拉平計算器 的英文怎麼說

中文拼音 [lāpíngjìsuànqì]
拉平計算器 英文
flare computer
  • 拉 : 拉構詞成分。
  • 平 : Ⅰ形容詞1 （沒有高低凹凸 不頃斜） flat; level; even; smooth 2 （高度相同; 不相上下） on the same l...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 算 : Ⅰ動詞1 （計算數目） calculate; reckon; compute; figure 2 （計算進去） include; count 3 （謀劃;計...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 拉平 : 1 （使有高有低的變成相等） flareout; bring to the same level; even up2 （指飛行時平穩降落的操作）...
  • 計算 : 1 （求得未知數） count; compute; calculate; reckon; enumerate 2 （考慮; 籌劃） consideration; pla...
  1. The azeotropic distillation of the system acetic acid - water - azeotropic agent ( isopropyl acetate and butyl acetate ) is simulated. due to the non - ideal behavior, nrtl - hoc and uniquac - hoc model is used to depict vapor - liquid phase equilibrium behavior of this system. concerning the liquid in the decanter, the stability is checked by tangent plane stability analysis, and the initialization of phase splitting calculation is produced. a good estimate of the phase fration is gotten by successive substitution with newton ' s method, and every component of two phase is gotten by mass equilibrium equation. finally, the solution of this equation is produced with successive substitution calcultion. the naphtali - sandholm method is used to simulation of azeotropic distillation. by virtue of this combined calculation method, the simulation is begun with operational data as basical data. the results of simulation accord with the operating data, which proved that the combined calculation method is credible

    該體系具有高度非理想性，氣液相平衡模型採用nrtl - hoc和uniquac - hoc模型，採用切平面判據法對進入分層器中的液相進行液相穩定性測試，提供液液相分離計算的初值，再結合牛頓拉夫森迭代法運算求得相分割系數，根據物料衡算求出各相組成，循環迭代可求得分層各組分數據，共沸精餾模擬計算採用那夫塔列-山德荷姆全變量迭代演算法。
  2. In this application, the lorentz force generated by the interaction between the current in the wire and the geomagnetic field produces an electro - dynamic drag leading to a fast orbital decay. in this paper, we make an intensive study of the process of de - orbiting using electro - dynamic tether system. the concrete work includes : firstly, i have studied the basic principle of how to generate the electro - dynamic drag, modeled via accuracy geomagnetism, made a concrete analysis of the de - orbiting duration, the magnitude and direction of electro - dynamic drag under the action of the dipole and accurate geomagnetic models, set up a counterbalance between electro - dynamic torque and gravity gradient torque, emulate the de - orbiting process of spacecraft, and compared the change of six orbital factors and the de - orbiting duration under the action of the dipole and accurate geomagnetic models

    本文對基於電動力纜繩的航天器離軌過程進行了深入研究，具體工作如下:首先，本文研究了電動力纜繩產生電動力拉力的基本原理，建立了精確地磁場模型;分別在偶極子模型和精確地磁場模型作用下，對電動力拉力的大小、方向、離軌時間及電動力纜繩傾角的大小進行了計算分析;建立了電動力力矩與纜繩系統重力梯度力矩的平衡關系;分析了電動力力矩為系統提供能量的原理;最後分別在偶極子地磁場模型和精確地磁場模型作用下，對受電動力纜繩作用的航天器的離軌過程進行模擬，分析了在不同精度地磁場模型下，航天器離軌過程中各軌道參數的變化情況，並比較了不同模型對離軌時間的影響。
  3. Motorola computer group introduces first processor pmc for the intel ixc1100 control plane processor

    摩托羅拉計算機部推出首款採用intel ixc1100控制平面處理器的pmc處理器模塊
  4. Secondly, basing on the theory of on - off gain of small signal, the raman gain coefficient for frequency shift between 0. 5 and 20 thz of standard sigle mode optical fiber is measured by pump - probe method through a super luminescent diode ( sld ) as a broadband small signal probe source. thirdly, numerical simulation analysis of gain characteristic of raman fiber amplifier for c band wdm signal light is made according to the raman gain coefficient of the fiber measured before through target and four rank runge - kutta method. at the invariability of wavelength and maximum power of each of two pumps, schematic of powers of two pumps for best flatness on c band wdm optical gain was found out, at the same time, the factors of resulting in gain saturation is analyzed, too

