恆壓狀態 的英文怎麼說

中文拼音 [héngyāzhuàngtài]
恆壓狀態 英文
pressure constant state
  • 恆 : Ⅰ形容詞1 （永久; 持久） permanent; lasting 2 （平常; 經常） usual; common; constant Ⅱ名詞1 （恆心...
  • 壓 : 壓構詞成分。
  • 狀 : Ⅰ名詞1 （形狀） form; shape 2 （情況） state; condition; situation; circumstances 3 （陳述事件或...
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 狀態 : status; state; condition; state of affairs: （病的）危險狀態 critical condition; 戰爭狀態 state o...
  1. The system is based on the inner pid regulate function of frequency converter to regulate the living water stress with low constant stress, and the stress signal is sensed by the stress translator as feedback signal and the construction is sent by the computer as the given signal. the water stress is regulated to high constant stress when the fire happens

    本論文基於變頻器內置pid調節系統，以管網的壓力變送器壓力信號作為反饋信號，由上位機發出的當前狀態作為給定輸出，調節生活供水壓力使其保持低恆壓狀態；當火災發生時，調節系統管網壓力為高恆壓狀態。
  2. They will short down the working life of air compressor because they are always started or stopped when we want to make the railway carriage stay in a fixed temperature. now, automatic and intelligent control systems are being applying in bus air - conditions control. in this way, computers control the work of air compressor, the turnaround speed of fan, the open degrees of wind controlled doors and so on

    我國大多數客車空調仍然採用簡單的壓縮機開關控制及循環離合控制系統，如：離合器?熱力膨脹閥系統（ cctxv ）和離合器?節流管系統（ ccot ） ，這些控制方式的精度低，當進行恆溫控制時壓縮機處于頻繁的開、停狀態，縮短了壓縮機的工作壽命。
  3. When the transportation load is long - term evenly distributed, the influences of each relevant factor, i. e. pipeline depth, diameter, deformation module of foundation, poisson ratio of soil and tyre pressure of vehicles, toward mises stress and vertical displacement of pipelines are discussed. when the transportation load is movable and invariable, the changing rules of mises stress and vertical displacement during the vehicle ' s movement are calculated and analyzed, and effects of vehicle velocity and tyre pressure toward these two mechanical characteristics are discussed. when the transportation load is stable and simple harmonic, the changing rules of mises stress and vertical displacement during the time of load function are calculated and analyzed, and effects of vehicle velocity and tyre pressure toward these two mechanical characteristics are also discussed. in three - dimensional analysis, mises stress and vertical displacement of pipelines under three kinds of transportation loads are calculated, and the analysis and discussion of correlative factors are also made

    當交通荷載為長期均布荷載時，討論了各相關因素，包括管道埋深、管徑、地基變形模量、地基泊松比和車輛輪壓大小分別對管道mises應力和豎向位移的影響；當交通荷載為移動恆載時，計算並分析了車輛行駛過程中管道mises應力和豎向位移的變化規律，討論了車速和車輛輪壓對這兩個管道力學性狀的影響；當交通荷載為穩態簡諧荷載時，計算並分析了荷載作用時間內管道mises應力和豎向位移的變化規律，討論了車速和車輛輪壓對管道力學性狀的影響。
  4. A stressor is anything in the environment that knocks the body out of homeostasis, and the stress response is the array of physiological adaptations that ultimately reestablishes balance

    所謂的壓力源，指的是使身體偏離恆定狀態的任何環境因子，而壓力反應則是一系列的生理適應，終究將重建身體的平衡狀態。
  5. Based on the experiment of nimh battery, investigations on characteristics of discharging and charging of nimh battery, and analysis of influencing factor of nimh battery, an approach of ah ? coe ? ocu has been carried out to estimate an accurate surplus energy and state of charge of nimh batteries, and consider the compensation of the temperature, aging and self - discharging etc. after theoretic analysis has been completed, simulations are given to determine parameters of batteries for changan hev

    本文在蓄電池試驗的基礎上，分析和研究ni - mh蓄電池充放電特性及其影響因素，建立了電池內阻、電動勢模型，提出了安時?能量守恆?開路電壓演算法（ ah ? coe ? ocu法）預測蓄電池的剩餘能量和荷電狀態計算方法，並進行溫度、循環使用壽命、自放電等補償，從而建立了蓄電池的充放電模型。
  6. In general, by utilizing observing instrument, estimates of systemvariable are obtained ; and the minimal energy control system principle isused to control the supply pressure so as to attain the goal of economizedconstant pressue water supply

