扭阻力 的英文怎麼說

中文拼音 [niǔzǔlì]
扭阻力 英文
twisting resistance
  • 扭 : 動詞1 （掉轉; 轉動） turn round 2 （擰; 旋轉） twist; wrench 3 （擰傷） sprain; wrench 4 （走路時...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 阻力 : 1 （阻礙事物發展的外力） obstruction; resistance 2 [物理學] resistance; drag; drag force; nowel; ...
  1. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  2. Based on the special property of magnetic fluid ( mf ), we fill the magnetic fluid into the working clearances of the servo valve torque motor. one side, the magnetized magnetic fluid can exert a damping torque on the torque motor armature and reduce vibration of the armature ; on the other side, it can improve the magnetic circuit efficiency of the torque motor because of the magnetic fluid ’ s larger magnetic permeability

    基於磁流體所具有的特殊性質，將磁流體添加到伺服閥力矩馬達的工作間隙中，一方面磁流體被磁化后可增大銜鐵的阻尼力，減少振動;另一方面由於力矩馬達氣隙中磁導率的提高，使氣隙中的磁通量增大，力矩馬達的磁路效率和輸出扭矩將增大，因此可以提高力矩馬達的固有頻率和伺服閥的響應速度。
  3. Electronic co., ltd., a private hi - tech company, professionally makes and markets electronic instruments and gauges, such as digital torque tester, bottle cap torque tester, voltage resistance tester, grounding resistance tester, leakage current tester, insulation resistance tester and etc. lankers quality instruments and gauges are characterized by well - designed structure, high reliability and stability and outstanding performance and are well sold to users in the industries of home appliances, motorcycle, automobile, motor and pharmaceutical

    市藍光電子有限公司是一家集科研生產銷售於一體的高科技民營企業，公司擁有雄厚的技術實力，以卓越的設計能力，完備的工藝控制和完善可靠的檢測手段，向用戶提供高性價比的電子測量儀器。主要產品有：數字扭力測試儀系列瓶蓋扭力測試儀系列耐電壓測試儀，接地電阻測試儀，泄漏電流測試儀，絕緣電阻測試儀等安規測試儀系列。
  4. The simulations get the variation curve of the torque acted on the helical gear spline during translating process, and get the important damping force acted on the middle part during engaging and disengaging process

    模擬還求得了作用在螺旋齒花鍵上的扭矩在動態過程中的變化曲線；求得了作用在中間件上，起關鍵作用的阻尼力在嚙合、脫開中的動態變化曲線。
  5. The crucial technologies of highly - displacement well mainly include torque / friction and wellbore trajectory control tool, and these technologies require rock bit have the following characteristics : having gage protection ability, long axletree lifespan, wear - resisting shirt - tail and head o. d., and high - temperature - resistant sealed system, etc

    大位移井的關鍵技術主要有扭矩摩阻和井眼軌道控制工具，這些技術要求鉆頭具有以下特點：具有良好的保徑能力，軸承壽命長，掌尖和掌背部位耐磨損，密封系統耐高溫等。
  6. Based on the structural feature of long blade with friction damper, pretwist beam element and space straight beam element were adopted to discrete the blade, and the numerical model of damper link element was established, then the gross finite element motion equation of the blade was obtained

    針對帶摩擦阻尼器長葉片的結構特點，採用扭曲梁與空間直梁單元模化葉片，推導葉片阻尼連接單元的力學模型，由此建立葉片總的動力特性分析方程。
  7. Two models of friction are proposed, the simulation results show together : kurtosisness of torsional vibration will decrease, low harmonic and main harmonic of torsional vibration will increase when cylinder scoring

    創造性地利用了扭振信號診斷柴油機拉缸故障。拉缸時，由於摩擦阻力的增大，發動機噴油量達到最大。
  8. By establishing force equilibrium equations, a mechanical model for calculating the friction on the string is set up, and the analytical formulas for calculating the hook load and wellhead torque when the string is tripped in

    通過建立管柱受力平衡方程，推導出水平井管柱入井時摩阻計算的力學模型，分析計算了在穩定和旋轉方式下管柱入井時的大鉤載荷和井口扭矩等重要技術參數的解析公式。
  9. In practical application, the m10 180 bolts, which are installed in the head cover of the torque divider of ts5560 special automobile, sometimes fracture all of a sudden. according to the tests of acceleration, stress and strain, and the exciting test, it is resonance vibration that leads to the compound - bending fatigue fracture of the bolts. the exciting force caused by drive system, transmitted through the torque divider, produces a 1000 - 1500hz cyclical excitation at the junction of the bolts and head cover, which causes the first order bending resonance vibration of the bolts

    通過加速度、應力應變測試實驗和激振試驗的研究，發現ts5560特種車分動器取力器氣缸端蓋m10 180螺栓斷裂問題是由於共振引起的雙向彎曲疲勞斷裂：傳動系統工作所產生的激勵，經過分動器結構的傳遞（特別是分動器一階扭轉模態的放大） ，在螺栓的連接處產生1000 1500hz的振動激勵，其導致螺栓一階彎曲共振，在螺栓一階彎曲模態的阻尼比較小的情況下，使得螺栓產生較大的共振響應，導致螺紋處的彎曲動應力較大，疲勞壽命較低。
  10. Lastly, previous vane are analysed by fluent, we calculate the pressure distribution chart and report chart of each wing form, then alter the torsion angle and the airfoil form of the vane respectively, finally ascertain the influence curve of the torsion angle and the airfoil form of the vane on which act the lift power

