循環最高溫度 的英文怎麼說

中文拼音 [xúnhuánzuìgāowēndù]
循環最高溫度 英文
maximum cycle temperature
  • 循 : 循動詞（遵守; 依照; 沿襲） follow; abide by
  • 環 : Ⅰ名詞1 （環子） ring; hoop 2 （環節） link 3 （姓氏） a surname Ⅱ動詞（圍繞） surround; encircle;...
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 循環 : circulate; circle; round; repeat; loop; period; recurrence; cycling; circulating; mixing; circula...
  • 溫度 : [物理學] temperature
  1. The sort, material composite, structure properties and conduction mechanisms of eca ( electrical conductive adhesive ) were discussed in this paper. then three types of ega specimens were designed and made, on which temperature cycles test from - 55 ? to + 125 ? and thermal aging at + 125 ? were carried out. changes of the adhesive strength, eca ' s bulk resistance and contact resistance under the environment stress were summarized and a detailed evaluation on these specimens was given

    本文在全面闡述導電膠的分類組成、物理結構、導電機理的基礎上，設計並製作了三批導電膠樣品，通過對樣品進行長時間的- 55 ? ? + 125溫度循環和125高溫存儲試驗，總結了導電膠粘接強度、體電阻和接觸電阻在環境應力下的變化規律，對三類樣品的長期可靠性做出了全面的評價，並結合導電膠電阻率和「穿流閾值」的計算機模擬，給出了提高導電膠可靠性和電導率的建議，介紹了國內外在高電導率高可靠性導電膠研製方面的一些最新進展。
  2. Besides, scan rate and cycle period also affect the result ; co - deposition of dualistic oxide is a focus of research, as an element in the same group, ir is selected. deposition rate of composition is decreased by the adding of ir composition, and when the proportion of ir exceeded 50 %, composition procession can be ceased. but cooperation of ir and ru oxide can highly increase the specific capacitance of active material ; annealing treatment under a certain temperature can help to change the hydrate ru composition into mixture state ru oxide, accordingly increase the stabilization of active material

    研究表明:電解液的配製過程中，氯化釕濃度、溶液ph值、陳化時間、溶液溫度對電鍍效果均有影響，其中溶液ph值是最主要的影響因素;在儀器的使用條件探索中，理論結合實驗確定了本電鍍液體系循環伏安電勢窗的理想范圍，並發現循環伏安掃描速度和掃描周期對電鍍結果也有較大影響;混合氧化物的共沉澱是目前研究熱點，在此選用與釕同一族的銥作為共沉澱元素，銥的加入會阻礙氧化物的沉積速度，銥的比例超過50 %會使沉積作用停止，但是二元氧化物的協同作用使沉積的活性物質比容量大大提高;一定溫度下退火后處理作用會使水合釕化物轉變成混合價態的氧化釕，從而提高活性物質的穩定性。
  3. In the mean time, i test the separator ’ s performance, including the rate of hole 、 the performance of absorbing electrolyte and the conductance eletrochemical steady range 、 machine intensity test, and then make bettery to test its cycle performance. the test result show that, the spreading separator get better performance, when dbp ’ s percentum reach 50 %, and dry temperature reach 90, after ultraviolet radiation disposal. the test show that, the separator has high conductance reach 6. 1 10 - 3s / cm ( 25 ), and the machine intensity can reach 3. 92 mpa, this separator can meet the need of making bettery, the bettery capability will go down after 30 cycle. and the bettery show worse performance under high temperature, under 70, the bettery will get fire. making the intensified seprator, i find that when dbp % : pvdf % = 40 % : 60 %, dbp % + pvdf % : sio2 % = 70 % : 30 %, the separator get

    但用其制備的電池循環30周期后容量發生衰減，並且電池高溫性能差， 70下電池燃燒;強化聚合物膜的最佳制備配比條件為: dbp : pvdf為40mass % : 60mass % ， dbp含量與pvdf含量之和與納米sio2含量比值為70mass % : 30mass % ;強化電解質隔膜的室溫離子電導率也可達4 10 - 3s / cm左右，完全能滿足聚合物鋰離子電池的使用需要;機械強度遠遠大於流延法制得的隔膜，達到108 . 84mpa 。
  4. Abstract : the effects of sodium hydroxide concentration and chlorination temperature on effective chlorine content of calcium hypochlorite were tested. the effects of mesh number of standard sieve on effective chlorine content of calcium hypochlorite were tested. the retrieval technology of effective chlorine in mother liquor of calcium hypochlorite was researched, and the effects of cycle number on effective chlorine content of calcium hypochlorite were tested. the results indicate that when sodium hydroxide concentration is 333. 3 g / l, and chlorination temperature is 20, the effective chlorine content of calcium hypochlorite is highest, that when mesh number of standard sieve is 180 mesh, the effective chlorine content of calcium hypochlorite is higher, but the passing sieve rate is not too low, that the cycle number has no remarkable effect on the effective chlorine content of calcium hypochlorite, and the effective chlorine content of calcium hypochlorite is basically above 80 %