    本文首先應用經典的電磁理論對拉曼光纖放大器的工作機制進行了分析，然後，根據小信號理論推導出的開關增益求出了光纖拉曼增益系數的表達式，採用泵浦-探測波的方法，利用超輻射激光二極體（ superluminescentdiode簡稱sld ）作為探測光源，測量了所用標準單模光纖頻移為0 . 5 - 20thz的拉曼增益系數，之後根據所測得的光纖的拉曼增益系數譜對應用該類光纖構成的放大c波段wdm光信號的拉曼光纖放大器的增益特性採用打靶法和四階龍格- - -庫塔進行了數值計算，在給定了兩個泵浦光源的波長和最大功率后，找出了反向泵浦情況下使c波段wdm光源增益最平坦的兩個泵浦的各自最佳功率，同時也分析了導致信號光飽和的原因。
  5. Both of the numeric simulations and the experimentations indicate that the c band raman fiber amplifier can be satisfied with some gain flatness when numbers and wavelengths of pump are installed while powers of pump are arranged properly. the method of measuring fiber raman gain coefficient is adopted to other type

    數值計算和試驗上都證明了在合理地選取泵浦源的個數和波長的情況下，通過對各個泵浦功率配置的調整， c波段的拉曼光纖放大器可以滿足一定的增益平坦度。
  6. It begins form the discussion the knowledge of the gaussian filter and the laplacian operator, which are the base of the marr method. and it is followed by the detail discussion of such as : the 2g （ laplacian of gaussian ) filter, the template log ( laplacian of gaussian ), the meaning of laplacian of gaussian in human vision, edge detection and neurophysiology. with different template to different size of target, the small target can be separated from the background by this small infrared target detection method

    從marr演算法的理論基礎? ?高斯平滑濾波器與拉普拉斯運算元的相關知識以及Ｍ ａ ｒ ｒ的計算視覺理論基礎開始，進行了2g （ laplacianofgaussian ，高斯?拉普拉斯）濾波器、 log （ laplacianofgaussian ，高斯?拉普拉斯）模板以及2g濾波器在人類視覺、邊緣檢測、邊緣處理的物理意義以及神經生理學意義方面的分析討論，提出了易於fpga （ fieldprogrammablegatearray ，現場可編程門陣列）實現的基於marr計算視覺的紅外圖像小目標檢測方法。
  7. This system captures the rack position signal and rotate speed signal of the fuel injection pump, and calculates the circulating fuel injection quantity by programming the computer. then the computer is programmed to control the daq board to generate a certain width pulse. finally, controlled by the pulse, the alcohol injection system injects a certain quantity alcohol into inlet manifold according to a setting diesel / alcohol proportion

    該系統採用了在labview平臺上開發的pc總線?插卡式虛擬儀器系統，系統通過採集噴油泵的供油拉桿位置信號和轉速信號，利用計算機計算得出柴油的循環噴油量，再根據程序設定的柴油/酒精比例控制數據採集卡發出一定寬度的脈沖，控制低壓酒精噴射系統按比例將酒精噴入進氣歧管。
  8. This paper has studied and set up a supervision and control system based on the backing item of jinzhou yangtze river bridge with main span of 500m, by analyzing the development of construction control of cable - stayed bridges in china and abroad, foreword calculation of 250 work cases of plane bar fem, adoption of advanced equipment and devices, quick analysis of gathered data research of karemen filtering method, least square and gray model gm ( 1, 1 ) into the identification of the real state and precuts and effective manage mechanism

    本文以荊州長江公路大橋主跨500米的混凝土斜拉橋施工為應用背景，通過分析目前國內外大跨度混凝土斜拉橋施工控制現狀，結合該橋施工實踐，運用平面桿系有限元計算理論對大橋250個工藝進行正裝計算，採用先進測試設備和儀器，利用計算機快速分析處理技術對現場監測系統收集的數據進行誤差分析，系用卡爾曼濾波法、最小二乘法和灰色理論gm （ 1 ， 1 ）進行結構真實狀態的識別和後期預測，通過科學高效的監控管理機制的運行和監控實踐，探索並建立了一套適合於大跨度混凝土斜拉橋的施工監測監控體系。
分享友人
分享到 Line

分享到臉書