抽力控制 的英文怎麼說

中文拼音 [chōulìkòngzhì]
抽力控制 英文
draft control
  • 抽 : 動詞1 （把夾在中間的東西拉出; 提取） take out （from in between） 2 （從全部里取出一部分; 騰出） ...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. I crept along, fighting paralysis of the calves and the thighs.

    我躡腳躡手地摸索著走，極力控制著肌肉抽搐的雙腿。
  2. The # 9 and # 10 142mw heat supply units in gansu xigu power plant, the steam extraction main pipe system adopt westation control system of westing house company and deb coordination control policy in design. the coordination control policy successfully expand the whole the running range, from the normal running condition to abnormity running condition and start or stop condition, which simplicity base on burthen and main steam pressure coordination control

    甘肅西固熱電廠# 9 、 # 10142mw抽汽母管制供熱機組，選用美國西屋公司westation控制系統，設計、應用了deb協調控制策略，從單純作為負荷和主蒸汽壓力控制協調的基本功能，成功擴展到整個運行范圍，即從正常運行工況到異常運行工況及啟、停工況。
  3. The system is different from traditional silicon controlled dephasing method, such speedy modules as whole controlled electric and electronic equipment igbt and high frequency pwm controlling methods are employed, and the voltage of exchanging power supply of motor of beam pumping units can be controlled automatically, so there is no problem of power factor being decreased brought by silicon controlled phase single controlled, power factor in power net of beam pumping units " motor is enhanced really

    由於雙管齊下，電機電網側的功率因數得到了大大提高。與傳統的可控硅移相控制方式不同，本系統採用全控型電力電子器件igbt等快速模塊及高頻pwm控制方式，對抽油機電機的交流供電電壓進行自動控制，不存在可控硅相控角所帶來的功率因數變差的問題，真正提高了抽油機電網側的功率因數。
  4. Through analyzing the structure of open caisson, and according to sinking stress principle, the paper introduced in the open caisson construction process sinking, correcting error, survey control as well as peculiar circumstance processing technical measure, such as in open caisson construction the inner - mold for sanding, framework supporting and steel binding, and concrete casting ; in open caisson sinking - control the sand in edge foot inner - mold, sand - pumping sinking, and pressure hydraulic monitor breaking and pressure - blowing sinking by air pressure blower etc

    摘要根據下沉受力原理，分析了沉井結構，介紹了沉井施工過程中的下沉、糾偏、測量控制以及特殊情況處理的技術措施，如沉井製作中的填沙內模，模板支設和鋼筋綁扎，混凝土澆注；沉井下沉控制中的刃腳內模沙土，抽沙泵抽沙下沉，高壓水槍破壓、空壓機吹壓下沉等。
  5. First, it applies fuzzy logical in the abstract and non - linear dealing ability ; second, it applies neural net in the self - study and any functions approaching ability ? through combining above two ability, it can find a best p i d non - linear controlling regularity and achieve controlling on line of the unknown subject etco therefore, it not only can strengthen robust and intelligence of the system, but also make design simple and easily be requiredo in addition, the thesis also does many works on procedure of upper - computer and basic - controller and the whole system designed can be put into work immediately

    根據啤酒發酵過程具有大慣性、時滯和非線性等特點，本論文還提出一種基於神經網路的模糊自適應pid控制方案，它一方面利用模糊邏輯的「概念」抽象能力和非線性處理能力，另一方面利用神經網路的自學習能力和任意函數的逼近能力，通過兩者的有機結合尋找一個最佳的p 、 i 、 d非線性組合控制規律，以實現對未知對象進行在線控制，並具備適應控制環境變化的能力和自學習能力等。
  6. The membrane layer is formed by the vacuum forming technology. by controlling the weight and the ratio of long path of ceramics fiber, changing the operation factor reasonably of vacuum forming, we can obtain the ceramic fiber composite membrane layer, which has pore diameters of about 5 to about 30um, porosity i s 50 - 80 %, and tensile strength is about 4. 1to 18. 1mpa and thickness of membrane layer is 0. 5 - 2 mm, has the good thermal shock resistance and peal off

    膜層採用真空抽濾成型工藝，通過控制膜組分中陶瓷纖維長徑比、纖維加入量、成型時料漿濃度、成型壓力及成型時間等可以獲得膜孔徑5 ? 30 m 、氣孔率50 ? 80 、抗折強度4 . 3 ? 18mpa 、膜層厚度0 . 5 ? 2mm 、具有良好熱性能和耐剝離性能的陶瓷纖維復合微濾膜材料。
  7. Summarize : gcs low - voltage withdrawable switchgear is a new - type low - voltage complete switchgear with foreign advanced techniques, it is meeting the requirements of loadability expansion, computer interfacing, power - control centralization, easy assembly and maintenance

    Gcs低壓抽出式開關櫃，是我國吸收過外先進技術並根據國內用戶對增容，計算機介面、動力集中控制、方便安裝維護等要求而開發的一種新型低壓成套開關設備。
  8. Then the author puts forward the most important opinion of this article - that is, ( 1 ) in the theory of incomplete contract contributed by ghm, residual rights of control are too abstract, which just like a " black box ", to lose quite a number of the ability of explanation in theory. ( 2 ) hhe article replaces the residual claim with control right as the central conception to analyze corporate governance issue

