恆溫循環 的英文怎麼說

中文拼音 [héngwēnxúnhuán]
恆溫循環 英文
constant temperature cycle
  • : Ⅰ形容詞1 (永久; 持久) permanent; lasting 2 (平常; 經常) usual; common; constant Ⅱ名詞1 (恆心...
  • : Ⅰ形容詞(不冷不熱) warm; lukewarm; hot; gentle; mild Ⅱ名詞1 (溫度) temperature 2 (瘟) acute ...
  • : 循動詞(遵守; 依照; 沿襲) follow; abide by
  • : Ⅰ名詞1 (環子) ring; hoop 2 (環節) link 3 (姓氏) a surname Ⅱ動詞(圍繞) surround; encircle;...
  • 循環 : circulate; circle; round; repeat; loop; period; recurrence; cycling; circulating; mixing; circula...
  1. In addition, for temperature stabilization, the cuvette holder ' s base plate has internal channels that can connect to a circulating, constant - temperature water source

    另外為了達到穩定的度,試管支架的底架有內部通道,通道與一個的、的水源連通。
  2. The extruders drived by d. c motor with a thyristro to stepless regulate. it also equipped with the over - load prtection and stoppage alsrmingsystem. the screws core and the outside of barrels are cooled by the circulation of oil, ther fuctions include vacuum venting and forced feeding

    本機採用直流電機,可近期硅無級調速,沒有過載保護和故障報警、螺桿芯部油、機筒油冷卻,並裝有真空排氣管裝置和定量喂料裝置。
  3. So it is very important to understand the cyclic deformation behavior of zircaloy - 4. in this paper, bauschinger effect of zircaloy - 4 with different metallurgical state at room temperature and 400 ? is investigated in an incremental step test and cyclic deformation test under constant strain control. bauschinger effect during cyclic deformation is described by using back stress, which is mainly responsible for bauschinger effect ; back stress is attained by using kwl " s method

    本文採用單試樣逐級加載變形和應變幅變形試驗,研究了不同冶金狀態、度、氫以及固溶處理下的zr - 4合金的bauschinger效應現象;種種結果表明,影響bauschinger效應的主要因素是背應力;本文正是從背應力的角度來分析各種狀態下zr - 4合金的bauschinger效應現象;背應力的計算主要通過使用kwl方法而獲得。
  4. The experimental results is shown as followings : ( 1 ) the cyclic flow stress - strain curves in an incremental step test could be expressed as the power law relation : ( 2 ) when the strain amplitude is lower during cyclic deformation tests under constant strain control, softening firstly appears, then gradually hardens with the increasing numbers of cycle ; when the strain amplitude is higher, hardening firstly appears, then gradually softens

    試驗結果表明: ( 1 )流變應力與應變的相互關系曲線均符合冪律關系式: ( 2 )在室下進行應變幅變形過程中,當所控制的應變幅較小時,該材料首先出現軟化,之後隨周次的增加直至失效前該材料出現了硬化現象。當應變幅較大時,該材料開始出現硬化,然後隨周次的增加才出現軟化。
  5. Ceramic fuel cells are electrochemical devices that directly convert fuels such as gasified coal or natural gas into electricity without the limitation of the carnot cycle ( an ideal thermodynamic cycle in which heat is taken onto a working fluid at a constant upper temperature and rejected at a constant lower temperature )

    陶瓷燃料電池是一種電氣化學裝置,能直接將煤氣、天然氣等燃料直接轉化為電能而不會受到卡諾(一種理想的熱力,熱量在定高下轉化成工作流體,在定低下被釋放)的限制。
  6. Pre - heating oven. oil heating for bronzing plate, constant temperature auto control, oil pump circulation

    燙金版油加熱,自動控制,油泵
  7. 5. sealed hot wind circulationg oven, automatic constant temperature, diesel oil air - stove or electrical heating for the drying methods

    5封閉式熱風烘箱,自動懂控制,加熱方式柴油熱風爐或外置式電加熱。
  8. They will short down the working life of air compressor because they are always started or stopped when we want to make the railway carriage stay in a fixed temperature. now, automatic and intelligent control systems are being applying in bus air - conditions control. in this way, computers control the work of air compressor, the turnaround speed of fan, the open degrees of wind controlled doors and so on

    我國大多數客車空調仍然採用簡單的壓縮機開關控制及離合控制系統,如:離合器?熱力膨脹閥系統( cctxv )和離合器?節流管系統( ccot ) ,這些控制方式的精度低,當進行控制時壓縮機處于頻繁的開、停狀態,縮短了壓縮機的工作壽命。
  9. Based on the experiment of nimh battery, investigations on characteristics of discharging and charging of nimh battery, and analysis of influencing factor of nimh battery, an approach of ah ? coe ? ocu has been carried out to estimate an accurate surplus energy and state of charge of nimh batteries, and consider the compensation of the temperature, aging and self - discharging etc. after theoretic analysis has been completed, simulations are given to determine parameters of batteries for changan hev

    本文在蓄電池試驗的基礎上,分析和研究ni - mh蓄電池充放電特性及其影響因素,建立了電池內阻、電動勢模型,提出了安時?能量守?開路電壓演算法( ah ? coe ? ocu法)預測蓄電池的剩餘能量和荷電狀態計算方法,並進行度、使用壽命、自放電等補償,從而建立了蓄電池的充放電模型。
  10. Having no heat thermostatically device, liquid level automatically controlled, spraying and filtration economizes the cost, be easy and simple to handle, strong ability to clean, be suitable for the products that is large output, complicated and difficult to clean

    設有加熱裝置,液位自動控制,噴淋、過濾節約成本,操作簡便,洗凈能力較強,適合產量多、復雜、難洗的產品。
  11. The sl401 circulating water refrigeration unit is mostly used as a supporting product for precision instrument facilities with the need of isothermal cooling water, for example, the x - ray diffractometer, fluorescence spectrometer, scanning microscope, laser, energy spectrometer, vacuum forming machine, high - frequency generator, mocvd, etc

    Sl401型水製冷機組主要為x射線衍射儀、熒光光譜儀、掃描顯微鏡、激光器、能譜、真空成型機、高頻機、 mocvd等需用冷卻水源的精密儀器設備的配套產品。
  12. Inside cool water circulation system can guarantee invariance temperature, stable laser output power

    內封閉製冷系統,水可保證度,激光功率輸出穩定。
  13. The isothermal oxidation behavior at 900 - 1300 for 20 h in air followed a parabolic rate law as well as the cyclic oxidation behavior at 1100 - 1300 for 30 cycles

    Ti3aicz在900一1300 「 c的空氣中氧化20h和在1100一1300 「 c空氣中氧化30次都符合拋物線規律。
  14. For the cyclic deformation under a given strain at room temperature, cyclic softening is usually displayed till to failure in the lower range of strain ; however, cyclic hardening is displayed in the early stage in the higher range of strain, subsequent cyclic softening in the later stage and till to failure

    對于室應變幅的變形,在應變幅較低時表現為軟化直至疲勞破壞;在應變幅較高時,變形的初期為硬化,隨后是軟化直至疲勞破壞。
分享友人