拉伸強度試驗 的英文怎麼說

中文拼音 [lāshēnqiángdùshìyàn]
拉伸強度試驗 英文
tensile strength test
  • 拉 : 拉構詞成分。
  • 伸 : Ⅰ動詞（展開） stretch; extend Ⅱ名詞（姓氏） a surname
  • 強 : 強形容詞（強硬不屈;固執） stubborn; unyielding
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. Test method for metallic fibered concrete - measuring the flexural tensile stength limit of proportionality, residual ; german version en 14651 : 2005

    金屬纖維混凝土試驗方法.彎曲拉伸強度的測量
  2. Uv & heat * * 80 % tensile strength retention after 350 hours stabilised weatherometer exposure, masterbatch in both tapes and coating

    紫外線和熱穩定性在老化試驗機中試驗350小時后保留80 %的拉伸強度
  3. Adhesives for load - bearing timber structures - test methods - determination of the effect of acid damage to wood fibres by temperature and humidity cycling on the transverse tensile strength

    承重木結構用膠粘劑.試驗方法.通過溫度和濕度循環試驗測定木纖維酸性腐蝕對橫向拉伸強度的影響
  4. When fillings is other materials ( unprocessed montmorillonite, powder coal ash, co - composite of powder coal ash and organo - montmorillonite, co - composite ofcarbonizing calcium and organo - montmorillonite ) in the binder and content of organo - montmorillonite in the binder is five percent decided by tensile - shear experiment, tensile - shear strength of binder is up to tiptop ; at the same time, this paper carries out abrasion experiment, and, by comparison, concludes abrasion property of coating is optimum when content of organo - montmorillonite in the binder coating is five percent, and observes abrasion sample under set

    當膠粘劑中填料為其它物質（未處理蒙脫土、粉煤灰、粉煤灰和有機化蒙脫土共復合、碳化鈣和有機化蒙脫土共復合）時，通過拉伸剪切試驗確定膠粘劑中有機化蒙脫土含量為5時，膠粘劑的拉伸剪切強度最高；同時進行了沖蝕磨損試驗，通過比較得出，當膠粘劑塗層中有機化蒙脫土含量達到5時，塗層的耐沖蝕磨損性能最佳，並對沖蝕磨損試樣在掃描電子顯微鏡（ set ）上進行觀察。
  5. Standard test method for flatwise tensile strength of sandwich constructions

    夾層結構平直拉伸強度的標準試驗方法
  6. Test method for interlaminar tensile strength of glass fiber reinforced plastic laminates

    玻璃纖維增強塑料層合板層間拉伸強度試驗方法
  7. Advanced technical ceramics. ceramic composites. methods of test for reinforcements. determination of distribution of tensile strength and tensile strain to failure of filaments within a multifilament tow at ambient temperature

    高技術陶瓷.陶瓷成分.增強的試驗方法.環境溫度下多纖維牽引內纖維斷裂拉伸強度和拉伸應變分配的測定
  8. Advanced technical ceramics - ceramic composites - methods of test for reinforcements - determination of distribution of tensile strength and of tensile strain to failure of filaments within a multifilament tow at ambient temperature

    高級工業陶瓷.陶瓷復合材料.增強纖維的試驗方法.室溫下復絲束中長絲斷開時的拉伸強度和拉伸應變分佈的測定
  9. Advanced technical ceramics - ceramic composites - methods of test for reinforcements - part 5 : determination of distribution of tensile strength and of tensile strain to failure of filaments within a multifilament tow at ambient temperature

    先進工藝陶瓷.陶瓷復合材料.增強纖維的試驗方法.第5部分:周圍溫度下復絲束中長絲拉伸強度的分佈和斷裂拉伸應變的測定
  10. V - btlts - tensile strength and elongation test method

    帶拉伸強度和伸長率試驗方法
  11. Test method for tensile strength of preimpregnated roving

    預浸紗帶拉伸強度試驗方法
  12. Wood wool slabs. measurement of transverse tensile strength

    木絲板.橫向拉伸強度試驗
  13. Testing methods for tensile strength of adhesive bonds

    粘合劑粘合點抗拉伸強度的試驗方法
  14. Used for bursting test of some fabrics for which tensile strength test is not suitable

    用於做拉伸強度對某種織物不太適宜、可用脹破強度試驗來代替的織物。
  15. Method of test for tensile strength of rock

    巖石拉伸強度試驗方法
  16. Test methods for aircraft wheel friction materials - part 9 : test method for tensile strength

    航空機輪摩擦材料試驗方法第9部分:拉伸強度試驗方法
  17. Tensile strength tests of natural fibres

    天然纖維的抗拉強伸強度試驗
  18. Adhesives for load - bearing timber structures - test methods - part 3 : determination of the effect of acid damage to wood fibres by temperature and humidity cycling on the transverse tensile strength

    承重木結構用粘合劑.試驗方法.第3部分:通過溫度和濕度循環試驗測定木纖維酸性腐蝕對橫向拉伸強度的影響
  19. Simultaneity, various single fiber strength tests ( sft ) and the single fiber fragmentation techniques were discussed, and the influence of fiber surface treatment on the single fiber strength and the interface load - transfer were discussed in detail. the two parameters weibull statistic theory was used to evaluate the scattering of the tensile strength test results of three types of single fibers with different surface treatments. the following conclusions can be drawn based on the analysis of the results

    同時，文中詳細討論了單纖維強度測試實驗（ sft ）和單纖維復合材料斷裂實驗（ sfc ） ，重點討論了纖維表面處理對單纖維拉伸強度和界面載荷傳遞能力的影響；採用兩參數weibull統計理論對經過三種不同表面處理的單纖維拉伸強度的測試結果的分散性進行了評價，獲得了理想的實驗結果；分析實驗結果可得到如下結論， sft實驗與sfc實驗獲得的界面剪切強度吻合良好；經過表面處理的玻璃纖維的界面粘結情況較未經處理的玻璃纖維好；經過表面處理的玻璃纖維的界面粘結強度和單纖維拉伸強度均高於未經表面處理的玻璃纖維。
  20. Rock - determination of the tensile strength - indirect method - brazil test

    巖石.拉伸強度的測定.間接法. brazil試驗
分享友人
分享到 Line

分享到臉書