    在此之後，作者提出了本文的核心觀點：在以ghm為代表的不完全契約理論方法中，剩餘控制權太抽象了，就像一個「黑匣子」 ，使其失去了相當多的理論解釋力；用控制權取代剩餘控制權作為分析公司治理問題的中心概念。
  9. Based on the further study of dynamic characteristic of the tractor - implement combination, according to the integrated control model, which including the flowing three parameters : the engine load rate, drive wheel slip and work resistance, and the three control strategies, which are : highest production efficiency control strategy, oil consume economic control strategy and give attention to the above control strategy, we can adopt different control strategies according to different purpose of the task. applying the theory of the hybrid dynamic system to this case, the three control strategies can be abstracted to three discrete matters, and then the exchange model of the discrete matters of the top layer ( which called manage layer ) of the tractor - implement combination and the function decision model, which based on the nerve network, can be established. through this way, the best ad aptive controlling of the tractor came true

    本文研究了拖拉機機組的綜合控制問題及其最佳匹配方法，在深入研究機組動態特性的基礎上，根據發動機負荷率、驅動輪滑轉率和作業阻力三參數的綜合綜合控制模型以及三種綜合控制策略（最高生產效率的控制策略、燃油經濟性的控制策略和兼顧最高生產效率及燃油經濟性的控制策略） ，針對不同的作業目的，採用不同的控制策略，應用混雜動態系統理論，把三種控制策略抽象為三種離散事件，建立了拖拉機機組上層（管理層）離散事件切換模型，並建立了基於神經網路的功能決策層模型，從而實現了拖拉機機組的整機最優控制。
  10. The bureau is taking steps to upgrade storm water and wastewater facilities including sewer pipeline systems and pumping stations, and develop facilities to strengthen controls over rainwater overflow

    因此，下水道局和抽水站正採取措施增強雨水排水設施能力，整備控制雨水溢出的設施。
  11. By using the mathematical model for lfg pressure distribution under a vertical extraction well, method of optimum design of landfill gas collection system with vertical extraction wells was discussed in this paper, including the determination of lfg extraction flow, radius of influence of extraction well, and the buried depth of the well

    本文利用豎井抽氣條件下填埋代壓力分佈模型，分析討論了抽代系統各參數對對抽氣效果的影響，提出了垃圾填埋場填埋氣豎井收集系統的抽氣量、抽氣井影響半徑、抽氣井埋深的優化設計方法，可為填氣污染控制與回收利用系統的規劃設計及運行管理提供技術支持。
  12. On the base of the soft about the deformation of aerodynamic configuration of mav, the advanced controlling technique of the deformation o f aerodynamic configuration about the prototype mav will be explored. based on the characteristic of micro air vehicle, this paper abstracted the aerodynamic evaluation mathematics models, developed a aerodynamic engineering estimation program, all kinds of aerodynamic configuration was compared and analyzed, found the perfect configuration and got the prototype of mav. abstracted the model about the deformation of aerodynamic configuration on base of the method of vortex lattice, developed the program for researching the performance of the deformation of aerodynamic configuration

    本文針對mav的具體特點，抽象出mav的氣動工程計算數學模型，建立起氣動工程估算環境，對各種氣動布局進行了氣動特性比較分析與綜合，尋求出理想的mav氣動布局方案並提出mav原型機，抽象出基於渦格法的氣動外形形變的數學模型，建立起氣動外形形變性能研究環境，探討新型的飛行控制方法和氣動力控制策略，在得出氣動外形形變模型的初始方案后，對其進行進一步的優化，最後得出理想的氣動外形形變執行機構組合陣列。
  13. The machine id used to press the album, and it has two cyclinders, air - opreation. the design is moresuitable to completely absorb the water inside of the album, the album will keep smooth and steady

    烘乾壓力機是壓制相冊的專業設備. .機器在結構設計上更加合理，採用的是雙層溫控系統，利用空氣動力學原理想相冊內部的水分抽出.縮短了壓制相冊時間，更重要的是保證了相冊的長期不變形
  14. The structure recognization of web table can be processed by two phases. first we need to filter out those non - genuine tables which is uesd not for relational information display but for creating any type of multiple - column layout to facilitate easy viewing. according to lots of observations to tables in web pages, the features are identified which best capture the characteristics of the genuine table compared to a non - genuine one, and then get the heuristic rules. based on these rules, algorithms are designed and implemented to evaluate the performance, as measured by ie evaluation metrics - recall, precision and f - measure. the result show that the performance of our algorithms is not less effectively than others

    首先從紛繁復雜的web頁面中濾去那些用於控制頁面結構而不是表達有效數據信息的「假表格」 。本文通過大量的觀察，提取出識別真假表格的特徵信息，形成啟發式規則;在此基礎上設計並實現一系列演算法;最後通過傳統的信息抽取指標? ?召回率、準確率和f指數來衡量識別結果。實驗顯示，本文的演算法有較強的表格識別能力。
分享友人
分享到 Line

分享到臉書