拉伸法 的英文怎麼說

中文拼音 [shēn]
拉伸法 英文
rubber vulcanized - determination of adhesion to metal - tension method
  • : 拉構詞成分。
  • : Ⅰ動詞(展開) stretch; extend Ⅱ名詞(姓氏) a surname
  • : Ⅰ名詞1 (由國家制定或認可的行為規則的總稱) law 2 (方法; 方式) way; method; mode; means 3 (標...
  1. Methods of tensile test for butt welded joints

    對焊焊縫抗試驗方
  2. Conveyor belts of textile carcase - test method for tensile strength and elongation

    織物芯輸送帶強度和長率測定方
  3. Methods. apparent glucose diffusivity measurements were performed on 10 axial and 10 radial af specimens from bovine coccygeal discs. the dependence of diffusivity on compression was determined using 3 levels of strain ( 0 %, 10 %, and 20 % )

    :測量來自牛尾骨椎間盤纖維環10個軸的和10個輻射的樣品來獲得葡萄糖近似擴散系數。壓縮狀態下的擴散系數決定於3個等級的( 0 % , 10 % ,和20 % ) 。
  4. First the sketch / datum plane is fitted by least - square distance, then the extruded direction or axis with the flank points of the cloud is extracted in quadratic paogramming arithmetic, and certain points projected to gain 2d sketched datas. feature points are defined to segment the sketch datas, and the sketch profile is generated by fitting separately the line and circle segment

    使用最小二乘方擬合草圖基準平面,採用二次規劃方提取方向和旋轉軸線,然後將數據點投影以獲取草圖數據,通過柵格劃分提取草圖邊界輪廓數據,再對這些邊界數據進行基於特徵點的分割,以直線和圓弧段擬合出草圖輪廓。
  5. Helical compression and extension springs - requirements for design, performance test method

    螺旋壓縮與彈簧.設計要求和性能試驗方
  6. 1 helical compression and extension springs - requirements for design, performance test method erratum 1

    螺旋壓縮與彈簧.設計要求和性能試驗方
  7. Standard test method for relative extensional viscosity of agricultural spray tank mixes

    農用噴霧箱混合料的相對粘度的標準試驗方
  8. Test method for metallic fibered concrete - measuring the flexural tensile stength limit of proportionality, residual ; german version en 14651 : 2005

    金屬纖維混凝土試驗方.彎曲強度的測量
  9. Method of repeated tension fatigue testing for fusion welded joints

    熔焊接頭重復疲勞試驗方
  10. Testing sprayed concrete - bond strength of cores by direct tension

    噴射混凝土試驗.用直接拉伸法測定泥芯的粘結強度
  11. Rubber vulcanized - determination of adhesion to metal - tension method

    硫化橡膠與金屬粘合強度測定方拉伸法
  12. Baumgarte ray - stretching method

    鮑姆加特射線拉伸法
  13. Cai software development on measuring young ' s modulus of tinsel by pulling and stretching method

    拉伸法測金屬楊氏模量實驗的改進
  14. Testing sprayed concrete - part 4 : bond strength of cores by direct tension

    噴射混凝土試驗.第4部分:用直接拉伸法測定芯的粘結強度
  15. Test method for determining performance strength of geomembranes by the wide strip tensile method

    用寬帶拉伸法測定土工薄膜性能強度的試驗方
  16. 100 mm min paper and board - determination of tensile properties - constant rate of elongation method 100 mm min

    紙和紙板.抗張性能的測定.恆速拉伸法
  17. Standard test method for determining tensile properties of geogrids by the single or multi - rib tensile method

    單邊或多邊拉伸法測定土工格柵特性的標準試驗方
  18. Testing methods for in - plane shear properties of carbon fiber reinforced plastics by plus and minus 45 degrees tension method and two pairs of rails method

    用加減45度拉伸法和兩對軌測定碳纖維增強塑料的平面剪切性能的試驗方
  19. More, residual stresses of the plate relieved by stretching distortion are simulated. otherwise it is compared between the simulating results and the experimental results of the literatures, they are good agreed

    對機械拉伸法消除鋁合金板材殘余應力進行了模擬研究,將研究結果與相關文獻實驗結果作了比較驗證,取得了較好的一致性。
  20. In this article, the author introduces the method and procedure of the cai software development on measuring young ' s modulus of tinsel by pulling and stretching method, which will improve the teaching level of physics experiments

    摘要該文通過具體實例,介紹了開發拉伸法測金屬絲的楊氏模量cai課件的方和步驟,這將有利於提高大學物理實驗的教學水平。
分享友人