抖動模式 的英文怎麼說

中文拼音 [dǒudòngmóshì]
抖動模式 英文
dithering pattern
  • 抖 : 動詞1 （顫動;哆嗦） tremble; shiver; quiver 2 （振動; 甩動） shake; jerk 3 （振作; 鼓起精神） rou...
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 抖動 : （顫動; 用手振動）1 shake; tremble; vibrate; chatter 2 agitation; joggling; whipping; flutter; ji...
  • 模式 : model; mode; pattern; type; schema
  1. For a class of series - wound active power line conditioner the design approach law of a new fuzzy integral sliding mode variable structure control is presented. this method adjusts power electronic switch in order to achieve anticipated balance volt, finally makes active power line conditioner not only possess good robustness of variable - structure control and decrease vibration to the most but also increase the steady state precision. series - wound aplc adopted this control method possesses good dynamic and steady state performance

    針對串聯型有源電網調節器運用變結構控制策略，調節電力電子開關模式，以獲得預期的平衡電壓，對串聯型有源電網調節器提出了模糊積分變結構控制方法，使串聯型有源電網調節器既保持了常規滑模控制強魯棒性的優點，又減弱了滑模控制的抖振，提高了系統的穩態精度，使系統具有良好的動態和靜態性能，模擬試驗表明該控制策略是一種十分有效的控制方法。
  2. Clock recovery is an important and difficult part of tdm access, so the thesis will emphasize on it. and two methods of clock recovery are proposed in the thesis

    然後，本文對同步時鐘統計恢復法進行了分析，推導出了時鐘信號低頻抖動的時域和頻域特性公式，並利用matlab對低頻特性進行了模擬分析。
  3. The traditional simulation is based on the determinate environment. while the proposed jitter simulation environment is of a random processing, which is more closed to the real world

    傳統的時序模擬都是確定型的，而相位抖動的軟體模擬環境是一種隨機處理方式，它最接近真實的物理世界。
  4. So the sliding mode variable structure controller was discussed, which has strong robustness against the disturbance, and the chattering phenomenon inherited from vsc was taken advantage to regular valve vibration for the purpose of avoiding coagulation on it, while precision of level control can be almost unaffected. but for the reason of control limitation, especially the acceleration insufficiency, the continuous time quasi - sliding mode vsc for one class of controllable system, as the substitution of ideal sliding mode control system, which was impossible to implemented, was researched, including the three essentials, reaching condition in particular, and the chattering ex - pression was given. furthermore, the effect to quasi - sliding mode motion and chatter - ing expression by extent disturbance was also analyzed

    由於控制量相對受限制，並且主要體現在控制量加速不足方面，無法實現理想的滑模變結構控制，因此本文研究了一類能控系統在這種情況下的連續系統準滑模變結構控制，包括變結構控制三要素，尤其是到達條件；並且針對塞棒掛渣問題，給出了該情況下抖振的表達式；魯棒性方面，分析了外界擾動對準滑模運動的影響，並且給出了外擾作用下抖振的表達式。
  5. An efficient wind field simulation technique for wind - induced vibration analysis of long - span bridges is first introduced in this paper ， and the statistic characteristics of the simulated wind field are then discussed on this basis ， the time - domain expressions for the buffeting and self - excited forces acting on long - span bridges are further given a simple and practical method is presented for the non - linear parameter identification involved in the calculation of self - excited forces by using the above theory ， the wind field and aerodynamic forces acting on the hong kong ting kau bridge are obtained the time - domain buffeting response analysis of the bridge shows that the analytic results agree quite well with the experimental ones this indicates that the theory presented in this paper has reached a practical level

    介紹了一種快速高效的用於大跨度橋梁風致振動分析的風場模擬方法，並對模擬風場的統計性質進行了討論和驗證在此基礎上進一步給出了大跨度橋梁抖振力和自激力的時域表達方式，其中針對自激力計算中涉及的參數識別問題，提出了一種簡單實用的非線性參數識別方法本文採用上述理論，獲得了作用於香港汀九大橋上的風場和氣動力，據此對大橋進行的抖振響應時域分析表明，計算結果與風洞試驗結果吻合良好，說明文中述及的這套理論已達到實用的階段
  6. Based measured aerodynamic parameter and simulated wind speed field, time - domain expression of static wind load, buffeting load and self - excited load for bridge and vehicle are introduced

    基於測試的氣動參數和模擬的脈動風速場，給出了車輛和橋梁靜風力、抖振力及自激力的時域表達式。
  7. This paper selects the pulsating wind power density spectrum of davenport and simulates the wind speed time series and the wind load time by matlab. considering the vertical and horizontal correlation of the pulsating wind, the study make use of the time domain analysis of buffeting to carry out the transient dynamic analysis of the whole frame structure which is loaded by the random pulsating wind load. finally, in terms of the whole frame of the pipe belt conveyor, the evaluation for

    選取davenport脈動風功率譜，利用matlab模擬脈動風的風速時程曲線和風荷載時程曲線，並考慮脈動風的空間豎向和側向相關性，利用抖振時域法對整體機架結構進行隨機脈動風壓作用下的瞬態動力學分析，最後再對圓管帶式輸送機整體機架結構對環境風荷載的適應性做出評價。
  8. Ld - pumped nd : yag, lbo ( type - i critical phase matching ) intracavity frequency doubled, blue laser at 473nm was obtained finally. under the condition of 14w pump power, high power tem00 mode blue laser at 473nm of 1. 1w was obtained. by means of inserting diaphragm into cavity, the power fluctuation and beam mode were improved ; in the experiments, the proportion of special mode matching in quasi - three - level laser was discovered, and the phenomenon were explained reasonedly

    實驗上採用對熱效應不敏感的三鏡折疊腔， ld泵浦nd : yag ，類相位匹配lbo作為倍頻晶體，獲得了1 . 1瓦的連續473mn藍光輸出；採用腔內插入光闌的方法，有效克服了功率抖動，同時改善了光斑模式；實驗中發現準三能級激光器存在兩個空間模式匹配比例關系，並對這一現象給出了合理的解釋。
  9. The design strategy investigated is based on a sliding surface that only contains the error between the reference input wheel slip and the actual wheel slip. the design strategy uses continuous switching, in the form of a saturation or a ambrosino function, to reduce chattering in the system response

    研究的設計策略基於只包含參考輸入車輪滑移率和實際車輪滑移率間誤差的滑模面，用飽和函數或ambrosino函數形式的連續切換函數來減小系統響應的抖動。
  10. In the recent years, with the development of microcomputer technology and the needs of industrial automation. we use computer to realize the control algorithm. but during the time of realizing the vsc, because of the limits of sampling, the ideal sliding mode does not exist

    近年來，隨著計算機技術的飛速發展和工業自動化領域的實際需要，控制演算法的實現經常利用數字計算機，但當採用數字計算機實現變結構控制演算法時，由於采樣過程的限制，理想的滑動模態不存在，狀態軌跡以抖振的形式沿著滑動平面運動，這是不利於工程的實際應用的。
  11. The kinematic model of inertial measurement unit ( imu ) with mdrlg has been analyzed theoretically, the coning drift caused by dithering has been calculated, and some problems including the assembly of inertial sensors have been discussed

    本文對機抖激光陀螺捷聯慣導系統慣性測量單元的運動模型進行了理論分析，對抖動作用下的圓錐漂移進行了理論計算，對儀表安裝形式等問題進行了探討。
分享友人
分享到 Line

分享到臉書