拉伸纖維 的英文怎麼說

中文拼音 [lāshēnxiānwéi]
拉伸纖維 英文
drawing of fiber
  • 拉 : 拉構詞成分。
  • 伸 : Ⅰ動詞（展開） stretch; extend Ⅱ名詞（姓氏） a surname
  • 纖 : 纖形容詞（細小） fine; minute
  • 維 : Ⅰ動詞1 （連接） tie up; hold together; link 2 （保持; 保全） maintain; safeguard; preserve; keep ...
  • 纖維 : fibre; staple; filamentary
  1. Tensile tests of carbon filament yarn shows at high strain rate that the mechanical behavior of carbon fiber bundles are insensitive to strain rate, i. e., the failure stress strain and elastic modulus are not increased with the rising of strain - rate. however, the fractograph of carbon fiber is rate - dependent. the fractograph of carbon will become smooth from coarse as the strain rate increases

    通過對碳纖維束的沖擊拉伸試驗表明，雖然碳纖維束的力學性能與應變率基本上是不相關的，即隨著應變率的增大，碳纖維束的初始模量、破壞應力及其失效應變都變化不大，但碳纖維束的破壞斷口與沖擊拉伸實驗的應變率密切相關。
  2. Methods. apparent glucose diffusivity measurements were performed on 10 axial and 10 radial af specimens from bovine coccygeal discs. the dependence of diffusivity on compression was determined using 3 levels of strain ( 0 %, 10 %, and 20 % )

    方法：測量來自牛尾骨椎間盤纖維環10個軸的和10個輻射的樣品來獲得葡萄糖近似擴散系數。壓縮狀態下的擴散系數決定於3個等級的拉伸（ 0 % ， 10 % ，和20 % ） 。
  3. With the filling of diabase, the mechanical properties of the composite increased first and then decreased with a top tensile strength of 56. 5mpa and a top impact strength of 70. 1mpa. these illuminated that the diabase fiber reinforced pvc composites could be used as structure materials

    復合材料的力學性能隨著輝綠巖的增加先升后降，復合材料拉伸強度最高可達56 . 5mpa ，復合材料沖擊強度最高可達70 . 1mpa ，說明輝綠巖纖維增強pvc復合材料作結構材料使用。
  4. Test method for metallic fibered concrete - measuring the flexural tensile stength limit of proportionality, residual ; german version en 14651 : 2005

    金屬纖維混凝土試驗方法.彎曲拉伸強度的測量
  5. Sem images indicated that the membranes consisted of micro - fibrils domains hightly oriented in the direction of the stretching and fibril - connected island - like node domains

    Sem分析表明，膜具有小島狀結點和與拉伸方向平行的微細纖維組成的結構。
  6. Glass fibre reinforced plastics - tensile test

    玻璃纖維增強塑料.拉伸試驗
  7. Test methods for tensile properties of carbon fiber multifilament

    碳纖維復絲拉伸性能試驗方法
  8. Ships and marine technology - polypropylene fibre ropes, made of high - tensile multifilament

    船舶和海上技術.高拉伸強度多絲制聚丙烯纖維繩索
  9. Investigation on the high strain rate properties of pva fiber bundles

    纖維束沖擊拉伸性能的實驗研究
  10. The process of drawing can import many useful properties to a synthetic fiber.

    拉伸處理能給合成纖維增添許多有用的性能。
  11. Adhesives for load - bearing timber structures - test methods - determination of the effect of acid damage to wood fibres by temperature and humidity cycling on the transverse tensile strength

    承重木結構用膠粘劑.試驗方法.通過溫度和濕度循環試驗測定木纖維酸性腐蝕對橫向拉伸強度的影響
  12. The dynamic characteristics and fatigue property of polyester fiber modified asphalt concrete are investigated in this paper, and the effects of polyester fiber on the viscoelastic characteristic and fatigue performance arc analyzed

    摘要採用動態模量試驗和間接拉伸疲勞試驗研究了聚酯纖維瀝青混凝土（纖維摻量為0 . 25 % ）的動態模量特性和疲勞性能，分析了聚酯纖維對瀝青混凝土粘彈特性和疲勞性能的影響。
  13. On the other hand, the collection on a rotating cylinder is helpful to the process of electrospinning, and it is furthersome to get the ordered mats, otherwise, because the velocity of cylinder rotating is far less than that of nanofiber depositing, the rotation of cylinder has not the function of drawing

    另外，採用輥筒收集有利於紡絲工藝的順利進行，而且輥筒收集能使纖維氈中的纖維較整齊排列，但輥筒的卷繞速度遠遠小於電紡絲速度，輥筒的旋轉不能起到拉伸的作用。
  14. Test method for tensile properties of glass fiber - reinforced plastics

    玻璃纖維增強塑料拉伸性能試驗方法
  15. Atr analysis of wool and human hair fiber after stretching treatment

    拉伸改性處理毛發纖維的紅外光譜研究
  16. Amino - acid analysis of wool and human hair fiber after stretching treatment

    拉伸改性處理毛發纖維的氨基酸含量分析
  17. In this investigation carbon black - filled electrical conductive composites of poly ( ethylene terephthalate ) / polyethylene were first prepared through the single - screw melt - blended extrusion, then drawing, followed by the quenching and subsequent press molding. the relationships among the influencing factors including composition, hot stretching ratio and compatibilizer, morphology and properties of composites were systematically investigated. positive temperature coefficients effect and crystallization behaviors of composites were preliminarily analyzed

    本文擬採用單螺桿熔融共混擠出?熱拉伸?淬冷的新的成型方法制備炭黑填充的pet pe復合導電材料，熱拉伸的目的是使材料的分散相（ pet相）在加工過程中原位形成纖維，而炭黑基本分散在纖維中或纖維的表面上，使炭黑粒子間間距減小，形成更多的導電通路，從而提高材料的導電性能，同時保持或提高材料的力學性能。
  18. The fracture surface of the wires studied by scanning electron microscopy ( sem ) shows a suitable interfacial bonding between the fiber and aluminum

    復合絲拉伸斷口的掃描電鏡（ sem ）觀察可見斷面有一定起伏，部分纖維拔出但長度較短，表明纖維與基體具有適當的界面結合。
  19. Aerospace ; testing of fibre - reinforced plastics ; determination of interlaminar shear strength by tenside test

    航空航天.纖維增強塑料的試驗.用拉伸試驗測定中層間
  20. Aircraft industry. synthetic cloths for the fabric of airplane structures. determination of shear sstrength by stretching cloths, in the delivery condition, stuck then protected before and after aging

    航空工業.飛機結構用合成纖維布.發貨時測定老化前後粘著保護的拉伸纖維的抗剪切強度
分享友人
分享到 Line

分享到臉書