    文摘:測試了燒堿質量分數和氯化溫度對漂粉精有效氯含量的影響，測試了分鹽用標準篩目數對漂粉精有效氯含量和過篩率的影響.研究了漂粉精母液中有效氯的回用工藝流程，並測試了循環次數對漂粉精有效氯含量的影響.結果表明，燒堿質量分數為25 、氯化溫度為20時，漂粉精的有效氯含量最高；標準篩目數為180目時，漂粉精的有效氯含量較高而過篩率不太低；循環次數對漂粉精有效氯含量沒有顯著影響，並且漂粉精有效氯含量基本上可以達到80以上
  5. The effects of sodium hydroxide concentration and chlorination temperature on effective chlorine content of calcium hypochlorite were tested. the effects of mesh number of standard sieve on effective chlorine content of calcium hypochlorite were tested. the retrieval technology of effective chlorine in mother liquor of calcium hypochlorite was researched, and the effects of cycle number on effective chlorine content of calcium hypochlorite were tested. the results indicate that when sodium hydroxide concentration is 333. 3 g / l, and chlorination temperature is 20, the effective chlorine content of calcium hypochlorite is highest, that when mesh number of standard sieve is 180 mesh, the effective chlorine content of calcium hypochlorite is higher, but the passing sieve rate is not too low, that the cycle number has no remarkable effect on the effective chlorine content of calcium hypochlorite, and the effective chlorine content of calcium hypochlorite is basically above 80 %

    測試了燒堿質量分數和氯化溫度對漂粉精有效氯含量的影響，測試了分鹽用標準篩目數對漂粉精有效氯含量和過篩率的影響.研究了漂粉精母液中有效氯的回用工藝流程，並測試了循環次數對漂粉精有效氯含量的影響.結果表明，燒堿質量分數為25 、氯化溫度為20時，漂粉精的有效氯含量最高；標準篩目數為180目時，漂粉精的有效氯含量較高而過篩率不太低；循環次數對漂粉精有效氯含量沒有顯著影響，並且漂粉精有效氯含量基本上可以達到80以上
  6. The result of the calculation for tip clearance is reasonable when it is compared with theory. two ways are put forward for convention of dimension of the turbine components from high temperature to low one, which is related with tip clearance, a simple example is used to illuminate that the two ways are useful, using the method of design optimization, axiisk and a blade of a certain turhine is analysed, it showes that the method of design optimization is feasible to be used for convertion of dimension of the turbine components. finally, ansys software is used to analyzed the variation of tip clearance with the method of cyclic symmetry analysis when engine works under the conditions of temperature and rotational speed, am using a new method to deal with thermal contact resistance in the calculation

    本文完善了計算渦輪葉尖間隙的簡化演算法程序，增加了程序的計算功能，並將其應用於某高壓渦輪進行葉尖間隙分析，所得結果與理論結果進行了對比，得出修改後的程序用於葉尖間隙計算是合理的；同時提出了與葉尖間隙相關的渦輪典型部件的冷、熱態的尺寸兩種換算方法，使用優化設計的方法進行了實例分析，說明了所提出的計算方法是可行的；最後應用ansys有限元軟體利用循環對稱的方法分析了某型發動機高壓渦輪在溫度場及離心力作用下的葉尖間隙在發動機工作過程中變化情況，並分析了計算中的接觸熱阻的處理問題。
  7. High heating temperature : circulation type heater is designed to have max empt of 650

    加熱溫度高：循環式加熱器設計最高工作溫度可達650 。
  8. Starting from the frozen food and refrigeration principles and using comparative analysis method, we get conclusions that in the blow - frozen device, the open - mode, cold - quantity reclaim, low - press, direct - cooling air, absorbing - heat air cycle have the most significant reductions in food freeze dry cost, food hygiene, devices delicate, organizating air stream, non - electrical heat, high efficiency and safe refrigeration etc. the cold - cumulating and dryness tin is the equipment which applys the store - release characteristic of cold - cumulating stuff, ensures the higher efficiency of open - mode cold - quantity reclaim low - press direct - cooling air, shoulders conveyance of the saturated and frozen air to frozen storeroom to reduce dry cost of food and dry the cycling air to ensure safe and reliable

    從食品冷凍和製冷原理入手，用對比分析方式得到了在吹風式凍結裝置中，開式回冷低壓直接冷卻吸熱循環空氣製冷機具有最大幅度降低食品凍結乾耗、確保食品冷凍安全、系統簡單、凍結庫小巧、氣流易於組織、無電機熱量、效率較高和製冷安全等結論。蓄冷乾燥器是通過蓄冷材料的蓄?釋冷特性，來保證開式回冷低壓直接冷卻吸熱循環空氣製冷機具有較高的效率，同時蓄冷乾燥器還擔負著輸送飽和低溫空氣至凍結庫以降低食品凍結乾耗和乾燥循環空氣以確保整機安全可靠工作的主要設備。
  9. Zhang liji ( material physics and chemistry ) directed by professor xie xiaoming this paper is intended to solve problems for those who are designing, using pbgas. failure mechanism, as well as cycles to failure of two groups of pbga samples ( with / without underfill ) for thermal cycling conditions in the range of - 40 ~ 125, were presented. the experiment shows that solder ball in the samples without underfill cracked after 500 times cycle, no crack was found in the underfilled samples even after 2700 cycles

    通過一系列的實驗，得到以下實驗結果： ?在本論文設定的溫度循環條件下，未充膠pbga樣品的熱疲勞品壽命在500周左右，充膠樣品的焊點壽命高於2700周； ?對于未充膠器件，中心距（ dnp ）是決定焊點應力、應變大小的最主要因素，裂紋總是從中心距較大處萌生並向中心處擴展； ?溫度循環的過程中焊盤附近焊料組織明顯粗化。
  10. Under the action of cycle fan, the hot air stream inside each unit of the dryer will carry out hot air cycle. final air with iow temperature and high damp will be out. the whole drying process with stably and high effect will be finished

    使熱空氣穿流通過床面上的被乾燥物料進行均勻的熱質交換，機體各單元內熱氣流在循環風機的作用下進行熱風循環，最後排出低溫高濕度的空氣、平穩高效地完成整個乾燥過程
分享友人
分享到 Line

分享到臉書