of

    5 .對各種對接初始偏差，分別用adams與ddss進行了大量的模擬研究: （ 1 ）考察了接觸點處庫侖摩擦力對模擬結果的影響; （ 2 ） adams與ddss對比分析結果相互驗證了模型及演算法的正確性。
  4. Thirdly writer, using linear elastic theory and finite element program ( ansys ), analyzed expanding bolt pullout test. fifthly, writer using the modified mohr - coulomb failure theory, on the base of curving failure surface, derived a theoretical formula between pullout force and compressive strength. then the thesis compared the formula with the strength - detecting formula of expanding bolt pullout method

    本文採用ansys有限元程序對脹栓拔出法試驗過程進行彈性理論分析；以修正的摩爾-庫侖破壞準則，在擬合實際破壞面的基礎上推導出極限狀態下脹栓拔出法的混凝土拔出力與混凝土抗壓強度的理論公式，並把該公式與脹栓拔出法測強公式進行了比較。
  5. Methods three - step extract procedures were used and the solanesol contents were measured by coulometric titration method

    方法採用滲濾、析晶、重結晶三步法提取分離，庫侖滴定法測定含量。
  6. Methods for chemical analysis of melted welding fluxes. the direct combustion - coulomb method for determination of total carbon content

    熔煉焊劑化學分析方法.燃燒-庫侖法測定碳量
  7. Failure reasons of impellers in a pump of an aromatic hydrocarbon extracting system were analyzed by means of microcoulometric detector, spectroscopic methodology, optical microscopy, scanning electron microscope and x ray diffraction

    摘要採用微庫侖法、光譜法、光學顯微鏡、掃描電鏡、 x射線衍射儀等手段對芳烴抽提系統的3105泵葉輪進行了失效分析。
  8. Methods for chemical analysis of iron - chromium - aluminium alloys. coulombic method for the determination of carbon content

    鐵鉻鋁合金化學分析方法.庫侖法測定碳量
  9. Methods for chemical analysis of high - titanium slag and rutile - the direct combustion - coulometric method for the determination of total carbon content

    高鈦渣，金紅石化學分析方法燃燒-庫侖法測定碳量
  10. With the help of this program, this paper does research on the moved backwards of the slide surface, lengthening the anchor section, the soil nail ' s total force, gets conclusion about relations between the soil nail ' s length and the slope ' s grade, height, soil ' s mechanical parameter ; relations between soil nail ' s total force and coulomb soil pressure. with the help of the large multiuse finite element program ansys, this paper analyzes the soil nailing in one - step ' s slopes, in two - steps " slopes, puts the emphasis on the axis force ' s distributing along the soil nail at each rows, the effect of both the excavating mode and the original slope figure to the axis force of the soil nail, the one another effect between the upper - step slope and the nether - step slope in the soil nail ' s axis force, gets conclusion about the design of soil nail at the first low, different slope body is the same with different excavating mode, the original slope figure has more effect to some than others because of the slope body, the reasonably design of the step width in two - steps slopes, the two - steps excavating and retaining has more virtue than the one - step ' s. through soil pressure analysis this paper does research on the differences and the links between the coulomb soil pressure theory and the rankin ' s, the vertical pressure at the slope surface when the slope surface is inclined and the retaining wall is rough, the soil pressure ' s distributing behind the panel, gets conclusion about the effect of both the slope body inner stability and the slope surface local stability to the soil pressure

    通過分析比較，論證了對數螺旋線型比圓弧形作為邊坡的假設滑裂面具有較多的工程優點，並為此編制了一個採用極限平衡法分析土釘支護的fortran語言程序，以此作工具對滑裂面的后移、土釘錨固段的超長、土釘總力的大小等方面作了研究，得出了有關土釘的長度與邊坡的坡角、坡高、土體力學參數的關系、土釘總力與庫侖土壓力間的關系等結論；採用大型通用有限元數值分析程序ansys分別對採用土釘支護的一階邊坡、二階邊坡進行分析，重點是研究各排土釘的軸力分佈規律、開挖方式及原始邊坡形態對土釘的軸力的影響、上下階邊坡在土釘軸力方面的相互作用，得出了有關第一排土釘的設計問題、不同類型的土體應適用於特定的開挖方式、原始開挖出的邊坡形態對一些類型坡體的邊坡土釘支護有較大的影響而對另外一些影響不大、二階邊坡臺階寬度的合理確定、二階開挖及支護比一階時具有較多的工程優點等結論；通過土壓力分析對朗肯、庫侖兩種經典土壓力理論的區別與聯系、坡面傾斜及墻背有摩擦時的坡面豎向應力分佈、面板背土壓力的分佈形態作了研究，得出了邊坡支擋土壓力受坡體內部穩定與坡面局部穩定兩個方面的影響、土釘支護面板背土體中卸荷拱的存在對面板受力有利等結論。
  11. Several classical methods of interface element, soil behaviors and structure characters are presented in this paper. the author made great effort on the modeling of the interface element and the underground structure element, while considering the soil obey the mohr - columnb yielding principle, modified the existing beam element for solid rectangle pile and applies this element into thin - wall hollow pile, proposes a kind of board element. some examples are presented in the paper to test these new concepts and corresponding formulas

    本文在總結已有的結構與土相互作用問題中的接觸面單元形式、土的本構關系以及結構的數值模擬方法的基礎上，對滿足摩爾庫侖屈服條件的土體材料用常規的薄層單元模擬進行了更加深入的驗證，在已有實心矩形截面樁與土相互作用描述模式的基礎上推導了薄壁筒樁用梁模擬時與土相互作用分析模式，和考慮與土相互作用時用板單元模擬地下連續墻的分析方法。
  12. Methods for chemical analysis of tungsten - the combustion - coulometric titration method for the determination of carbon content

    鎢化學分析方法燃燒-庫侖滴定法測定碳量
  13. Methods for chemical analysis of molybdenum - the combustion - coulometric titration method for the determination of carbon content

    鉬化學分析方法燃燒-庫侖滴定法測定碳量
  14. Methods for chemical analysis of tungsten - the inert gas fusion - coulometric titration method for the determination of oxygen content

    鎢化學分析方法惰氣熔融庫侖滴定法測定氧量
  15. Methods for chemical analysis of molybdenum - the inert gas fusion - coulometric titration method for the determination of oxygen content

    鉬化學分析方法惰氣熔融庫侖滴定法測定氧量
  16. Test method for moisture in plastics by coulometry

    用庫侖分析法測定塑料中水分的試驗方法
  17. Plastics piping systems - determination of moisture content in thermoplastics by coulometry

    塑料管道系統.用庫侖分析法測定熱塑性塑料中的水含量
  18. Standard test method for determination of chlorine in coal by oxidative hydrolysis microcoulometry

    氧化水解微庫侖分析法測定煤中氯含量的標準試驗方法
  19. Trace quantities of sulfur in light liquid petroleum hydrocarbons by oxidative microcoulometry, method of test for

    用氧化微庫侖分析法測定輕質液態石油烴類中硫痕量的試驗方法
  20. Standard test method for determining organic chloride in aromatic hydrocarbons and related chemicals by microcoulometry

    用微庫侖分析法測定芳香烴和相關化學藥品中有機氯的標準試驗方法
分享友人
分享到 Line

分享到臉書