徑向射流 的英文怎麼說

中文拼音 [jìngxiàngshèliú]
徑向射流 英文
radial jet
  • 徑 : Ⅰ名詞1 （狹窄的道路; 小路） footpath; path; track 2 （達到目的的方法） way; means 3 （直徑的簡稱...
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  1. Rail corrugation at high frequency wheel rail interaction

    小口徑軸對稱收縮噴嘴射流沖擊大平板噪聲指向特性研究
  2. According to rigorous procedures, an experimental study was carried out to investigate the effects of jet exit velocity, flow direction, fluid subcooling and nozzle diameter on hysteresis of boiling heat transfer with impinging circular submerged jets of highly - wetting liquids

    摘要系統地研究了液體在圓形斷面噴嘴浸沒射流作用下沸騰熱滯后與射流沖擊速度大小、液體流動方向、液體過冷度和噴嘴直徑等因素的影響。
  3. The thermal visualizations of jet impingement cooling with single or double row holes inside semi - enclosed channel are measured by using infrared camera and then the impingement cooling heat transfer coefficients are deduced. the effects of flow and geometry parameters on convective heat coefficients are obtained. the results show that : for a single row normal impingement, the impingement cooling effectiveness is enhanced with the increase of impinging reynolds number or the decrease of hole space to diameter ratio, and the best effectiveness is achieved under the jet - to - surface spacing equals to 2 ; when the jet is oblique to the confined wall, the cooling effectiveness is weaken especially under the jet - to - surface spacing ratio is greater than 2 ; for double rows normal impingement cooling, the cooling effectiveness of rear row jet is weaker than the front row under lower impinging reynolds number or bigger jet - to - surface spacing

    對于單排垂直射流，沖擊冷卻效果隨射流雷諾數的增加、孔間距與直徑比的減小而得到提高，沖擊間距比為2時換熱效果最好;沖擊孔中心線向通道封閉一側傾斜后，射流沖擊冷卻的范圍變窄，當沖擊間距比大於2時駐點區的對流換熱能力明顯降低;對于雙排沖擊射流，孔排間距與直徑比的增加使沖擊冷卻范圍變大，但在兩排孔之間區域的對流換熱系數有所下降;在較小的沖擊射流雷諾數和較大的沖擊間距比下，後排射流的沖擊換熱效果要遜於前排射流。
  4. In theoretical analysis, the motion of radially - emitted electron beam in diode region and drift region has been analyzed, and the relation between radial momentum or current of electron beam and the guiding magnetic field has also been studied, then the possibility to optimize the guiding magnetic field has been derived. the motion of radially - emitted beam electrons in smooth bore magnetron and smooth bore milo has also been studied theoretically. at last, the motion of radially - emitted beam electrons in compound axial and azimuthal magnetic field has been studied

    在理論分析中，初步分析了軸向發射條件下電子在二極體區域和漂移區的運動規律，電子徑向動量隨著外加磁場變化的規律，以及電子束電流隨著外加磁場的變化規律，還有二極體區域磁場優化的可能性;分別研究了有軸向磁場時以及有角向磁場時徑向發射的電子在光滑陽極結構中的運動規律，最後分析了在軸向和角向復合磁場中電子的運動規律。
  5. The radial high current forms the virtual cathode in the reflected high frequency field, which further modulates the emitted electron beam

    徑向強流電子束在徑向反射場中會形成虛陰極振蕩，單獨的虛陰極振蕩產生的微波效率低。
  6. Application of technology on augmentation of heat transfer in the grinding contact zone with radial jet impinging in creep feed grinding

    緩進給磨削時磨削弧區徑向射流沖擊強化換熱技術的應用
  7. The numerical simulation is carried out and the sauter mean diameter and the axial and radial size distribution of droplet of round jets and annular jets were obtained. numerical results are in good agreement with experimental data

    針對hy911圓柱形射流和環形射流，計算出霧化液滴sauter平均直徑以及軸向和徑向液滴尺寸分佈，計算結果與實驗數據吻合較好。
  8. This paper provided basis for application of rotary abrasive jet in drilling radial horizontal wells

    該試驗研究為磨料旋轉射流應用於徑向水平鉆井提供了基礎。
  9. Studies have shown, lead impeller nozzle it forms the hole to be equal to size of the nozzle, gush out from light, difficult to arrange bits and realize it cut one layer of advantages effectively ; under the equal condition, rotate the nozzle by oneself, can be designed in accordance with the actual need while vary the size of aperture of hole, gush out the distance longer effectively, it is apt to give play to the role of its pulse broken rock

    以此設計出限速部分的參數，且初步討論射流功率與轉速之間的關系。研究表明，內導葉輪噴頭形成鉆孔孔徑與噴頭大小相當，有效噴距小，不易排屑和實現其切向剝層優勢；同等條件下，自旋轉噴頭，成孔孔徑大小可依實際需要設計，有效噴距較長，易於發揮其脈沖破巖作用。
  10. For the clouds over xi ' an region, the quantity calculations of the backscattering cross sections for various reflection mechanism of cloud are dealt with. the results calculated show that the major contributions for the backscattering cross s ection come possibly from average cloud diameter, clear - air and humidity turbulence and also from distributions of cloud particles, especially, at higher frequencies

    再分析了雲的後向散射機理，計算了西安地區雲的後向散射截面；表明影響雲的後向散射截面的主要因素為雲滴平均半徑、大氣濕度湍流及雲粒子分佈，在較高頻率時更顯著。
  11. Abstract : being aimed at the poor rock - breaking efficiency of rotary water jet in hard formations and deep wells with radial horizontal well technology, by use of powerful advantages of abrasive jet rock - breaking, experimental study on rotary abrasive jet was made

    文摘:針對徑向水平井鉆井技術中旋轉水射流在硬地層和深井中破巖能力低的不足，利用磨料射流破巖能力強的優勢，對旋轉磨料射流進行了試驗研究。
  12. Climatic mean map, it is further confirmed that it s a good approach to retrieve the equatorial zonal circulation by using the ir indicate ascending branch and wv indicate descending branch channels. the definition of the index of zonal circulation with the olr and fwv are presented and the 17 years mean annual and seasonal equatorial circulation are drawn. the climatic characteristics of the equatorial zonal circulation are analyzed in detail. consequently the fore results of the other observation are corrected

    通過波耳茲曼公式換算得到的6 . 7m水汽輻射通量密度，以便於與olr比較與ncep再分析的500hpa的年氣候平均圖進行比較，分析其異同，進一步證明了用衛星觀測的紅外，水汽雙通道olr表示上升運動， fwv表示下沉運動去反演緯向垂直環流是一個極好的途徑。
  13. A lot of photographs of atomization field on high pressure jet were obtained by the use of the energetic liquid injection device and laser holographic system, so that the properties of axial and radial droplets size distribution were revealed. the relations of droplet size distribution with injection pressures, nozzle and viscosity were discussed

    利用含能液體噴射霧化模擬裝置及其全息攝影系統，得到了多種工況下液體藥射流噴霧場的全息照片，揭示了噴霧場中液滴軸向和徑向分佈規律，分析了噴射壓力、噴嘴形狀、液體粘度等對射流破碎的影響。
分享友人
分享到 Line

分享到臉書