拉伸應力 的英文怎麼說
中文拼音 [lāshēnyīnglì]
拉伸應力
英文
drawing stress-
Method of tensile stress relaxation test for metallic materials
金屬材料拉伸應力張馳試驗方法Tensile stress concentrations and strengths for notched unidirectional laminates
割口單向疊層板的拉伸應力集中與強度Tensile stress relaxation
拉伸應力弛豫Maximum tensile stress
最大拉伸應力Standard practice for preparation and use of direct tension stress - corrosion test specimens
直接拉伸應力腐蝕試樣的制備和使用Metallic materials - tensile stress relaxation testing - procedure for testing machines
金屬材料.拉伸應力鬆弛試驗.試驗機規程Axial tensile stress
軸向拉伸應力Rubber, vulcanized or thermoplastic - determination of tensile stress - strain properties
硫化橡膠或熱塑性橡膠拉伸應力應變性能的測定Metallic materials - tensile stress relaxation testing - part 1 : procedure for testing machines
金屬材料.拉伸應力鬆弛試驗.第1部分:試驗機用程序Energetic materials for defense - physical - chemical analysis and properties - tensile stress relaxation
軍用高能材料.物理-化學分析及特性.拉伸應力鬆弛Metallic materials - tensile stress relaxation testing - part 1 : procedure for testing machines ; german version en 10319 - 1 : 2003
金屬材料.拉伸應力鬆弛試驗.第1部分:試驗機規程The response of mmcs has a turning point, associated with the initiation of interfacial debonding, which is decided by the interfacial strength. unlike the two predecessors, the evolving complaint interface ( eci ) model allows unloading of interfacial stresses
在常響應界面情況下，復合材料橫向拉伸應力?應變曲線存在明顯的轉折點，對應于界面分離的始發點，轉折點的位置取決于界面粘結強度。Tensile strength corresponds to the maximum tensile stress that may be sustained by a specimen
抗拉強度是指樣品可能承受的最大拉伸應力。The calculated value of shear force model fit well with the experimental results. it means that compare to the tensile stress during squeeze flow the shear stress can be omitted especially when the molding rat e is low and distortion rate is low
拉伸粘度模型的計算結果與實驗結果吻合得相當好表明：在合模速率不大或變形率不是很大的情形下，擠壓流動過程中剪切力相對于拉伸應力可以忽略。During stage i, the macro - stiffness of mmcs is reducing because of interfacial debonding
當存在漸進適應界面時，復合材料橫向拉伸應力?應變曲線存在三個階段。Under the tensile stress, the fracture mode of za27 alloyed with si or mn is a mix type fracture - the plastic fracture and the brittle fracture are coexistence. cracks are mainly stemmed from brittle phases of si and mn and develop along the grain boundary
適宜的加錳量為0 . 4 - 0 . 8 ；在拉伸應力作用下加入si或mn后的za27 ，合金的斷裂均為混合型斷裂，既有塑性斷裂，也有脆性斷裂。If there are high temperature gradient between cool liner and hot liner, compressive plastic strain appear at that transient time, which lead to gas film wall bearing high tensile stress at high temperature. high tensile stress is one of main reasons which destroy combustor
分析表明，起動過程中由於熱傳導滯后引發的溫度梯度可以導致火焰筒氣膜唇邊在起動瞬間發生較大的壓縮塑性應變，進而使得該區域在工作時承受較高水平的拉伸應力，高的拉應力會導致火焰筒萌生裂紋。Wood. tensile parallel to grain. determination of ultimate tensile stress parallel to grain using small clear specimens
木材.平行於木紋的拉伸.用無瑕疵小試樣做平行於木紋的極限拉伸應力的測定Standard test method for determining age at cracking and induced tensile stress characteristics of mortar and concrete under restrained shrinkage
測定限制收縮下的灰漿和混凝土斷裂老化和誘導拉伸應力特性的標準試驗方法Testing methods for tensile stress - strain behavior of continuous fiber reinforced ceramic matrix composites at room temperature
室溫下連續纖維增強陶瓷基質復合材料的拉伸應力應變性能的測試方法分享友人