恆壓調節 的英文怎麼說

中文拼音 [héngyādiàojié]
恆壓調節 英文
constant potential regulation
  • 恆 : Ⅰ形容詞1 （永久; 持久） permanent; lasting 2 （平常; 經常） usual; common; constant Ⅱ名詞1 （恆心...
  • 壓 : 壓構詞成分。
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. A white led driver circuit is presented in this paper. the circuit drives up to four white leds with regulated constant current for uniform intensity. by utilizing proprietary adaptive 1x / 1. 5x modes and ultra - low - dropout current regulators, it maintains the highest possible efficiency over the full 1 - cell li + battery input voltage range

    整體電路以恆定電流驅動4隻白光led ，利用1倍/ 1 . 5倍分數型電荷泵和低壓差電流調節器，在整個鋰電池供電電壓范圍內保持最高的效率，並使四個白光led獲得均勻的亮度。
  2. A precision pressure regulator maintains the carrier-gas pressure constant.

    精密壓力調節器可以維持載汽壓力恆定。
  3. To tune up the frequency of power supply by the transducer in the system, this adjusting make the speed of electromotor and performance curve of pump change. at last, it make the status of a pump alter

    在變頻調速恆壓供水系統中，單臺水泵工況的調節是通過變頻器來改變電源的頻率f來改變電機的轉速n ，從而改變水泵性能曲線得以實現的。
  4. Through analyzing the figure of energy wasting of pump, the quality in pipes is direct proportion of the speed of pump if the speed of pump is reduced. the power of electromotor fell the cube of the speed of pump. so the energy wasting of constant pressure water supply based on variable frequency speed regulating technology is envident less than the traditional mode is used throttle to supply water

    分析水泵工況的能耗比較圖，可以看出利用變頻調速實現恆壓供水，當轉速降低時，流量與轉速成正比，功率以轉速的三次方下降，與傳統供水方式中用閥門節流方式相比，在一定程度上可以減少能量損耗，能夠明顯節能。
  5. Ar air regulators in multiple burner systems, hold constant air - fuel ratio and the mixture pressure with reducing burner port area of up to 90 %

    Ar空氣調節閥用於多爐頭系統，保持恆定的空氣燃料比和混合氣壓力。
  6. The system is based on the inner pid regulate function of frequency converter to regulate the living water stress with low constant stress, and the stress signal is sensed by the stress translator as feedback signal and the construction is sent by the computer as the given signal. the water stress is regulated to high constant stress when the fire happens

    本論文基於變頻器內置pid調節系統，以管網的壓力變送器壓力信號作為反饋信號，由上位機發出的當前狀態作為給定輸出，調節生活供水壓力使其保持低恆壓狀態；當火災發生時，調節系統管網壓力為高恆壓狀態。
  7. The result of the study shows that the electro - hydraulic proportional technology is useful for all - hydraulic operated drilling machine to simplify the operations and composition of system, to improve the level of automatization and efficiency and to reduce the consumption of energy. the result of the study also shows that the system of feeding has the properties as followed : fast respone, stable pressure - adjusted characteristic, distinct effect of energy - saving, some improvement of system efficiency

    研究結果表明：全液壓鉆機中應用電液比例技術，可以簡化系統組成和操作，提高鉆機自動化水平，提高系統效率，降低發熱和溫升；採用恆壓變量泵的給進加壓電液比例控制系統調壓性能穩定、響應快、節能效果明顯。
  8. In addition, in order to make the pumps realize constant injection pressure, the expert tuning pid vfvs constant injection pressure control sub - system for pumps is established and relevant software module is developed. the sub - system can control automatically the quantity and rotate speed of the pumps running to realize the pumps optimum run according to the seawater injection plan of the oil field, which realizes constant injection pressure, energy saving and decreases the consumption to a large degree

    此外，為平臺注水泵機組的優化運行構建了基於專家整定pid控制的變頻調速恆壓注水控制子系統，並開發了相應的軟體模塊，完全省卻了pid控制器的硬體設備，使得注水泵機組可以根據油田注水量的配注方案優化運行，自動控制注水泵的轉速和運轉臺數，既能實現平穩增壓注水，又能在很大程度上節能降耗。
  9. This thesis comes from the technological innovation project 2002 in xi ' an. the research is focused on the adaptive hybrid excitation synchronous generator system with constant output voltage. in order to keep the output voltage constant, the adaptive control is introduced in the digital voltage regulator of the generator system

    本課題來源於2002年西安市重大技術創新工程計劃?自適應復合勵磁恆壓同步發電機系統的研究，通過採用數字電壓調節器對復合勵磁同步發電機的自適應控制，實現發電機的恆壓發電輸出。
  10. It also builds the mathematic model of all section of vscf ac exited wind power generation system on a - b - b and d - q coordinate system by the coordinate commutation technology. the thesis gives the characteristics of torque, active power, reactive power and the steady - state analysis of it. it proves that the capability of wind generator is determined to slip, the amplitude and phase of rotor voltage, the phase dispatch between stator voltage and rotor voltage

