拆線狀態 的英文怎麼說

中文拼音 [chàixiànzhuàngtài]
拆線狀態 英文
cleared state
  • 拆 : 拆動詞[方言] （排泄大小便） excrete
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 狀 : Ⅰ名詞1 （形狀） form; shape 2 （情況） state; condition; situation; circumstances 3 （陳述事件或...
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 拆線 : 1 [醫學] take out stitches; take out [remove] the suture2 （將電話線路斷開） clearing拆線寄存器 d...
  • 狀態 : status; state; condition; state of affairs: （病的）危險狀態 critical condition; 戰爭狀態 state o...
  1. Now when all this was finished, all israel that were present went out to the cities of judah, and brake the images in pieces, and cut down the groves, and threw down the high places and the altars out of all judah and benjamin, in ephraim also and manasseh, until they had utterly destroyed them all

    狀態離線31 : 1這事既都完畢，在那裡的以色列眾人就到猶大的城邑，打碎柱像，砍斷木偶，又在猶大，便雅憫，以法蓮，瑪拿西遍地將邱壇和祭壇拆毀凈盡。
  2. Stem drive ? two - piece allows for replacement of yoke bushing inline, removal of handwheel without affecting position of valves ( closed or opened )

    閥桿驅動-兩件式，可在線更換軛架襯套，不需要影響閥門開關位置（關閉或開啟）狀態下拆卸手輪。
  3. The primary conclusions are drawn in this paper on these points : ( 1 ) after the blasting data of delayed time and height are gained based on the theory of gradually disintegration, the elements need to kill are executed similar with destroying the part of the building. then the pre - condition cg solver is pitched on to execute the nonlinear analysis

    本文的主要成果如下： （ 1 ）根據逐段解體法爆破拆除設計的原理，計算秒延差時間和爆破高度，在已劃分網格的有限元模型中殺死擬爆除的部分單元，使整體結構處于失穩狀態下，然後利用前置條件共軛梯度法求解器對結構進行材料和幾何非線性求解。
  4. The influence caused by geometric nonlinear behaviors should be considered in forward analysis and backward analysis during construction processes. only the reasonable finished bridge state should be got by approach iteratively of forward analysis and backward analysis, the non - circled problems of the results between forward analysis and backward analysis will reach to the minimum degree

    2 ）施工階段的正裝和倒拆分析中考慮斜拉橋的幾何非線性因素影響，而且必須經過正裝與倒拆的反復迭代才能得到理想的成橋狀態，才能將正裝倒拆計算中結構的不閉合問題減小到最低限度。
  5. After modulating these two finished bridge state, another new backward analysis and forward analysis are carriedon again and again. the target configuration of girder attains to the designed configuration at last

    調整成橋狀態的索力，反復進行倒拆、正裝計算，使得成橋後主梁線形達到設計線形。
分享友人
分享到 Line

分享到臉書