弧電阻 的英文怎麼說
中文拼音 [húdiànzǔ]
弧電阻
英文
tracking-
Analysis of the discharge process in electrothermal light gas gun
電熱輕氣炮電弧電阻計算及其彈道分析The problem about neutral - point - grounding mode is an all - around technical problem which associated with not only power system reliability ， insulation coordination ， electromagnetic interference ， but assault safety 。 in china ， the neutral grounding modes of the 10kv net involved of none grounding, grounding by arc suppressing coils, resistance grounding or reactance grounding in the past 。 with the development of civic power network ， low resistance grounding mode was used to restrain the over voltage, particularly in guangzhou, shanghai ， beijing ， and zhuhai etc. it was reported that the over - voltage level of low resistance grounding mode is lower than that of arc suppressing coil mode, but the operation carried out the other way 。 at substations in guangzhou and shanghai it was found that the low resistance grounding mode is successful 。 but in some areas ， such as zhuhai ， substations grounding with low resistance revealed some problems ， including power supply reliability rapidly dropping ， transmitting line often tripping ； and person safety being threatened 。 so interiorly the grounding mode selection of the 10kv network was disputed, which mainly focused on the fault form of 10kv net grounding, the apply area of suppressing arcing coil grounding mode, power supply reliability level of the two modes, person safety, communication interfere and the workload of maintenance
爭議點主要是在10kv電網接地故障的形式、消弧線圈接地的應用范圍、兩種運行方式供電可靠性的高低、人身安全、通訊干擾和運行維護工作量等諸多方面。 11 17本論文就是針對以電纜為主的城區10kv電網中性點接地方式的選擇問題進行研究。論文首先對10kv電網的中性點運行各種方式進行分析，比較各方式的特點，然後以重慶儲奇門變電站10kv電網的實際參數來建立數值計算模型，在考慮了電網接地電容電流變化、中性點電阻取值大小、接地點接地電阻值變化等多種影響因素的情況下，對中性點經消弧線圈接地和經小電阻接地方式下電網的過電壓水平和接地點短路電流大小進行了數值計算，其計算結果與電科院所作現場試驗進行了比較。Railway rolling stock. art and resistance welded joints of steels. part 1 : acceptance criteria for defects in welded butt and corner joints
鐵路車輛.鋼的電弧和電阻焊接接頭.第1部分:對接焊點和角焊接點中缺陷的驗收準則The main work and conclusion for this paper is as following : according to the flashover test results of several kinds of iced insulators under positive voltage and negative voltage, this paper obtained : for the single porcelain insulator, the single glass insulator and the composite insulator bridged completely by icicle, the metal cathode ' s strong ability of emission electron is the primary reason that results in the lower negative flashover voltage ; the position difference of the high resistance district in method anode side results in that porcelain insulator cluster and glass insulator cluster have an evident effect of polarity ; when less ice and no icicle at the brim of the sheds, due to numerous non - polar arcs on the composite surface, the effects of polarity of composite insulator was lost using the test method of the average flashover voltage in the freezing period, dc flashover performances were investigated of several insulators with some typical structures and different material
本文的主要工作和結論如下：在人工氣候室內，根據不同覆冰絕緣子正、負極性下的閃絡試驗結果，得出負極性電弧金屬陰極的強電子發射能力造成了單片瓷、玻璃絕緣子及被冰凌橋接的合成絕緣子有較低負極性冰閃電壓；正極性電弧金屬陽極側產生高電阻區所處位置的差異使得瓷和玻璃絕緣子串具有明顯的極性效應；覆冰較少時，合成絕緣子表面出現數量較多的非極性電弧使合成絕緣子無極性效應。利用覆冰期內平均閃絡電壓的試驗方法，對不同材質和結構的絕緣子在覆冰、低氣壓和污穢共存環境中的直流閃絡特性進行了研究。試驗結果表明，直流平均閃絡電壓隨著海拔的升高、覆冰量的增加以及污穢度的增加而降低，且其特徵指數與絕緣子結構、覆冰量、覆冰狀態、污穢度等有關。These measures include installation of lightning lines, decrease of the tower grounding resistance as far as possible, the reasonable use of arc suppressing coils and adoption of arresters
處理方法包括加裝避雷線、盡量減低線路桿塔接地電阻值、消弧線圈的合理使用和採用線路型避雷器。Analysis of low - energy arc discharge of d. c. resistive intrinsically safe circuits
直流電阻性本質安全電路低能電弧放電分析Selecting principle analysis of damping resistance for multitap arc - suppression coil