    並分析了交流勵磁風力發電機作變速恆頻運行時的工作原理，闡述了與同步發電機、異步發電機的不同之處，分析了其能量平衡關系，在坐標變換技術的幫助下，詳細推導了交流勵磁發電機在a - b - c坐標系和d - q坐標系下的數學模型，分析並模擬了其有功和無功特性、轉矩和功率調節特性、穩態運行和機械特性，證明了發電機的性能由轉差率、轉子電壓的相位和幅值、定轉子電壓相位差所決定的。
  11. In the dissertation, a novel hybrid excitation constant voltage synchronous generator is adopted to improve the system performance, which takes the advantages of both electrical excitation and permanent magnet machines. a parted configuration is presented in order to design the structure of the generator. the adaptive digital adjustment is settled in principle using the single chip microcomputer 80c31 as the control core of the voltage regulator and adopting the proportion - integral - differential control as the control arithmetic, then a sample is made

    論文對同步發電機的工作原理、性能特點、電機本體以及電壓調節器的硬體和軟體設計進行了研究，針對稀土永磁同步發電機變載、變轉速情況下輸出電壓不可調的不足之處，採用一種新穎的電機型式? ?自適應復合勵磁恆壓同步發電機，綜合了永磁發電機和電勵磁發電機的優點，提出一種磁路分開的結構進行電機本體的設計，並選用單片機80c31作為電壓調節器的控制核心，比例?積分?微分控制（ pid ）作為其控制演算法，從原理上較好地解決了其電壓的自動數字調節，並試制了一臺樣機。
  12. Aiming at the problems of the k190jik rail welding machine, that the parameter modification is difficult, the welding process is not enough stability and the welding machine has no on - line diagnosis function, in this paper, the control system of the welding machine was promoted completely adopting the fx2n - 64mr programmable logic controller and the pcl - 1800 data acquisition card, the das ( data acquisition system ) was set up by using labview and visual basic software, the functions of welding voltage stabilizing and adjusting, current controlling and intellectual modification was improved, welding quality diagnosis system was built up, and the assembling and debugging of the control system was completed, including the process experiments

    本文針對k190jik鋼軌焊機控制系統存在參數修改困難、焊接過程不夠穩定、無焊接質量在線診斷功能等問題，採用日本三菱公司fx2n - 64mr可編程序控制器、研華工控pcl ? 1800數據採集卡等為核心控制部件，對焊機的整機控制系統進行了全面升級。運用軟體labview和vb開發了數據採集系統，完善了焊接穩壓、調壓、電流恆值控制與智能調節功能，利用vb建立了焊接質量在線診斷系統，並完成了系統組裝調試與工藝試驗研究工作。
  13. Constant gas flow control box is composed of pressure stabilizing valve, pressure meter, flow control valve and flowrator, gas contain and regulating valve and so on

    恆氣流控制箱由穩壓閥壓力表流量控制閥和轉子流量表氣容和調節閥等組成。
  14. The system maintains the pressure constant through continuous sampling to pressure, and pid adjuster operating and obtaining control parameter to control the system implementing part

    該系統通過對壓力進行連續采樣，由pid調節器運算得出控制參數，對系統執行機構進行控制，從而維持壓力恆定。
  15. With the application of real - time multi - tasks mechanism and modulization software structure, the controller can set and modify the parameters on - line, collect and process the real - time data of the four - battery charge / discharge devices, termly and digitally regulate the closed loop and monitor the real - time faults, so that the system can control different styles of charging and discharging operate mode such as in constant current style, constant voltage with limited current style and static style

    控制器軟體採用實時多任務機制和模塊化的設計思想，通過對蓄電池化成充放電過程中工藝參數的在線設定修改、實時數據的採集處理、定時的數字閉環調節和故障的監測，實現對蓄電池靜電、恆流、恆壓限流等多種充放電工作方式的控制。
  16. Traditional direct torque control uses two value torque regulator which makes zero voltage vector work long and make flux shape bad seriously and makes response time long when the speed of induction motor is very low or drops down quickly. in order to solve this problem the thesis puts forward a new way to use three - value torque regulator, when the motor speed is very low or drops down quickly, the contrary voltage vector is used instead of zero voltage vector and the between the stator flux and rotor flux is reduced quickly so that torque is reduced quickly and response time becomes shorter

    為此，本論文提出三點式轉矩調節，這樣當電機低速運轉或給定轉速突降時，不是加零電壓矢量，而是加反方向的電壓矢量，使定子磁鏈與轉子磁鏈之間的夾角迅速減小，從而使電磁轉矩也迅速減小，大大減小了調速時間，同時磁鏈值仍然保持基本恆定，輸出比較穩定的電磁轉矩，這在電機制動過程中非常有用。
  17. Constant voltage regulation

    恆壓調節
  18. Based on the experience of regulating frequency according to different valve ' s angle, a reasonable controlling tactic is proposed. when the situation changes to a small degree, electromotor makes fan running at a constant rate ; when the situation changes to the limiting range, the discharge header pressure is automatically adjusted by the rate of fan

    制定合理的控制策略，採用基於閥門開度的變頻調節策略，即工況變化較小的情況下，電機帶動鼓風機恆速運行，通過控制閥門開度自動調節集氣管壓力；當閥門開度到達極限值，還不能達到控制要求時，再通過變頻器改變鼓風機轉速，以自動調節集氣管壓力。
  19. What the machine has superior to others is that it is able to insist the pressure invariableness, and pulse, shield and temperature can be adjusted

    與現有技術相比cim具有保持沖洗壓力在恆定的范圍、實現脈沖水流、能調節沖洗液溫度、噴槍上設有防護罩等優點。
  20. Constant voltage regulator

    恆壓調節器
分享友人
分享到 Line

分享到臉書