    最後，通過fluent對設計出的葉片分析，得出其壓力分布圖和報告圖。然後從改變葉片的扭轉角度和翼型兩個方面分析其對升力和阻力的影響。得出葉片的扭轉角和翼型對升阻比的影響曲線，在文章的結尾部分估算了無人機的一些性能參數。
  11. The result of simulation of model 8 ? 1 / 2 ? xhp2s bit shows that, the torque on the bit changes randomly, and the degree of the change increases with the increase of the weight on bit ; the change of the torque on the upper part of the drillstring is not so large as that on the string ' s lower part, and the rotary speed of the bit changes smoothly overall

    對8英寸xhp2s鉆頭做了模擬，結果表明，鉆頭處受巖石的阻力扭矩是隨機變化的，並有負扭矩出現，扭矩的變化幅值隨靜鉆壓的增加而增加；鉆柱頂部轉盤施加的扭矩變化不如底部劇烈；鉆頭的轉速在局部有較小的波動，其總體變化較為平緩。
  12. The first two are indirect methods in as much as they rely on measurements of overall torque or resistance and boundary layer similarity laws to obtain du +, whereas the velocity profile method provides a direct measurement of du +

    首兩個是間接的方法一樣因為他們依靠的測量整體扭矩或阻力和邊界層相似性法律以取得杜+而流速剖面法提供了一個直接測量杜+ 。
  13. In this paper, some aspects such as the behavior of pore pressure of unsaturated loess, the dynamic constitutive relationship and the characteristics of the dynamic modulus, dynamic strength and dynamic damping ratio are studied with the dynamic torsional shear test of loess

    在以上研究的基礎上，本文又通過黃土的動扭剪試驗研究了非飽和黃土的孔隙壓力特性、動本構關系、動剪切模量特性、動強度特性以及動阻尼比特性。
  14. Before the second cash, the safety mechanism benefit occupant to safe condition. the safety mechanism is very cheap and it can be bought by most consumer. based on the multi - body dynamics roberson - wittenburg formula, a mathematical modle of the " occupant - seat - safety mechanism " system was built, and its kinematic equation was given. the corresponding computer programme was based on the equation, kinematic equation can provide advice for safety mechanism and serve for computer imotion. r / w and kane set up their own formula. they both can prove safety mechanism is benfit to occupant

    為了研究人體的傷害機理，選擇適當的人體模型作為研究對象；人體採用二維多剛體鉸接模型，將人體簡化為骨盆、軀干、頭部、大腿、小腿、腳部、上臂和前臂八個剛體，而相應的七個關節腰、頸、髖、膝、踝、肩和肘，均簡化為帶有扭力彈簧和轉動阻尼的鉸鏈。
  15. In order to study the vibration in the artillery traveling more accurately and completely, a tire force model of non - linear and self - adapting stochastic contacting mark is set up, and this model provides a good method to study the driving system ' s horizontal and vertical excitation caused by the plainness road surface. the suspension of the tractor is simplified by the model of spring - damp system, and the artillery torque rod is also simplified by torsion spring

    為了更準確和全面地研究火炮牽引行駛過程中出現的振動，建立了非線性自適應隨機接地印跡的輪胎力學模型，該模型能很好地研究路面不平度對火炮牽引系統的垂直和縱向激勵；牽引車懸架簡化為彈簧阻尼系統；火炮扭轉桿簡化為扭簧。
  16. By means of the simulation calculation, varying of the torques on the bit and the drillstring top and the rotary speed of the bit can be predicted

    通過模擬計算可預測鉆頭處阻力扭矩、鉆柱頂部扭矩和鉆頭轉速的變化情況。
  17. At present the main product includes ： the resistance should the variant, the proliferation silicon, the ceramics and so on three big kind of high temperatures, center warm, the normal temperature table press, certainly press, sensor and so on negative pressure, fluid position, difference pressure, current capacity, name is heavy, measures strength, torque, displacement, temperature / changes delivering and the necessary control measuring appliance

    目前主要產品有：電阻應變式、擴散硅、陶瓷等三大類的高溫、中溫、常溫的表壓、絕壓、負壓、液位、差壓、流量、稱重、測力、扭矩、位移、溫度等傳感器/變送器和配套控制儀表。
  18. Railway applications - track - test methods for fastening systems - determination of torsional resistance

    鐵路設施.軌道.緊固系統的試驗方法.抗扭曲阻力的測定
  19. Railway applications - track - test methods for fastening systems - part 2 : determination of torsional resistance

    鐵路設施.軌道.緊固系統的試驗方法.第2部分:扭轉阻力的測定
  20. The increase in heat transfer coefficients and the concomitant pressure drops inserts is found to be strongly influenced by tape - induced vortex motion and higher flow velocity due to the tube blockage.

    4mpa 。試驗系統地研究了在該re數范圍空氣流動的傳熱和流阻特性，獲得了不同壓力、溫度，不同扭轉比下的數據。
分享友人
分享到 Line

分享到臉書