調匝式消弧線圈阻尼電阻的選取原則分析The influences of several factors such as harmonics, intermittent arc grounding, ct, load and fault resistance have been thoroughly analyzed, therefore, it is fundamental work for its application
深入細致地分析了諧波、間歇電弧、電流互感器、負荷、過渡電阻等多個因素對故障選線結果的影響，為方案的實用化奠定了基礎。The tap - changer is made with solid state relay as its working mechanism and controlled by microprocessor. this switch has totally cancelled the mechanical drive organization, by the microprocessor according to the voltage of second side microprocessor decide the working condition of solid state rely, high regulation speed, need not transition resistor, rush current is low. operating frequently ; there is no electric arc to produce, can put in the fuel tank of the voltage transformer directly ; the structure is simple, the fabrication cost is low, benefit and use widely among the voltages transformer of distribution
其中的有載調壓分接開關，它是一種完全由固態繼電器作為分接開關執行機構，由單片機控制的有載自動調壓的變壓器分接開關。該開關完全取消了機械傳動機構，由單片機根據變壓器二次側電壓的高低，決定與變壓器各分接頭聯接的固態繼電器的工作狀態。調節速度快，改變分接頭時不需過渡電阻，沖擊電流小，可頻繁操作；無電弧產生，可以直接放在變壓器油箱中；結構簡單，造價低，便於在配電變壓器中推廣使用。Dry, solid insulating materials - resistance test to high - voltage, low - current arc discharges
乾性固體絕緣材料.高電壓低電流電弧狀放電電阻試驗Arc suppressing varistor
消弧電壓敏電阻器Arc suppressing varstor
消弧電壓敏電阻器Specification and qualification of welding procedures for metallic materials - welding procedure test - resistance butt and flash welding
金屬材料焊接程序的規范和鑒定.焊接程序試驗.電阻對接焊和電弧對接焊Railway rolling stock. arc and resistance welded joints of unalloyed or low alloyed steels. rules for conception and realization
鐵路車輛.非合金鋼或低合金鋼的電弧焊接頭和電阻焊接頭.設計與實施規則This paper presents the effects of some features on the productivity of raw c60 materials, such as distance and approaching speed of electrodes, helium partial pressure and arc current etc. then we separate and purify the raw materials and obtain pure solid c60 of 99. 9 % and compare the purification efficiency and effect of different fluxion phase and fixed phase and discuss the effects of the experimental conditions, such as the depositing speed, the type of the substrate, the surface structure of the substrate and the temperature of the substrate. finally, we use xps, afm, ultraviolet, infrared and raman to analyze the component, structure and feature of the films qualitatively and quantitatively
本文首先研究了氦氣分壓、弧電流大小、電極間距以及電極推進速度等實驗條件對制備c _ （ 60 ）粗品產率的影響；接著選用柱色譜法分離提純得到了純度大於99 . 9的c _ （ 60 ）固體，比較了不同流動相和固定相的提純效率和效果；然後採用自己改進后的真空鍍膜機，利用電阻式加熱蒸鍍方法，得到了純c _ （ 60 ）薄膜和不同摻雜比的銀摻雜薄膜；探討了沉積速率、襯底種類、襯底表面結構以及襯底溫度等實驗條件對薄膜結構的影響；最後通過xps ， afm ，紫外，紅外，拉曼對薄膜的成分、結構和特性作了定性和半定量分析。Dry, solid insulating materials - resistance test to high - voltage, low - current arc discharges iec 61621 : 1997 ; german version en 61621 : 1997
乾燥的固體絕緣材料.耐高壓低電流電弧放電的電阻試驗The paper explains the method of the petersen coil parameter selection and expatiates the working principle of micro - computer controller. new methods of on - line measuring of the capacitive current and the control of the series resistance are put forward ? which lead to the integration of the automatic resonance and the faulted line selection in a compensating network
文中說明了消弧線圈參數的選擇方法，闡述了微機控制器的工作原理，提出了在線測量補償電網對地電容電流以及控制串聯電阻的新方法，實現了補償電網自動調諧與單相接地選線的一體化。Dry, solid insulating materials. resistance test to high - voltage, low - current arc discharges
乾性固體絕緣材料.高壓低電流弧光放電阻抗試驗Test method for high - voltage, low - current, dry arc resistance of solid electrical insulation
固體電絕緣的高壓低電流和干電弧電阻試驗方法A tentative idea of using the variation of interim resistance to achieve the metering ofadapting oneself to impedance is put forward, the relevant bases of a differentiation are derived, and its preliminary analysis has been carried out as well. it aims at eliminating the influence of interim resistance on metering of impedance protector by changeable property of arc resistance
提出了利用過渡電阻增量實現阻抗自適應測量的設想，導出了其動作判據，並對該判據進行了初步分析，旨在利用故障點電弧電阻的變化特性來消除過渡電阻對距離保護正確測量的影響。分享友人