    概括地說，就是應用觀測器，得到了狀態變量的估計值，並按最小能量系統控制規律控制供水k力，達到了恆壓供水的目的。
  7. The hardware circuit design include : industrial control computer configuration, selection of industrial control board type, design of the power supply and monitoring interface circuit, design of signal processing interface circuit ( the constant current source circuit, the time base signal processing circuit, the processing circuit for the signal to be measured ), design of panel control circuit, design of the system self - checking circuit, and etc. the program flow hart include : main program flow chart, system boot - strap self - checking program flow chart, manual static testing program flow chart, semiautomatic static testing program flow chart, automatic static testing program flow chart, dynamic testing program flow chart, transient testing program flow chart, source voltage and current monitor program flow chart, investigate function testing program flow chart, and etc. the measure system offers six working power supplies, the signal of time base, the signal of constant current source, sine wave signal and step to leap signal, and measures the frequency of the output pulse signal of the wide range pulse convert circuit accurately under three kinds of different test state ( static form, dynamic form and transient form )

    硬體電路設計包括：工控機配置、工控板卡選型、產品電源及監控介面電路設計、信號處理介面電路（恆流源電路、時基信號處理電路、被測信號處理電路）設計、面板控制電路設計、系統自檢電路設計等。程序流程圖包括：主程序流程圖、系統開機自檢程序流程圖、手動靜態測試程序流程圖、半自動靜態測試程序流程圖、自動靜態測試程序流程圖、動態測試程序流程圖、暫態測試程序流程圖、電源電壓和電流監控程序流程圖、研究功能測試程序流程圖等。測試系統提供六路工作電源、時基信號、恆流源信號、正弦波信號和階躍信號，並對三種不同測試狀態（靜態、動態、暫態）下大量程脈沖變換電路輸出脈沖信號的頻率進行精確測量。
  8. Oddly, the inferred elapsed time between ejection episodes, about 500 years, is too long to be explained by dynamic pulsations ( in which the star contracts and expands, in a gentle tussle between gravity and gas pressure ) and too short to represent thermal pulsations ( in which the star is driven out of equilibrium )

    奇怪的是，不連續噴發的間隔據推估大約是500年，但這段時間實在太長而不能以動力搏動（恆星因重力與氣體壓力間溫和的交互作用，而產生收縮與擴張的現象）來解釋，不過卻又短到無法用熱力搏動（恆星被驅向非平衡狀態）來描述。
  9. A simple constant voltage and constant current charger has been improved, the state of float charger has been added to the charger in order to guarantee the full charge of battery safely, with high charge speed. experiment results and detailed designs of power circuit and control circuit of the charger are presented

    本論文對一種簡單實用的恆壓恆流充電器進行了改進，在恆壓恆流充電的基礎上加入了浮充狀態，從而保證了蓄電池的滿充；同時對充電器的功率電路和控制電路進行了詳細的設計，並且給出了實驗結果。
  10. Pressure constant state

    恆壓狀態
  11. Otherwise, an active integral chaotic measuring circuit is suggested based on the analysis of the present nonlinear circuits in this paper, which gets rid of nonlinear distortion of map function in constant - voltage mode and defect of constant - current source operating on - off state. using a general operational amplifier, high precision can also be obtained. a nth - order chaotic measuring system can be composed of its interconnection

    另外，本文在分析原有非線性電路的基礎上提出一種有源積分式混沌測量電路，它克服了恆壓式測量電路映射函數存在非線性失真、恆流式測量電路不宜工作在開關狀態的不足，利用普通的運放也獲得較好的測量精度。
  12. Two abb frequency converters and a siemens programmable logic controller ( plc ) are with the lower - level computer and industry computer are with the host computer. the communication between with the host computer and low - level computer not only translate the system condition, but also send the control instruction. the system condition is shown with chinese window in the host computer, and the constant stress function is realized through the frequency converter part

    2臺變頻器和plc作為下位機設備，工控機作為上位機集中控制，上下位機之間通過通訊，把系統當前狀態、當前給定通過上位機來綜合判斷，並通過上位機以漢化界面形式予以顯示，而下位機的變頻部分則實現管網的恆壓功能， plc實現4臺水泵機組邏輯控制和定期巡檢，及部分故障綜合報告。
  13. For gases, one has to distinguish between the changes of state which take place under constant volume and those under constant pressure.

    對于氣體來說，必須把恆容和恆壓下發生的狀態改變區別開來。
  14. Abstract : the multifunctional inverter power sourcethe handy inverter welding, plating & charging manchine, developed with advanced inverter and micro - electronics control techniques, adopts “ half - bridge power expansion supply midpoint voltage autocontrol setting ”, and technically and effectively having solved inverter subvision of inverter power expansion circuit for leaning magnetism, reliability of high - power inverter setting, achives combination of constantcurrent and constantvoltage export, and realizes low - voltage dc and high - voltage ac double power supply

    文摘:運用先進的高頻逆變技術和微電子控制技術設計研製的逆變式多功能電源便攜式逆變焊鍍充電多用機，採用「半橋式功放級供電中點電壓自動控制調節裝置」 ，在技術上解決了逆變功放電路因偏磁而造成的逆變顛覆，有效地解決了大功率逆變器的可靠性問題；進行多種外特性的綜合設定，實現了恆流與恆壓輸出的合一；與傳統焊機相比，實現了開環和閉環狀態下都互不影響的低壓直流電瓶和高壓交流雙供電
分享友人
分享到 Line

分享到臉書