慣性閥 的英文怎麼說

中文拼音 [guànxìng]
慣性閥 英文
crv coasting richer valve
  • : Ⅰ動詞1 (習以為常 積久成性; 習慣) be used to; be in the habit of 2 (縱容; 放任) spoil; indulge...
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • : 名詞1 (指在某方面有支配勢力的人物或家族) established house or power group; a powerful person or...
  • 慣性 : [力學] inertia; inertance; sluggishness; the force of inertia
  1. Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads

    第四章介紹了多執行器復合控制實驗系統和實驗方法;介紹了實驗採用的流量控制的pid演算法;並測定了執行器控制芯位移相關的系數;做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗;通過實驗說明了論文提出的分流控制方法能實現大小負載復合操作時的合理分流。
  2. According to the law of mass moment of inertia and of momentum moment, the conditions for the complete dynamic balance of rotor inertial forces and moment of inertia in the rotary piston vacuum pump are put forward, with the rotor movement in single cylinder analyzed as basis

    根據質量矩定理和動量矩定理對單缸滑真空泵的轉子運動狀況進行了分析,分別提出了轉子力和力矩完全動平衡的條件。
  3. However, by comparison with flap nozzle servo valve which has been used widely and popularly by now, the torque motor of jet pipe servo valve has a larger rotary inertia. this causes low natural frequency of servo valve, and thus the response speed of jet pipe servo valve is slow. moreover, the jet pipe of servo valve has large flexibility, and it is easy to excite oscillations and noise in the valve, which is named self - excited oscillations and noise

    然而與目前普遍使用的噴嘴擋板伺服相比,射流管伺服的銜鐵組件轉動量大,導致力矩馬達部分固有頻率低,從而響應速度慢,此外,射流管供油管柔大,容易產生自激現象,這些缺點都使得射流管伺服的動態特差,從而影響了它的工作能。
  4. In order to decreasing hydraulic impact, the principle is analyzed to eliminate or increase hydraulic impact by means of changing eccentric lump structure to cut down the inertia force of starting, changing the pressure of pilot electromagnetic relief valve and changing the parameters of accumulator

    為了減小液壓沖擊,本文分析了用改變偏心塊結構減小起振力的方式、用改變先導式電磁溢流溢流壓力方式和改變蓄能器參數方式消除或減小液壓沖擊的原理。
  5. Inertia proportioning valve

    比例
  6. Crv coasting richer valve

    怠速加濃補償
  7. This paper is focused on the mathematical description of hydraulic control system, in which the hydraulic power comes from variable pump, the actuators are two valve - controlled motors, and the load is purely inertial

    摘要探討了由變數泵為液壓源、 2個控馬達為執行元件以及負載組成的液壓控制系統的數學描述,並給出了其線化模型。
  8. Optimizing design of inertia proportional valve

    比例的優化設計
  9. Then, the article carried out simulation of automobile brake system in detail. according to the structure, theory and character of the brake force adjustment, the function of one of the brake force adjustment - dspv valve is realized. a simulation of full vehicle is carried out in adams. the simulation results match well with the physical prototype experiment

    通過增加和改進系統原有模型的控制功能,將dspv慣性閥引入adams ,實現制動力調節功能,並且利用北汽福田汽車公司的奧鈴輕卡進行整車道路制動試驗,制動能模擬計算結果與實測結果也取得了較好的一致
  10. One is null oscillation occurred in the ehs valve, the second is the failure in the torque motor circuit, and the third is the load disturbance in the actuator

    然後對系統中其他幾種故障作了分析,包括伺服中位顫振故障;線圈故障;液壓缸運動變化故障。
分享友人